scispace - formally typeset
Search or ask a question
Author

M. I. Yanovskaya

Bio: M. I. Yanovskaya is an academic researcher from Moscow State University. The author has contributed to research in topics: Alkoxide & Barium titanate. The author has an hindex of 9, co-authored 23 publications receiving 267 citations.

Papers
More filters
Journal ArticleDOI
TL;DR: In this article, the properties of molybdenum and tungsten alkoxides of the two series MO(OEt)4 and MO2(OEts)2 (M = Mo, W) have been studied.
Abstract: Hydrolysis of molybdenum and tungsten alkoxides of the two series MO(OEt)4 and MO2(OEt)2 (M = Mo, W) has been studied. Hydrolysis products and the partially hydrolyzed solutions have been characterized by means of X-ray diffraction, IR, electron spectroscopy and small-angle X-ray scattering. Preparation of stable sols is reported and their structures are discussed in terms of a fractal model. While ‘tungsten solutions’ may be described as typical polymeric sols, ‘molybdenum solutions’ should be regarded as particulate sols. The reason for this difference has its origin in the structures of alkoxides and mechanisms of their hydrolysis. Sols were used for the preparation of electrochromic and photochromic films by spin-coating techniques. A coloration mechanism is discussed in terms of the percolation model. Some properties of the composite structures WO3TiO2, n-SiWO3 are also reported.

46 citations

Journal ArticleDOI
TL;DR: In this article, a review of the main events in the development of metal alkoxides in Russian and summarizes the results obtained by the authors has been provided, including the analysis of solubility and vapor pressure in the M(OR)n-ROH (R  Li, Mg, Ca, Sr, Ba, Tl) systems permitted the determination of the composition of the solvates formed and the optimization of the isolation conditions for distinct derivatives.

39 citations

Journal ArticleDOI
TL;DR: In this paper, LiNbO3 was prepared by simultaneous hydrolysis of lithium and niobium alkoxides (in the mole ratio Li : Nb = 1 : 1) followed by heat treatment.
Abstract: Crystalline LiNbO3 was prepared by simultaneous hydrolysis of lithium and niobium alkoxides (in the mole ratio Li : Nb = 1 :1) followed by heat treatment. Crystallization of LiNbO3 occurs in a wide temperature region, 350 to 700° C, directly from an amorphous hydrolysis product containing residual alkoxy and hydroxy groups. Heat treatment at 700° C results in the formation of fully crystalline LiNbO3 powder with completely formed ferroelectric properties. Hydrolysis of metal alkoxide solutions is successfully used to obtain high-quality LiNbO3 crystalline thin films.

38 citations

Journal ArticleDOI
TL;DR: An X-ray structural study of the crystals isolated from the solutions obtained by the reaction of Ba metal with Ti(OPri)4 in isopropyl alcohol has been carried out; the crystals of the compound, which is a precursor for the synthesis of BaTiO3, contain molecules of two different kinds [Ba4Ti4O4(OR)16(ROH)4], where R = Pri as mentioned in this paper.
Abstract: An X-ray structural study of the crystals isolated from the solutions obtained by the reaction of Ba metal with Ti(OPri)4 in isopropyl alcohol has been carried out; the crystals of the compound, which is a precursor for the synthesis of BaTiO3, contain molecules of two different kinds [Ba4Ti4O4(OR)16(ROH)4] and [Ba4Ti4O4(OR)16(ROH)3], where R = Pri.

