Lidia Morawska

Bio: Lidia Morawska is an academic researcher from Queensland University of Technology. The author has contributed to research in topics: Particle number & Ultrafine particle. The author has an hindex of 100, co-authored 746 publications receiving 95412 citations. Previous affiliations of Lidia Morawska include University of Surrey & Jinan University.

Modelling of Particle Emissions from Motor Vehicles in Urban Environments

Abstract: Air quality impacts of urban transportation policies and strategies are often assessed using modelling techniques based on traffic flow simulation and travel demand analysis tools. Such analytical methods have traditionally been aimed at estimating the overall mass of individual pollutants with an emphasis on gaseous emissions. Significantly less attention is usually given to the quantification of particle emissions. Extensive data relating to fine and ultra-fine airborne particle concentration levels and the corresponding contributing vehicles have been collected at two significantly different Brisbane sites. Analysis of the relationships between the data so far point to a strong correlation between traffic flow and meteorological variables and particle concentrations.

Insights into the growth of newly formed particles in a subtropical urban environment

Abstract: The role of different chemical compounds, particularly organics, involved in the new particle formation (NPF) and its consequent growth are not fully understood. Therefore, this study was conducted to investigate the chemical composition of aerosol particles during NPF events in an urban subtropical environment. Aerosol chemical composition was measured along with particle number size distribution (PNSD) and several other air quality parameters at five sites across an urban subtropical environment. An Aerodyne compact Time-of-Flight Aerosol Mass Spectrometer (c-ToF-AMS) and a TSI Scanning Mobility Particle Sizer (SMPS) measured aerosol chemical composition (particles above 50 nm in vacuum aerodynamic diameter) and PNSD (particles within 9–414 nm in mobility diameter), respectively. Five NPF events, with growth rates in the range 3.3– 4.6 nm, were detected at two of the sites. The NPF events happened on relatively warmer days with lower condensation sink (CS). Temporal percent fractions of organics increased after the particles grew enough to have a signifi- cant contribution to particle volume, while the mass fraction of ammonium and sulfate decreased. This uncovered the important role of organics in the growth of newly formed particles. Three organic markers, factors f43, f44 and f57, were calculated and the f44 vs. f43 trends were compared between nucleation and non-nucleation days. K-means cluster analysis was performed on f44 vs. f43 data and it was found that they follow different patterns on nucleation days compared to non-nucleation days, whereby f43 decreased for vehicle-emission-generated particles, while both f44 and f43 decreased for NPF-generated particles. It was found for the first time that vehicle-generated and newly formed particles cluster in different locations on f44 vs. f43 plot, and this finding can be potentially used as a tool for source apportionment of measured particles.

Air Quality and Its Impact on Health: Focus on Particulate Matter

Abstract: Inadequate air quality and the inhalation of airborne pollutants pose many risks to human health and wellbeing, and are listed among the top environmental risks worldwide. The importance of outdoor air quality was recognised in the 1950s and indoor air quality emerged as an issue some time later and was soon recognised as having an equal, if not greater importance than outdoor air quality. Identification of ambient air pollution as a health hazard was followed by steps, undertaken by a broad range of national and international professional and government organisations, aimed at reduction or elimination of the hazard. However, the process of achieving better air quality is still in progress. The last 10 years or so have seen an unprecedented increase in the interest in, and attention to, airborne particles, with a special focus on their finer size fractions, including ultrafine (< 0.1 m) and their subset, nano particles (< 0.05 m). This paper discusses the current status of scientific knowledge on the links between air quality and health, with a particular focus on airborne particulate matter, and the directions taken by national and international bodies to improve air quality.

Close contact risk assessment for SARS-CoV-2 infection

Abstract: Although close contact represents an important contagion route, the mechanism of exposure to exhaled droplets remains insufficiently characterized. In this study, an integrated risk assessment is presented for SARS-CoV-2 close contact exposure between a speaking infectious subject and a susceptible subject. It is based on a three-dimensional transient numerical model for the description of exhaled droplet spread once emitted by a speaking person, coupled with a recently proposed SARS-CoV-2 emission approach. Particle image velocimetry measurements were conducted to validate the numerical model. The contribution of large droplets to infection risk is dominant for distances < 0.6 m, whereas for longer distances, the exposure risk depends only on airborne droplets. In particular, for short exposures (10 s) a minimum safety distance of 0.75 m should be maintained to lower the risk below 0.1%; for exposures of 1 and 15 min this distance increases to about 1.0 and 1.5 m, respectively. Based on the interpersonal distances across countries reported as a function of interacting individuals, cultural differences, and environmental and sociopsychological factors, the approach presented here revealed that, in addition to intimate and personal distances, particular attention must be paid to exposures longer than 1 min within social distances (of about 1 m).