Ligong Zhang

Bio: Ligong Zhang is an academic researcher from Chinese Academy of Sciences. The author has contributed to research in topics: Quantum dot & Photoluminescence. The author has an hindex of 17, co-authored 31 publications receiving 1556 citations.

Correction: Corrigendum: The work mechanism and sub-bandgap-voltage electroluminescence in inverted quantum dot light-emitting diodes

Abstract: Through introducing a probe layer of bis(4,6-difluorophenylpyridinato-N,C2)picolinatoiridium (FIrpic) between QD emission layer and 4, 4-N, N- dicarbazole-biphenyl (CBP) hole transport layer, we successfully demonstrate that the electroluminescence (EL) mechanism of the inverted quantum dot light-emitting diodes (QD-LEDs) with a ZnO nanoparticle electron injection/transport layer should be direct charge-injection from charge transport layers into the QDs. Further, the EL from QD-LEDs at sub-bandgap drive voltages is achieved, which is in contrast to the general device in which the turn-on voltage is generally equal to or greater than its bandgap voltage (the bandgap energy divided by the electron charge). This sub-bandgap EL is attributed to the Auger-assisted energy up-conversion hole-injection process at the QDs/organic interface. The high energy holes induced by Auger-assisted processes can be injected into the QDs at sub-bandgap applied voltages. These results are of important significance to deeply understand the EL mechanism in QD-LEDs and to further improve device performance.

Amplified Spontaneous Green Emission and Lasing Emission From Carbon Nanoparticles

Abstract: In this work, the optical properties of carbon nanoparticles (CNPs) can be modulated by the dopant-N atom and sp(2) C-contents. CNPs prepared with the low urea mass ratio of 0.2:1 (CNP1) exhibit blue emission (maximum PL quantum yield: 15%). Increasing sp(2) C- and dopant-N atom contents, as determined in CNPs prepared with high urea mass ratio of 2:1 (CNP2), lead to green emission (maximum PL quantum yield up to 36% in ethanol aqueous solution). Amplified spontaneous emission (ASE) can be observed only in CNP2 ethanol aqueous solution. Green lasing emission is achieved from CNP2 ethanol aqueous solution in a linear long Fabry-Perot cavity, indicating the potential of CNP2 as a gain medium for lasing. CNP2 shows superior photostability compared with C545T dye. The green emission from CNP2 is speculated to arise from electron-hole recombination (intrinsic state emission). The high PL quantum yield and small overlap between absorption and emissions of CNP2 ethanol aqueous solution are the key factors in realizing lasing emission.

Towards efficient solid-state photoluminescence based on carbon-nanodots and starch composites

Abstract: A new type of environmentally friendly phosphor based on carbon nanodots (CDs) has been developed through the dispersion of CDs by integrating the CDs with starch particles. The starch particles contain large numbers of hydroxyl groups around the surfaces, which can effectively absorb the CDs, whose surfaces are functionalized by lots of carboxyl and amide groups, through hydrogen bonding. Effective dispersion of CDs on the surfaces of starch particles can suppress the non-radiative decay processes and photoluminescence (PL) quenching induced by aggregation of CDs. The starch matrix neither competes for absorbing excitation light nor absorbs the emissions of CDs, which leads to efficient PL emitting. As a result, the starch/CD phosphors with a quantum yield of ∼50% were obtained. The starch/CD phosphors show great potential in phosphor-based light emitting diodes, temperature sensors, and patterning.

Selectively enhanced red upconversion luminescence and phase/size manipulation via Fe3+ doping in NaYF4:Yb,Er nanocrystals

Abstract: Red upconversion luminescence (UCL) is selectively enhanced by about 7 times via Fe(3+) codoping into a NaYF4:Yb,Er nanocrystalline lattice. The maximum red-to-green ratio (R/G) as well as the overall integrated UCL intensity features at an Fe(3+) content of 20 mol%. The size and phase of nanocrystals are simultaneously manipulated via Fe(3+) doping with various concentrations by a facile hydrothermal method. Contrary to the literature, the pure hexagonal phase appears when Fe(3+) concentrations are from 5 to 20 mol%, meanwhile, the size of NaYF4:Yb,Er nanocrystals reaches its maximum at 10 mol%. The intensified visible UCL especially the dominant red emission is mainly ascribed to the energy transfer (ET) from |(2)F7/2, (4)T1g > (Yb(3+)-Fe(3+) dimer) to (4)F9/2 (Er(3+)) states as well as the distortion of the crystalline field symmetry upon Fe(3+) codoping. Dynamic investigation of (4)S3/2 and (4)F9/2 states under the pulsed laser excitation of 980 nm along with the diffuse reflectance data further supports the proposed mechanism of UC processes. The results show the remarkable promise of Fe(3+)-codoped NaYF4:Yb,Er nanocrystals as upconverting nanoprobes with high sensitivity and penetrability in deeper tissue for multimodal biomedical imaging.

