Michael Grätzel

Bio: Michael Grätzel is an academic researcher from École Polytechnique Fédérale de Lausanne. The author has contributed to research in topics: Dye-sensitized solar cell & Perovskite (structure). The author has an hindex of 248, co-authored 1423 publications receiving 303599 citations. Previous affiliations of Michael Grätzel include University of California, Berkeley & Siemens Energy Sector.

Solid-state synthesis of CdFe2O4 binary catalyst for potential application in renewable hydrogen fuel generation

Abstract: Clean energy is highly needed at this time when the energy requirements are rapidly increasing. The observed increasing energy requirement are largely due to continued industrialization and global population explosion. The current means of energy source is not sustainable because of several reasons, most importantly, environmental pollution and human health deterioration due to burning of fossil fuels. Therefore, this study develops a new catalyst for hydrogen and oxygen evolution by water splitting as a potential energy vector. The binary metal oxide catalyst CdFe2O4 was synthesized by the solventless solid-mechanical alloying method. The as-prepared catalyst was well characterized by several methods including field emission scanning electron microscopy (FESEM), X-ray diffraction spectroscopy (XRD), X-ray photoelectron spectroscopy (XPS), Fourier Transform infrared red spectroscopy (FTIR), energy dispersive X-ray spectroscopy (XEDS). The as-prepared catalyst, CdFe2O4 was successfully applied for water electrolysis at a moderate overpotential (470 mV). Specifically, the onset potential for the oxygen and hydrogen evolution reactions (OER and HER) were 1.6 V/RHE and 0.2 V/RHE respectively (vs. the reversible hydrogen electrode). The electrode potential required to reach 10 mA/cm-2 for OER (in alkaline medium) and HER (in acidic medium) was 1.70 V/RHE (corresponding to overpotential η = 0.47 and - 0.30 V/RHE (η = - 0.30 V) respectively. Similarly, the developed OER and HER catalyst displayed high current and potential stability for a period of 12 h. This approach is seen as the right track of making water electrolysis for hydrogen energy feasible through provision of low-energy requirement for the electrolytic process. Therefore, CdFe2O4 is a potential water splitting catalyst for hydrogen evolution which is a clean fuel and an antidote for world dependence on fossil fuel for energy generation.

Nanostructured solar cells

Abstract: Conversion into electrical power of even a small fraction of the solar radiation incident on the Earth's surface has the potential to satisfy the world's energy demands without generating CO2 emissions. Current photovoltaic technology is not yet fulfilling this promise, largely due to the high cost of the electricity produced. Although the challenges of storage and distribution should not be underestimated, a major bottleneck lies in the photovoltaic devices themselves. Improving efficiency is part of the solution, but diminishing returns in that area mean that reducing the manufacturing cost is absolutely vital, whilst still retaining good efficiencies and device lifetimes. Solution-processible materials, e.g. organic molecules, conjugated polymers and semiconductor nanoparticles, offer new routes to the low-cost production of solar cells. The challenge here is that absorbing light in an organic material produces a coulombically bound exciton that requires dissociation at a donor–acceptor heterojunction. A thickness of at least 100 nm is required to absorb the incident light, but excitons only diffuse a few nanometres before decaying. The problem is therefore intrinsically at the nano-scale: we need composite devices with a large area of internal donor–acceptor interface, but where each carrier has a pathway to the respective electrode. Dye-sensitized and bulk heterojunction cells have nanostructures which approach this challenge in different ways, and leading research in this area is described in many of the articles in this special issue. This issue is not restricted to organic or dye-sensitized photovoltaics, since nanotechnology can also play an important role in devices based on more conventional inorganic materials. In these materials, the electronic properties can be controlled, tuned and in some cases completely changed by nanoscale confinement. Also, the techniques of nanoscience are the natural ones for investigating the localized states, particularly at surfaces and interfaces, which are often the limiting factor in device performance. This issue provides concrete examples of how the techniques of nanoscience and nanotechnology can be used to understand, control and optimize the performance of novel photovoltaic devices. We are grateful to the contributors for submitting high-quality papers around a common theme, even though they may not normally consider their work to fall under the banner of 'nanotechnology'. We would also like to thank the editorial and production staff at Nanotechnology for their efficient and speedy work in putting this issue together.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Fast parallel algorithms for short-range molecular dynamics

Abstract: Three parallel algorithms for classical molecular dynamics are presented. The first assigns each processor a fixed subset of atoms; the second assigns each a fixed subset of inter-atomic forces to compute; the third assigns each a fixed spatial region. The algorithms are suitable for molecular dynamics models which can be difficult to parallelize efficiently—those with short-range forces where the neighbors of each atom change rapidly. They can be implemented on any distributed-memory parallel machine which allows for message-passing of data between independently executing processors. The algorithms are tested on a standard Lennard-Jones benchmark problem for system sizes ranging from 500 to 100,000,000 atoms on several parallel supercomputers--the nCUBE 2, Intel iPSC/860 and Paragon, and Cray T3D. Comparing the results to the fastest reported vectorized Cray Y-MP and C90 algorithm shows that the current generation of parallel machines is competitive with conventional vector supercomputers even for small problems. For large problems, the spatial algorithm achieves parallel efficiencies of 90% and a 1840-node Intel Paragon performs up to 165 faster than a single Cray C9O processor. Trade-offs between the three algorithms and guidelines for adapting them to more complex molecular dynamics simulations are also discussed.

A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films

Abstract: THE large-scale use of photovoltaic devices for electricity generation is prohibitively expensive at present: generation from existing commercial devices costs about ten times more than conventional methods1. Here we describe a photovoltaic cell, created from low-to medium-purity materials through low-cost processes, which exhibits a commercially realistic energy-conversion efficiency. The device is based on a 10-µm-thick, optically transparent film of titanium dioxide particles a few nanometres in size, coated with a monolayer of a charge-transfer dye to sensitize the film for light harvesting. Because of the high surface area of the semiconductor film and the ideal spectral characteristics of the dye, the device harvests a high proportion of the incident solar energy flux (46%) and shows exceptionally high efficiencies for the conversion of incident photons to electrical current (more than 80%). The overall light-to-electric energy conversion yield is 7.1-7.9% in simulated solar light and 12% in diffuse daylight. The large current densities (greater than 12 mA cm-2) and exceptional stability (sustaining at least five million turnovers without decomposition), as well as the low cost, make practical applications feasible.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Environmental Applications of Semiconductor Photocatalysis

Abstract: The civilian, commercial, and defense sectors of most advanced industrialized nations are faced with a tremendous set of environmental problems related to the remediation of hazardous wastes, contaminated groundwaters, and the control of toxic air contaminants. For example, the slow pace of hazardous waste remediation at military installations around the world is causing a serious delay in conversion of many of these facilities to civilian uses. Over the last 10 years problems related to hazardous waste remediation have emerged as a high national and international priority.