Michael Grätzel

Bio: Michael Grätzel is an academic researcher from École Polytechnique Fédérale de Lausanne. The author has contributed to research in topics: Dye-sensitized solar cell & Perovskite (structure). The author has an hindex of 248, co-authored 1423 publications receiving 303599 citations. Previous affiliations of Michael Grätzel include University of California, Berkeley & Siemens Energy Sector.

Boosting the performance of Cu2O photocathodes for unassisted solar water splitting devices

Abstract: Although large research efforts have been devoted to photoelectrochemical (PEC) water splitting in the past several decades, the lack of efficient, stable and Earth-abundant photoelectrodes remains a bottleneck for practical application. Here, we report a photocathode with a coaxial nanowire structure implementing a Cu2O/Ga2O3-buried p–n junction that achieves efficient light harvesting across the whole visible region to over 600 nm, reaching an external quantum yield for hydrogen generation close to 80%. With a photocurrent onset over +1 V against the reversible hydrogen electrode and a photocurrent density of ~10 mA cm−2 at 0 V versus the reversible hydrogen electrode, our electrode constitutes the best oxide photocathode for catalytic generation of hydrogen from sunlight known today. Conformal coating via atomic-layer deposition of a TiO2 protection layer enables stable operation exceeding 100 h. Using NiMo as the hydrogen evolution catalyst, an all Earth-abundant Cu2O photocathode was achieved with stable operation in a weak alkaline electrolyte. To show the practical impact of this photocathode, we constructed an all-oxide unassisted solar water splitting tandem device using state-of-the-art BiVO4 as the photoanode, achieving ~3% solar-to-hydrogen conversion efficiency. The generation of hydrogen fuel from water and visible light requires photoelectrodes that are inexpensive, stable and highly active. Now, Luo, Gratzel and co-workers report Cu2O photocathodes that reach these goals. Incorporation into an unassisted solar water splitting device gives ~3% solar-to-hydrogen conversion efficiency.

Molecular Engineering of Push–Pull Porphyrin Dyes for Highly Efficient Dye‐Sensitized Solar Cells: The Role of Benzene Spacers

Abstract: Porphyrins have drawn much attention as sensitizers owing to the large absorption coefficients of their Soret and Q bands in the visible region. In a donor and acceptor zinc porphyrin we applied a new strategy of introducing 2,1,3-benzothiadiazole (BTD) as a pi-conjugated linker between the anchoring group and the porphyrin chromophore to broaden the absorption spectra to fill the valley between the Soret and Q bands. With this novel approach, we observed 12.75% power-conversion efficiency under simulated one-sun illumination (AM1.5G, 100 mW cm(-2)). In this study, we showed the importance of introducing the phenyl group as a spacer between the BTD and the zinc porphyrin in achieving high power-conversion efficiencies. Time-resolved fluorescence, transient-photocurrent-decay, and transient-photovoltage-decay measurements were employed to determine the electron-injection dynamics and the lifetime of the photogenerated charge carriers.

Electron transport and recombination in solid-state dye solar cell with spiro-OMeTAD as hole conductor.

Abstract: We show that electron transport mechanisms in TiO2 solid-state dye-sensitized solar cells (SDSCs) with spiro-OMeTAD as hole conductor are similar to those of high-performance DSCs with liquid electrolytes and ionic liquids. Impedance spectroscopy provides the parameters for transport and recombination at different conditions of steady state in the dark. The recombination rate is much higher in the solid solar cell, this being a main limiting step to obtain high-efficiency SDSCs. Thus, the expected gain in photovoltage, due to a lower hole Fermi level, is prevented by recombination losses. Under low potentials the transport is limited by the electron transport in the TiO2, but at high potentials spiro-OMeTAD transport resistance reduces the fill factor and hence the efficiency on high-current devices.

Solvent-Free Ionic Liquid Electrolytes for Mesoscopic Dye-Sensitized Solar Cells

Abstract: Ionic liquids have been identified as a new class of solvent that offers opportunities to move away from the traditional solvents. The physical-chemical properties of ionic liquids can be tuned and controlled by tailoring their structures. The typical properties of ionic liquids, such as non-volatility, electrochemical stability and high conductivity, render them attractive as electrolytes for dye-sensitized solar cells. However, the high viscosity of ionic liquids leads to mass transport limitations on the photocurrents in the solar cells at full sunlight intensity, but the contribution of a Grotthous-type exchange mechanism in these viscous electrolytes helps to alleviate these diffusion problems. This article discusses recent developments in the field of high-performance dye-sensitized solar cells with ionic liquid-based electrolytes and their characterization by electrochemical impedance analysis.

