Lucia Zuin

Bio: Lucia Zuin is an academic researcher from Canadian Light Source. The author has contributed to research in topics: XANES & Lithium. The author has an hindex of 16, co-authored 59 publications receiving 1769 citations. Previous affiliations of Lucia Zuin include University of Saskatchewan.

The discharge rate capability of rechargeable Li–O2 batteries

Abstract: The O2electrode in Li–O2cells was shown to exhibit gravimetric energy densities (considering the total weight of oxygen electrode in the discharged state) four times that of LiCoO2 with comparable gravimetric power. The discharge rate capability of Au-catalyzed Vulcan carbon and pure Vulcan carbon (VC) as the O2electrode was studied in the range of 100 to 2000 mA gcarbon−1. The discharge voltage and capacity of the Li−O2 cells were shown to decrease with increasing rates. Unlike propylene carbonate based electrolytes, the rate capability of Li−O2 cells tested with 1,2-dimethoxyethane was found not to be limited by oxygen transport in the electrolyte. X-Ray diffraction (XRD) showed lithium peroxide as the discharge product and no evidence of Li2CO3 and LiOH was found. It is hypothesized that higher discharge voltages of cells with Au/C than VC at low rates could have originated from higher oxygen reduction activity of Au/C. At high rates, higher discharge voltages with Au/C than VC could be attributed to faster lithium transport in nonstoichiometric and defective lithium peroxide formed upon discharge, which is supported by XRD and X-ray absorption near edge structure O and Li K edge data.

Chemical and Morphological Changes of Li–O2 Battery Electrodes upon Cycling

Abstract: We report considerable chemical and morphological changes of reaction products in binder-free, vertically aligned carbon nanotube (VACNT) electrodes during Li–O2 battery cycling with a 1,2-dimethoxyethane (DME)-based electrolyte. X-ray absorption near edge structure (XANES) of discharged oxygen electrodes shows direct evidence for the formation of Li2CO3-like species at the interface between VACNTs and Li2O2 but not significantly on the Li2O2 surfaces exposed to the electrolyte. Although Li2O2 and Li2CO3-like species were largely removed upon first charge, the oxidation kinetics became increasingly difficult during Li–O2 cycling, which is accompanied by the accumulation of Li2CO3 in the discharged and charged electrodes as evidenced by selected area electron diffraction (SAED) and transmission electron microscopy (TEM). Together, these results indicate that the irreversibility during Li–O2 cycling in DME can be attributed largely to the growth of Li2CO3-like species associated with the reactivity between ...

Phosphorus L(2,3)-edge XANES: overview of reference compounds.

Abstract: Synchrotron-based X-ray absorption near-edge structure (XANES) spectroscopy is becoming an increasingly used tool for the element speciation in complex samples. For phosphorus (P) almost all XANES measurements have been carried out at the K-edge. The small number of distinctive features at the P K-edge makes in some cases the identification of different P forms difficult or impossible. As indicated by a few previous studies, the P L(2,3)-edge spectra were richer in spectral features than those of the P K-edge. However, experimentally consistent spectra of a wide range of reference compounds have not been published so far. In this study a library of spectral features is presented for a number of mineral P, organic P and P-bearing minerals for fingerprinting identification. Furthermore, the effect of radiation damage is shown for three compounds and measures are proposed to reduce it. The spectra library provided lays a basis for the identification of individual P forms in samples of unknown composition for a variety of scientific areas.

Li-O2 and Li-S batteries with high energy storage.

Abstract: Li-ion batteries have transformed portable electronics and will play a key role in the electrification of transport. However, the highest energy storage possible for Li-ion batteries is insufficient for the long-term needs of society, for example, extended-range electric vehicles. To go beyond the horizon of Li-ion batteries is a formidable challenge; there are few options. Here we consider two: Li-air (O(2)) and Li-S. The energy that can be stored in Li-air (based on aqueous or non-aqueous electrolytes) and Li-S cells is compared with Li-ion; the operation of the cells is discussed, as are the significant hurdles that will have to be overcome if such batteries are to succeed. Fundamental scientific advances in understanding the reactions occurring in the cells as well as new materials are key to overcoming these obstacles. The potential benefits of Li-air and Li-S justify the continued research effort that will be needed.

Challenges Facing Lithium Batteries and Electrical Double‐Layer Capacitors

Abstract: Energy-storage technologies, including electrical double-layer capacitors and rechargeable batteries, have attracted significant attention for applications in portable electronic devices, electric vehicles, bulk electricity storage at power stations, and “load leveling” of renewable sources, such as solar energy and wind power. Transforming lithium batteries and electric double-layer capacitors requires a step change in the science underpinning these devices, including the discovery of new materials, new electrochemistry, and an increased understanding of the processes on which the devices depend. The Review will consider some of the current scientific issues underpinning lithium batteries and electric double-layer capacitors.

Metal-free catalysts for oxygen reduction reaction.

Abstract: Liming Dai,*,†,‡ Yuhua Xue,†,‡ Liangti Qu,* Hyun-Jung Choi, and Jong-Beom Baek* †Center of Advanced Science and Engineering for Carbon (Case4Carbon), Department of Macromolecular Science and Engineering, Case Western Reserve University, 10900 Euclid Avenue, Cleveland, Ohio 44106, United States Key Laboratory of Cluster Science, Ministry of Education of China, Beijing Key Laboratory of Photoelectronic/Electrophotonic Conversion Materials, Department of Chemistry, School of Science, Beijing Institute of Technology, Beijing 100081, People’s Republic of China School of Energy and Chemical Engineering/Center for Dimension-Controllable Covalent Organic Frameworks, Ulsan National Institute of Science and Technology (UNIST), 100 Banyeon, Ulsan, 689-798, South Korea

A reversible and higher-rate Li-O2 battery.

Abstract: The rechargeable nonaqueous lithium-air (Li-O(2)) battery is receiving a great deal of interest because, theoretically, its specific energy far exceeds the best that can be achieved with lithium-ion cells. Operation of the rechargeable Li-O(2) battery depends critically on repeated and highly reversible formation/decomposition of lithium peroxide (Li(2)O(2)) at the cathode upon cycling. Here, we show that this process is possible with the use of a dimethyl sulfoxide electrolyte and a porous gold electrode (95% capacity retention from cycles 1 to 100), whereas previously only partial Li(2)O(2) formation/decomposition and limited cycling could occur. Furthermore, we present data indicating that the kinetics of Li(2)O(2) oxidation on charge is approximately 10 times faster than on carbon electrodes.

Mn3O4-Graphene Hybrid as a High Capacity Anode Material for Lithium Ion Batteries

Abstract: We developed two-step solution-phase reactions to form hybrid materials of Mn3O4 nanoparticles on reduced graphene oxide (RGO) sheets for lithium ion battery applications. Mn3O4 nanoparticles grown selectively on RGO sheets over free particle growth in solution allowed for the electrically insulating Mn3O4 nanoparticles wired up to a current collector through the underlying conducting graphene network. The Mn3O4 nanoparticles formed on RGO show a high specific capacity up to ~900mAh/g near its theoretical capacity with good rate capability and cycling stability, owing to the intimate interactions between the graphene substrates and the Mn3O4 nanoparticles grown atop. The Mn3O4/RGO hybrid could be a promising candidate material for high-capacity, low-cost, and environmentally friendly anode for lithium ion batteries. Our growth-on-graphene approach should offer a new technique for design and synthesis of battery electrodes based on highly insulating materials.