Marta I. Litter

Bio: Marta I. Litter is an academic researcher from National Scientific and Technical Research Council. The author has contributed to research in topics: Photocatalysis & Arsenic. The author has an hindex of 50, co-authored 178 publications receiving 9464 citations. Previous affiliations of Marta I. Litter include Spanish National Research Council & National Atomic Energy Commission.

Heterogeneous photocatalysis: Transition metal ions in photocatalytic systems

Abstract: The presence of transition metal ions in photocatalytic reactions is reviewed according to two main approaches: (a) the influence of transition metal ions on the rate of photocatalytic reactions (mainly oxidation) and (b) the transformation of the ions to less toxic species or their deposition on the semiconductor catalyst surface for recovery of expensive and useful metals. Most of the proposed mechanisms are discussed, together with experimental physicochemical evidences that support the involved pathways. Practical applications related to environmental protection and industrial processes are described.

Photocatalytic properties of iron-doped titania semiconductors

Abstract: An exhaustive review on the photochemical properties of iron-doped TiO2 semiconductors is presented. Photocatalytic reactions (reductions and oxidations) using Fe-containing TiO2 on different organic and inorganic substrates are reported. Different aspects relating to structural, surface and photophysical properties of these photocatalysts are extensively discussed. The origin of the photoactivity of this kind of mixed oxides is considered with regards to previously proposed physical and chemical processes and on the role of the iron content.

The combination of heterogeneous photocatalysis with chemical and physical operations: A tool for improving the photoprocess performance

Abstract: Heterogeneous photocatalysis is a process of great potential for pollutant abatement and waste treatment. In order to improve the overall performance of the photoprocess, heterogeneous photocatalysis is being combined with physical or chemical operations, which affect the chemical kinetics and/or the overall efficiency. This review addresses the various possibilities to couple heterogeneous photocatalysis with other technologies to photodegrade organic and inorganic pollutants dissolved in actual or synthetic aqueous effluents. These combinations increase the photoprocess efficiency by decreasing the reaction time in respect to the separated operations or they decrease the cost in respect of heterogeneous photocatalysis alone, generally in terms of light energy. Depending on the operation coupled with heterogeneous photocatalysis, two categories of combinations exist. When the coupling is with ultrasonic irradiation, photo-Fenton reaction, ozonation, or electrochemical treatment, the combination affects the photocatalytic mechanisms thus improving the efficiency of the photocatalytic process. When the coupling is with biological treatment, membrane reactor, membrane photoreactor, or physical adsorption, the combination does not affect the photocatalytic mechanisms but it improves the efficiency of the overall process. The choice of the coupling is related to the type of wastewater to be treated. A synergistic effect, giving rise to an improvement of the efficiency of the photocatalytic process, has been reported in the literature for many cases.

Emissions from Electronic Cigarettes: Key Parameters Affecting the Release of Harmful Chemicals

Abstract: Use of electronic cigarettes has grown exponentially over the past few years, raising concerns about harmful emissions. This study quantified potentially toxic compounds in the vapor and identified key parameters affecting emissions. Six principal constituents in three different refill "e-liquids" were propylene glycol (PG), glycerin, nicotine, ethanol, acetol, and propylene oxide. The latter, with mass concentrations of 0.4-0.6%, is a possible carcinogen and respiratory irritant. Aerosols generated with vaporizers contained up to 31 compounds, including nicotine, nicotyrine, formaldehyde, acetaldehyde, glycidol, acrolein, acetol, and diacetyl. Glycidol is a probable carcinogen not previously identified in the vapor, and acrolein is a powerful irritant. Emission rates ranged from tens to thousands of nanograms of toxicants per milligram of e-liquid vaporized, and they were significantly higher for a single-coil vs a double-coil vaporizer (by up to an order of magnitude for aldehydes). By increasing the voltage applied to a single-coil device from 3.3 to 4.8 V, the mass of e-liquid consumed doubled from 3.7 to 7.5 mg puff(-1) and the total aldehyde emission rates tripled from 53 to 165 μg puff(-1), with acrolein rates growing by a factor of 10. Aldehyde emissions increased by more than 60% after the device was reused several times, likely due to the buildup of polymerization byproducts that degraded upon heating. These findings suggest that thermal degradation byproducts are formed during vapor generation. Glycidol and acrolein were primarily produced by glycerin degradation. Acetol and 2-propen-1-ol were produced mostly from PG, while other compounds (e.g., formaldehyde) originated from both. Because emissions originate from reaction of the most common e-liquid constituents (solvents), harmful emissions are expected to be ubiquitous when e-cigarette vapor is present.

Understanding TiO2 photocatalysis: mechanisms and materials.

Abstract: Jenny Schneider,*,† Masaya Matsuoka,‡ Masato Takeuchi,‡ Jinlong Zhang, Yu Horiuchi,‡ Masakazu Anpo,‡ and Detlef W. Bahnemann*,† †Institut fur Technische Chemie, Leibniz Universitaẗ Hannover, Callinstrasse 3, D-30167 Hannover, Germany ‡Faculty of Engineering, Osaka Prefecture University, 1 Gakuen-cho, Sakai Osaka 599-8531, Japan Key Lab for Advanced Materials and Institute of Fine Chemicals, East China University of Science and Technology, Shanghai 200237, China

A review and recent developments in photocatalytic water-splitting using TiO2 for hydrogen production

Abstract: Nano-sized TiO 2 photocatalytic water-splitting technology has great potential for low-cost, environmentally friendly solar-hydrogen production to support the future hydrogen economy. Presently, the solar-to-hydrogen energy conversion efficiency is too low for the technology to be economically sound. The main barriers are the rapid recombination of photo-generated electron/hole pairs as well as backward reaction and the poor activation of TiO 2 by visible light. In response to these deficiencies, many investigators have been conducting research with an emphasis on effective remediation methods. Some investigators studied the effects of addition of sacrificial reagents and carbonate salts to prohibit rapid recombination of electron/hole pairs and backward reactions. Other research focused on the enhancement of photocatalysis by modification of TiO 2 by means of metal loading, metal ion doping, dye sensitization, composite semiconductor, anion doping and metal ion-implantation. This paper aims to review the up-to-date development of the above-mentioned technologies applied to TiO 2 photocatalytic hydrogen production. Based on the studies reported in the literature, metal ion-implantation and dye sensitization are very effective methods to extend the activating spectrum to the visible range. Therefore, they play an important role in the development of efficient photocatalytic hydrogen production.