Efficient light harvesting by using green Zn-porphyrin-sensitized nanocrystalline TiO2 films.

Abstract: A series of novel zinc metalloporphyrins, cyano-3-(2‘-(5‘,10‘,15‘,20‘-tetraphenylporphyrinato zinc(II))yl)-acrylic acid (Zn-3), 3-(trans-2‘-(5‘,10‘,15‘,20‘-tetraphenylporphyrinato zinc(II))yl)-acrylic acid (Zn-5), 2-cyano-5-(2‘-(5‘,10‘,15‘,20‘-tetraphenylporphyrinato zinc(II))yl)-penta-2,4-dienoic acid (Zn-8), 4-(trans-2‘-(2‘ ‘-(5‘ ‘,10‘ ‘,15‘ ‘,20‘ ‘-tetraphenylporphyrinato zinc(II))yl)ethen-1‘-yl))-1,2-benzenedicarboxylic acid (Zn-11), and 2-cyano-3-[4‘-(trans-2‘ ‘-(2‘ ‘‘-(5‘ ‘‘,10‘ ‘‘,15‘ ‘‘,20‘ ‘‘-tetraphenylporphyrinato zinc(II))yl) ethen-1‘ ‘-yl)-phenyl]-acrylic acid (Zn-13) were synthesized and characterized by using various spectroscopic techniques. Density functional theory (DFT) and time-dependent DFT (TDDFT) calculations show that key molecular orbitals (MOs) of porphyrins Zn-5 and Zn-3 are stabilized and extended out onto the substituent by π-conjugation, causing enhancement and red shifts of visible transitions and increasing the possibility of electron transfer from the substituent. The porp...

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Fast parallel algorithms for short-range molecular dynamics

Abstract: Three parallel algorithms for classical molecular dynamics are presented. The first assigns each processor a fixed subset of atoms; the second assigns each a fixed subset of inter-atomic forces to compute; the third assigns each a fixed spatial region. The algorithms are suitable for molecular dynamics models which can be difficult to parallelize efficiently—those with short-range forces where the neighbors of each atom change rapidly. They can be implemented on any distributed-memory parallel machine which allows for message-passing of data between independently executing processors. The algorithms are tested on a standard Lennard-Jones benchmark problem for system sizes ranging from 500 to 100,000,000 atoms on several parallel supercomputers--the nCUBE 2, Intel iPSC/860 and Paragon, and Cray T3D. Comparing the results to the fastest reported vectorized Cray Y-MP and C90 algorithm shows that the current generation of parallel machines is competitive with conventional vector supercomputers even for small problems. For large problems, the spatial algorithm achieves parallel efficiencies of 90% and a 1840-node Intel Paragon performs up to 165 faster than a single Cray C9O processor. Trade-offs between the three algorithms and guidelines for adapting them to more complex molecular dynamics simulations are also discussed.

A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films

Abstract: THE large-scale use of photovoltaic devices for electricity generation is prohibitively expensive at present: generation from existing commercial devices costs about ten times more than conventional methods1. Here we describe a photovoltaic cell, created from low-to medium-purity materials through low-cost processes, which exhibits a commercially realistic energy-conversion efficiency. The device is based on a 10-µm-thick, optically transparent film of titanium dioxide particles a few nanometres in size, coated with a monolayer of a charge-transfer dye to sensitize the film for light harvesting. Because of the high surface area of the semiconductor film and the ideal spectral characteristics of the dye, the device harvests a high proportion of the incident solar energy flux (46%) and shows exceptionally high efficiencies for the conversion of incident photons to electrical current (more than 80%). The overall light-to-electric energy conversion yield is 7.1-7.9% in simulated solar light and 12% in diffuse daylight. The large current densities (greater than 12 mA cm-2) and exceptional stability (sustaining at least five million turnovers without decomposition), as well as the low cost, make practical applications feasible.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Environmental Applications of Semiconductor Photocatalysis

Abstract: The civilian, commercial, and defense sectors of most advanced industrialized nations are faced with a tremendous set of environmental problems related to the remediation of hazardous wastes, contaminated groundwaters, and the control of toxic air contaminants. For example, the slow pace of hazardous waste remediation at military installations around the world is causing a serious delay in conversion of many of these facilities to civilian uses. Over the last 10 years problems related to hazardous waste remediation have emerged as a high national and international priority.