Mark C. Biesinger

Bio: Mark C. Biesinger is an academic researcher from University of Western Ontario. The author has contributed to research in topics: X-ray photoelectron spectroscopy & Oxide. The author has an hindex of 28, co-authored 64 publications receiving 13148 citations. Previous affiliations of Mark C. Biesinger include Guru Nanak Dev University & University of South Australia.

Investigation of multiplet splitting of Fe 2p XPS spectra and bonding in iron compounds

Abstract: Ferrous (Fe2+) and ferric (Fe3+) compounds were investigated by XPS to determine the usefulness of calculated multiplet peaks to fit high-resolution iron 2p3/2 spectra from high-spin compounds. The multiplets were found to fit most spectra well, particularly when contributions attributed to surface peaks and shake-up satellites were included. This information was useful for fitting of the complex Fe 2p3/2 spectra for Fe3O4 where both Fe2+ and Fe3+ species are present. It was found that as the ionic bond character of the iron —ligand bond increased, the binding energy associated with either the ferrous or ferric 2p3/2 photoelectron peak also increased. This was determined to be due to the decrease in shielding of the iron cation by the more increasingly electronegative ligands. It was also observed that the difference in energy between a high-spin iron 2p3/2 peak and its corresponding shake-up satellite peak increased as the electronegativity of the ligand increased. The extrinsic loss spectra for ion oxides are also reported; these are as characteristic of each species as are the photoelectron peaks. Copyright © 2004 John Wiley & Sons, Ltd.

X-ray photoelectron spectroscopic chemical state quantification of mixed nickel metal, oxide and hydroxide systems

Abstract: Quantitative chemical state X-ray photoelectron spectroscopic analysis of mixed nickel metal, oxide, hydroxide and oxyhydroxide systems is challenging due to the complexity of the Ni 2p peak shapes resulting from multiplet splitting, shake-up and plasmon loss structures. Quantification of mixed nickel chemical states and the qualitative determination of low concentrations of Ni(III) species are demonstrated via an approach based on standard spectra from quality reference samples (Ni, NiO, Ni(OH)2, NiOOH), subtraction of these spectra, and data analysis that integrates information from the Ni 2p spectrum and the O 1s spectra. Quantification of a commercial nickel powder and a thin nickel oxide film grown at 1-Torr O2 and 300 °C for 20 min is demonstrated. The effect of uncertain relative sensitivity factors (e.g. Ni 2.67 ± 0.54) is discussed, as is the depth of measurement for thin film analysis based on calculated inelastic mean free paths. Copyright © 2009 John Wiley & Sons, Ltd.

Advanced analysis of copper X-ray photoelectron spectra

Abstract: Chemical state X-ray photoelectron spectroscopic analysis of copper species is challenging because of the complexity of the 2p spectra resulting from shake-up structures for Cu(II) species and overlapping binding energies for Cu metal and Cu(I) species. This paper builds upon and extends previously published X-ray photoelectron spectroscopy curve-fitting and data analysis procedures for a wide range of copper containing species. Steps undertaken include the following: (i) an examination of existing Cu 2p3/2 main peak and Cu 2p3/2 – Cu L3M4,5M4,5 Auger parameter literature data, (ii) analysis of a series of quality standard samples, (iii) curve-fitting procedures for both the Cu 2p3/2 and the Cu L3M4,5M4,5 spectra (as well as associated anions), (iv) calculations that determine the amount of Cu(II) species in a mixed oxidation state system, (v) calculations and necessary data for thin film mixed oxide/hydroxide thickness measurements, and (vi) a presentation of literature and standard sample values in a Wagner (chemical state) plot. Copyright © 2017 John Wiley & Sons, Ltd.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Microplastics in the Marine Environment: A Review of the Methods Used for Identification and Quantification

Abstract: This review of 68 studies compares the methodologies used for the identification and quantification of microplastics from the marine environment. Three main sampling strategies were identified: selective, volume-reduced, and bulk sampling. Most sediment samples came from sandy beaches at the high tide line, and most seawater samples were taken at the sea surface using neuston nets. Four steps were distinguished during sample processing: density separation, filtration, sieving, and visual sorting of microplastics. Visual sorting was one of the most commonly used methods for the identification of microplastics (using type, shape, degradation stage, and color as criteria). Chemical and physical characteristics (e.g., specific density) were also used. The most reliable method to identify the chemical composition of microplastics is by infrared spectroscopy. Most studies reported that plastic fragments were polyethylene and polypropylene polymers. Units commonly used for abundance estimates are “items per m2” ...

A high-capacity and long-life aqueous rechargeable zinc battery using a metal oxide intercalation cathode

Abstract: Although non-aqueous Li-ion batteries possess significantly higher energy density than their aqueous counterparts, the latter can be more feasible for grid-scale applications when cost, safety and cycle life are taken into consideration. Moreover, aqueous Zn-ion batteries have an energy storage advantage over alkali-based batteries as they can employ Zn metal as the negative electrode, dramatically increasing energy density. However, their development is plagued by a limited choice of positive electrodes, which often show poor rate capability and inadequate cycle life. Here we report a vanadium oxide bronze pillared by interlayer Zn2+ ions and water (Zn0.25V2O5⋅nH2O), as the positive electrode for a Zn cell. A reversible Zn2+ ion (de)intercalation storage process at fast rates, with more than one Zn2+ per formula unit (a capacity up to 300 mAh g−1), is characterized. The Zn cell offers an energy density of ∼450 Wh l−1 and exhibits a capacity retention of more than 80% over 1,000 cycles, with no dendrite formation at the Zn electrode. High-performing positive electrode materials are crucial for the development of aqueous Zn-ion batteries. Here the authors report a battery based on reversible intercalation of Zn ions in a layered Zn0.25V2O5⋅nH2O-based positive electrode, which exhibits high-capacity and long-term cycling stability.