28 citations

Journal ArticleDOI
TL;DR: In this article, it was shown that considerable attention in sol-gel chemistry of oxides should be paid to decomposition of M(OR)n with elimination of ether and formation of oxoalkoxides, containing M-O-M' bonds.
Abstract: Powders and thin films of the following simple and complex oxides have been obtained from metal alkoxides: MIITiO3 (M= Mg, Ca-Ba), MM1/3B2/3O3 (M= Sr, Ba, M' = Mg-Zn; B= Nb, Ta); MNbO3(M= Li, Na); ZrTiO4; PbTiO3; PZT, PLZT-materials; M2BO4 (M= Li, Na; B= Mo, W), Bi2BO6(B= Mo, W); LixWO3, WO3, MoO3, Bi2O3-WO3(solid solutions), YFeO3, Y3Fe5O12; YBa2Cu3O7-; Bi2Sr2CaCu2Ox; Bi2Sr2Ca2Cu3Ox. For synthesis of metal alkoxides and solutions containing two or more elements electrochemical technique (the anodic dissolution of metals in alcohols) has been used. Analysis of different examples emphasises that considerable attention in sol-gel chemistry of oxides should be paid to decomposition of M(OR)n with elimination of ether and formation of oxoalkoxides, containing M-O-M' bonds-the basis of future oxide phases.

26 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: In this paper, a review of the synthesis and polymerization of aliphatic cyclic carbonates of different size and type is presented. And the mechanisms of cationic, anionic, coordination and enzymatic polymerization are discussed for obtaining polymers with well-defined structures and oligomers with reactive pendant and end groups.

465 citations

Journal ArticleDOI
TL;DR: In this paper, the progress in all of these areas will be reviewed thoroughly, including the early stage of the research, the band structure, photochromic mechanism and the behavior of the oxide.
Abstract: Molybdenum oxide can exhibit pronounced photochromism and thus might act as an excellent photonic material for a number of technical applications. In the early stage of the research, the attention was focused mainly on the (band) structure, photochromic mechanism and the behavior of the oxide. Later, many investigations were carried out on the factors that might influence the photochromic performance. At the same time, the photochromic response has been extended from UV light to visible light. In this review, the progress in all of these areas will be reviewed thoroughly.

258 citations

Journal ArticleDOI
TL;DR: In this paper, the chemistry of methanol was explored on the vacuum annealed TiO2(110) surface, with and without the presence of coadsorbed water and oxygen, using temperature programmed desorption (TPD), high resolution electron energy loss spectroscopy (HREELS), static secondary ion mass spectrometry (SSIMS) and low energy electron diffraction (LEED).
Abstract: The chemistry of methanol was explored on the vacuum annealed TiO2(110) surface, with and without the presence of coadsorbed water and oxygen, using temperature programmed desorption (TPD), high resolution electron energy loss spectroscopy (HREELS), static secondary ion mass spectrometry (SSIMS) and low energy electron diffraction (LEED). The vacuum annealed TiO2(110) surface possessed about 8% oxygen vacancy sites, as determined with H2O TPD. Although evidence is presented for CH3OH dissociation to methoxy groups on the vacuum annealed TiO2(110) surface using SSIMS and HREELS, particularly at vacancy sites, the majority of the adlayer was molecularly adsorbed, evolving in TPD at 295 K. Although no evidence of irreversible decomposition was found in the TPD, dissociative CH3OH adsorption at 135 K on the vacuum annealed TiO2(110) surface led to recombinative desorption states at 350 and 480 K corresponding to methoxys adsorbed at non-vacancy and vacancy sites, respectively. Coadsorbed water had little or no influence on the chemistry of CH3OH on the vacuum annealed TiO2(110) surface, however new channels of chemistry were observed when CH3OH was adsorbed on the surface after O2 adsorption at various temperatures. In particular, O2 exposure at 300 K resulted in O adatoms (via dissociation at vacancies) that led to increased levels of CH3O–H bond cleavage. The higher surface coverage of methoxy then resulted in a disproportionation reaction to form CH3OH and H2CO above 600 K. In contrast, low temperature exposure of the vacuum annealed TiO2(110) surface to O2 resulted in low temperature state of O2 (presumably an O2- species) that oxidized CH3OH to H2CO by C–H bond cleavage. These results provide incentive to consider alternative thermal and photochemical oxidation mechanisms that involve the interaction of organics and oxygen at surface defect sites.

236 citations

Journal ArticleDOI
TL;DR: In this article, a brief updated review of sol-gel-derived electrochromic films of different chemical systems is presented, where performances of selected films measured in electrochemical cells or in devices are discussed and degradation problems experienced by different authors enumerated.

235 citations