The work mechanism and sub-bandgap-voltage electroluminescence in inverted quantum dot light-emitting diodes

Abstract: Through introducing a probe layer of bis(4,6-difluorophenylpyridinato-N,C2)picolinatoiridium (FIrpic) between QD emission layer and 4, 4-N, N- dicarbazole-biphenyl (CBP) hole transport layer, we successfully demonstrate that the electroluminescence (EL) mechanism of the inverted quantum dot light-emitting diodes (QD-LEDs) with a ZnO nanoparticle electron injection/transport layer should be direct charge-injection from charge transport layers into the QDs. Further, the EL from QD-LEDs at sub-bandgap drive voltages is achieved, which is in contrast to the general device in which the turn-on voltage is generally equal to or greater than its bandgap voltage (the bandgap energy divided by the electron charge). This sub-bandgap EL is attributed to the Auger-assisted energy up-conversion hole-injection process at the QDs/organic interface. The high energy holes induced by Auger-assisted processes can be injected into the QDs at sub-bandgap applied voltages. These results are of important significance to deeply understand the EL mechanism in QD-LEDs and to further improve device performance.

The photoluminescence mechanism in carbon dots (graphene quantum dots, carbon nanodots, and polymer dots): current state and future perspective

Abstract: At present, the actual mechanism of the photoluminescence (PL) of fluorescent carbon dots (CDs) is still an open debate among researchers. Because of the variety of CDs, it is highly important to summarize the PL mechanism for these kinds of carbon materials; doing so can guide the development of effective synthesis routes and novel applications. This review will focus on the PL mechanism of CDs. Three types of fluorescent CDs were involved: graphene quantum dots (GQDs), carbon nanodots (CNDs), and polymer dots (PDs). Four reasonable PL mechanisms have been confirmed: the quantum confinement effect or conjugated π-domains, which are determined by the carbon core; the surface state, which is determined by hybridization of the carbon backbone and the connected chemical groups; the molecule state, which is determined solely by the fluorescent molecules connected on the surface or interior of the CDs; and the crosslink-enhanced emission (CEE) effect. To give a thorough summary, the category and synthesis routes, as well as the chemical/physical properties for the CDs, are briefly introduced in advance.

Carbon and Graphene Quantum Dots for Optoelectronic and Energy Devices: A Review

Abstract: As new members of carbon material family, carbon and graphene quantum dots (CDs, GQDs) have attracted tremendous attentions for their potentials for biological, optoelectronic, and energy related applications. Among these applications, bio-imaging has been intensively studied, but optoelectronic and energy devices are rapidly rising. In this Feature Article, recent exciting progresses on CD- and GQD-based optoelectronic and energy devices, such as light emitting diodes (LEDs), solar cells (SCs), photodetctors (PDs), photocatalysis, batteries, and supercapacitors are highlighted. The recent understanding on their microstructure and optical properties are briefly introduced in the first part. Some important progresses on optoelectronic and energy devices are then addressed as the main part of this Feature Article. Finally, a brief outlook is given, pointing out that CDs and GQDs could play more important roles in communication- and energy-functional devices in the near future.

Hydrogen Bonding in the Electronic Excited State

Abstract: Because of its fundamental importance in many branches of science, hydrogen bonding is a subject of intense contemporary research interest. The physical and chemical properties of hydrogen bonds in the ground state have been widely studied both experimentally and theoretically by chemists, physicists, and biologists. However, hydrogen bonding in the electronic excited state, which plays an important role in many photophysical processes and photochemical reactions, has scarcely been investigated.Upon electronic excitation of hydrogen-bonded systems by light, the hydrogen donor and acceptor molecules must reorganize in the electronic excited state because of the significant charge distribution difference between the different electronic states. The electronic excited-state hydrogen-bonding dynamics, which are predominantly determined by the vibrational motions of the hydrogen donor and acceptor groups, generally occur on ultrafast time scales of hundreds of femtoseconds. As a result, state-of-the-art femtos...

Core–shell nanoparticles: synthesis and applications in catalysis and electrocatalysis

Abstract: Core–shell nanoparticles (CSNs) are a class of nanostructured materials that have recently received increased attention owing to their interesting properties and broad range of applications in catalysis, biology, materials chemistry and sensors. By rationally tuning the cores as well as the shells of such materials, a range of core–shell nanoparticles can be produced with tailorable properties that can play important roles in various catalytic processes and offer sustainable solutions to current energy problems. Various synthetic methods for preparing different classes of CSNs, including the Stober method, solvothermal method, one-pot synthetic method involving surfactants, etc., are briefly mentioned here. The roles of various classes of CSNs are exemplified for both catalytic and electrocatalytic applications, including oxidation, reduction, coupling reactions, etc.

Near-Infrared Photoluminescent Polymer-Carbon Nanodots with Two-Photon Fluorescence

Abstract: Near-infrared-emissive polymer-carbon nanodots (PCNDs) are fabricated by a newly developed facile, high-output strategy. The PCNDs emit at a wavelength of 710 nm with a quantum yield of 26.28%, which is promising for deep biological imaging and luminescent devices. Moreover, the PCNDs possess two-photon fluorescence; in vivo bioimaging and red-light-emitting diodes based on these PCNDs are demonstrated.