Matthew O'donnell

Bio: Matthew O'donnell is an academic researcher from University of California, Davis. The author has contributed to research in topics: Tracheal collapse & Ring (chemistry). The author has an hindex of 2, co-authored 3 publications receiving 23 citations.

Forward-Viewing Ring-Annular Ultrasound Array for Intravascular Imaging

Abstract: In this paper, we present some initial results from our proposed forward viewing ring-annular array for intravascular ultrasound imaging. We have investigated array design and image synthesis allowing simultaneous sideward imaging at 20 MHz and forward imaging at 10 MHz from the same array. This design is appropriate for over-the-wire delivery but limits the forward-looking aperture to a ring-annular array. In particular, a 1200 /spl mu/m diameter ring-annular array with 64 elements has been constructed. The measured forward- viewing radiation pattern of an individual element indicates an acceptance angle range of over 90/spl deg/. Currently, there are significant sensitivity and center frequency variations among the elements. Nevertheless, images of point targets are obtained as a proof-of-concept. Future improvements of the array will be discussed.

Kinetic and kinematic gait analysis in the pelvic limbs of normal and post-hemilaminectomy Dachshunds

Abstract: Objective: To compare pelvic limb kinetic and kinematic gait parameters between Dachshunds six months following hemilaminectomy for treatment of thoracolumbar disc extrusion (post-hemilaminectomy; PHL) and Dachshunds without history and clinical evidence of spinal cord disease (control; CON). Methods: The CON (n = 8) and PHL (n = 6) Dachshunds were recruited for objective gait evaluation. Kinetic data collected included peak vertical force (PVF), stance phase duration and swing phase duration. Kinematic data collected included tarsal, stifle and hip range of motion (ROM) during stance and swing phases of the trot, tail ROM, and horizontal and vertical components of pelvis ROM. Results: No significant differences were identified between tarsal, stifle, hip, and tail ROM between CON and PHL Dachshunds. Although PVF was not significantly different between CON and PHL Dachshunds, PVF varied on average by 14% between the pelvic limbs in PHL Dachshunds (p

Annular-ring CMUT arrays for forward-looking IVUS: transducer characterization and imaging

Abstract: In this study, a 64-element, 1.15-mm diameter annular-ring capacitive micromachined ultrasonic transducer (CMUT) array was characterized and used for forward-looking intravascular ultrasound (IVUS) imaging tests. The array was manufactured using low-temperature processes suitable for CMOS electronics integration on a single chip. The measured radiation pattern of a 43 /spl times/ 140-/spl mu/m array element depicts a 40/spl deg/ view angle for forward-looking imaging around a 15-MHz center frequency in agreement with theoretical models. Pulse-echo measurements show a -10-dB fractional bandwidth of 104% around 17 MHz for wire targets 2.5 mm away from the array in vegetable oil. For imaging and SNR measurements, RF A-scan data sets from various targets were collected using an interconnect scheme forming a 32-element array configuration. An experimental point spread function was obtained and compared with simulated and theoretical array responses, showing good agreement. Therefore, this study demonstrates that annular-ring CMUT arrays fabricated with CMOS-compatible processes are capable of forward-looking IVUS imaging, and the developed modeling tools can be used to design improved IVUS imaging arrays.

3-D ultrasound imaging using a forward-looking CMUT ring array for intravascular/intracardiac applications

Abstract: Forward-viewing ring arrays can enable new applications in intravascular and intracardiac ultrasound. This work presents compelling, full-synthetic, phased-array volumetric images from a forward-viewing capacitive micromachined ultrasonic transducer (CMUT) ring array wire bonded to a custom integrated circuit front end. The CMUT ring array has a diameter of 2 mm and 64 elements each 100 /spl mu/m /spl times/ 100 /spl mu/m in size. In conventional mode, echo signals received from a plane reflector at 5 mm had 70% fractional bandwidth around a center frequency of 8.3 MHz. In collapse mode, 69% fractional bandwidth is measured around 19 MHz. Measured signal-to-noise ratio (SNR) of the echo averaged 16 times was 29 dB for conventional operation and 35 dB for collapse mode. B-scans were generated of a target consisting of steel wires 0.3 mm in diameter to determine resolution performance. The 6 dB axial and lateral resolutions for the B-scan of the wire target are 189 /spl mu/m and 0.112 radians for 8 MHz, and 78 /spl mu/m and 0.051 radians for 19 MHz. A reduced firing set suitable for real-time, intravascular applications was generated and shown to produce acceptable images. Rendered three-dimensional (3-D) images of a Palmaz-Schatz stent also are shown, demonstrating that the imaging quality is sufficient for practical applications.

Volumetric real-time imaging using a CMUT ring array

Abstract: A ring array provides a very suitable geometry for forward-looking volumetric intracardiac and intravascular ultrasound imaging. We fabricated an annular 64-element capacitive micromachined ultrasonic transducer (CMUT) array featuring a 10-MHz operating frequency and a 1.27-mm outer radius. A custom software suite was developed to run on a PCbased imaging system for real-time imaging using this device. This paper presents simulated and experimental imaging results for the described CMUT ring array. Three different imaging methods-flash, classic phased array (CPA), and synthetic phased array (SPA)-were used in the study. For SPA imaging, two techniques to improve the image quality-Hadamard coding and aperture weighting-were also applied. The results show that SPA with Hadamard coding and aperture weighting is a good option for ring-array imaging. Compared with CPA, it achieves better image resolution and comparable signal-tonoise ratio at a much faster image acquisition rate. Using this method, a fast frame rate of up to 463 volumes per second is achievable if limited only by the ultrasound time of flight; with the described system we reconstructed three cross-sectional images in real-time at 10 frames per second, which was limited by the computation time in synthetic beamforming.

Real-time 3-D ultrasound guidance of interventional devices

Abstract: We have previously developed 2-D array transducers for many real-time volumetric imaging applications. These applications include transducers operating up to 7 MHz for transthoracic imaging, up to 15 MHz for intracardiac echocardiography (ICE), 5 MHz for transesophageal echocardiography (TEE) and intracranial imaging, and 7 MHz for laparoscopic ultrasound imaging (LUS). Now we have developed a new generation of miniature ring-array transducers integrated into the catheter deployment kits of interventional devices to enable real-time 3-D ultrasound scanning for improved guidance of minimally invasive procedures. We have constructed 3 new ring transducers. The first consists of 54 elements operating at 5 MHz. Typical measured transducer element bandwidth was 25%, and the 50 Ohm round trip insertion loss was -65 dB. Average nearest neighbor cross talk was -23.8 dB. The second is a prototype 108-element transducer operating at 5 MHz. The third is a prototype 108-element ring array with a transducer center frequency of 8.9 MHz and a -6 dB bandwidth of 25%. All transducers were integrated with an 8.5 French catheter sheath of a Cook Medical, Inc. vena cava filter deployment device.