Mario Olmedo

Bio: Mario Olmedo is an academic researcher from University of California, Riverside. The author has contributed to research in topics: Resistive random-access memory & Thin film. The author has an hindex of 8, co-authored 14 publications receiving 582 citations.

Electrically pumped ultraviolet ZnO diode lasers on Si

Abstract: Electrically pumped ZnO quantum well diode lasers are reported. Sb-doped p-type ZnO/Ga-doped n-type ZnO with an MgZnO/ZnO/MgZnO quantum well embedded in the junction was grown on Si by molecular beam epitaxy. The diodes emit lasing at room temperature with a very low threshold injection current density of 10 A/cm2. The lasing mechanism is exciton-related recombination and the feedback is provided by close-loop scattering from closely packed nanocolumnar ZnO grains formed on Si.

Resistive switching in single epitaxial ZnO nanoislands.

Abstract: Resistive memory is one of the most promising candidates for next-generation nonvolatile memory technology due to its variety of advantages, such as simple structure and low-power consumption. Bipolar resistive switching behavior was observed in epitaxial ZnO nanoislands with base diameters and heights ranging around 30 and 40 nm, respectively. All four different states (initial, electroformed, ON, and OFF) of the nanoscale resistive memories were measured by conductive atomic force microscopy immediately after the voltage sweeping was performed. Auger electron spectroscopy and other experiments were also carried out to investigate the switching mechanism. The formation and rupture of conducting filaments induced by oxygen vacancy migration are responsible for the resistive switching behaviors of ZnO resistive memories at the nanoscale.

Multimode Resistive Switching in Single ZnO Nanoisland System

Abstract: Resistive memory has attracted a great deal of attention as an alternative to contemporary flash memory. Here we demonstrate an interesting phenomenon that multimode resistive switching, i.e. threshold-like, self-rectifying and ordinary bipolar switching, can be observed in one self-assembled single-crystalline ZnO nanoisland with base diameter and height ranging around 30 and 40 nm on Si at different levels of current compliance. Current-voltage characteristics, conductive atomic force microscopy (C-AFM) and piezoresponse force microscopy results show that the threshold-like and self-rectifying types of switching are controlled by the movement of oxygen vacancies in ZnO nanoisland between the C-AFM tip and Si substrate while ordinary bipolar switching is controlled by formation and rupture of conducting nano-filaments. Threshold-like switching leads to a very small switching power density of 1 × 103 W/cm2.

Dominant ultraviolet light emissions in packed ZnO columnar homojunction diodes

Abstract: The growth of Sb-doped p-type ZnO∕Ga-doped n-type ZnO homojunction on Si (100) substrate by molecular beam epitaxy led to closely packed vertical ZnO columns with lateral diameters ranging from 100to400nm. Mesa structures were defined and Ohmic contact of both n-type ZnO and p-type ZnO was realized with Au∕Ti and Au∕NiO, respectively. I-V and C-V curves present typical electrical properties of a diode, indicating that reliable p-type ZnO was formed. Electroluminescence shows dominant ultraviolet emissions with insignificant deep-level related yellow/green band emissions at different drive currents from 60to100mA at room temperature.

Fundamentals of zinc oxide as a semiconductor

Abstract: In the past ten years we have witnessed a revival of, and subsequent rapid expansion in, the research on zinc oxide (ZnO) as a semiconductor. Being initially considered as a substrate for GaN and related alloys, the availability of high-quality large bulk single crystals, the strong luminescence demonstrated in optically pumped lasers and the prospects of gaining control over its electrical conductivity have led a large number of groups to turn their research for electronic and photonic devices to ZnO in its own right. The high electron mobility, high thermal conductivity, wide and direct band gap and large exciton binding energy make ZnO suitable for a wide range of devices, including transparent thin-film transistors, photodetectors, light-emitting diodes and laser diodes that operate in the blue and ultraviolet region of the spectrum. In spite of the recent rapid developments, controlling the electrical conductivity of ZnO has remained a major challenge. While a number of research groups have reported achieving p-type ZnO, there are still problems concerning the reproducibility of the results and the stability of the p-type conductivity. Even the cause of the commonly observed unintentional n-type conductivity in as-grown ZnO is still under debate. One approach to address these issues consists of growing high-quality single crystalline bulk and thin films in which the concentrations of impurities and intrinsic defects are controlled. In this review we discuss the status of ZnO as a semiconductor. We first discuss the growth of bulk and epitaxial films, growth conditions and their influence on the incorporation of native defects and impurities. We then present the theory of doping and native defects in ZnO based on density-functional calculations, discussing the stability and electronic structure of native point defects and impurities and their influence on the electrical conductivity and optical properties of ZnO. We pay special attention to the possible causes of the unintentional n-type conductivity, emphasize the role of impurities, critically review the current status of p-type doping and address possible routes to controlling the electrical conductivity in ZnO. Finally, we discuss band-gap engineering using MgZnO and CdZnO alloys.

Science and technology roadmap for graphene, related two-dimensional crystals, and hybrid systems

Abstract: We present the science and technology roadmap for graphene, related two-dimensional crystals, and hybrid systems, targeting an evolution in technology, that might lead to impacts and benefits reaching into most areas of society. This roadmap was developed within the framework of the European Graphene Flagship and outlines the main targets and research areas as best understood at the start of this ambitious project. We provide an overview of the key aspects of graphene and related materials (GRMs), ranging from fundamental research challenges to a variety of applications in a large number of sectors, highlighting the steps necessary to take GRMs from a state of raw potential to a point where they might revolutionize multiple industries. We also define an extensive list of acronyms in an effort to standardize the nomenclature in this emerging field.

Speckle-free laser imaging using random laser illumination

Abstract: Exploiting the low spatial coherence of specifically designed random lasers, researchers demonstrate speckle-free full-field imaging in the regime of intense optical scattering. Their results show that the quality of images generated from random-laser illumination is superior to those generated from spatially coherent illumination.

Controlled charge trapping by molybdenum disulphide and graphene in ultrathin heterostructured memory devices

Abstract: Atomically thin two-dimensional materials have emerged as promising candidates for flexible and transparent electronic applications. Here we show non-volatile memory devices, based on field-effect transistors with large hysteresis, consisting entirely of stacked two-dimensional materials. Graphene and molybdenum disulphide were employed as both channel and charge-trapping layers, whereas hexagonal boron nitride was used as a tunnel barrier. In these ultrathin heterostructured memory devices, the atomically thin molybdenum disulphide or graphene-trapping layer stores charge tunnelled through hexagonal boron nitride, serving as a floating gate to control the charge transport in the graphene or molybdenum disulphide channel. By varying the thicknesses of two-dimensional materials and modifying the stacking order, the hysteresis and conductance polarity of the field-effect transistor can be controlled. These devices show high mobility, high on/off current ratio, large memory window and stable retention, providing a promising route towards flexible and transparent memory devices utilizing atomically thin two-dimensional materials.