Michael Grätzel

Bio: Michael Grätzel is an academic researcher from École Polytechnique Fédérale de Lausanne. The author has contributed to research in topics: Dye-sensitized solar cell & Perovskite (structure). The author has an hindex of 248, co-authored 1423 publications receiving 303599 citations. Previous affiliations of Michael Grätzel include University of California, Berkeley & Siemens Energy Sector.

Toward All Room-Temperature, Solution-Processed, High-Performance Planar Perovskite Solar Cells: A New Scheme of Pyridine-Promoted Perovskite Formation

Abstract: A new, all room-temperature solution process is developed to fabricate efficient, low-cost, and stable perovskite solar cells (PVSCs). The PVSCs show high efficiency of 17.10% and 14.19%, with no hysteresis on rigid and flexible substrates, respectively, which are the best efficiencies reported to date for PVSCs fabricated by room-temperature solution-processed techniques. The flexible PVSCs show a remarkable power-per-weight of 23.26 W g-1 .

Rutile TiO2-based perovskite solar cells

Abstract: A perovskite solar cell based on rutile TiO2 film was prepared and its photovoltaic performance was compared to an anatase TiO2-based perovskite solar cell. Rutile TiO2 nanoparticles with aspect ratio of 0.2 (20 nm wide and 100 nm long) were prepared by hydrolysis of TiCl4 at ambient temperature. Anatase TiO2 nanoparticles with diameter of about 50 nm were hydrothermally synthesized. The annealed rutile film showed porosity of 60.6%, while lower porosity of 49.1% was detected in the anatase TiO2 film. CH3NH3PbI3 perovskite was deposited on TiO2 film using either a one-step spin coating or two-step dipping method. 2,2′,7,7′-Tetrakis(N,N-p-dimethoxy-phenylamino)-9,9′-spirobifluorene (spiro-MeOTAD) was used as a hole transporting material. One-step deposition led to average power conversion efficiency (PCE) of 8.19% from the rutile-perovskite solar cells and 7.23% from the anatase-perovskite solar cells, while two-step deposition resulted in higher average PCE of 13.75% for the former device and 13.99% for the latter one. Regardless of the deposition methodologies, the rutile–perovskite solar cell showed generally higher Jsc and lower Voc. Slower electron transport and longer electron lifetime were observed for the rutile-based perovskite solar cell than for the anatase-based one. Although the same perovskite material was used for both rutile and anatase TiO2, the difference in electronic behavior indicates that photo-excited electrons are in part injected to TiO2 and the extent of electron injection can be influenced by the crystal phase of TiO2. Despite longer electron lifetime, the slightly lower voltage of the rutile-based device might be due to the fact that the amount of injected electrons was relatively larger for rutile than anatase, leading to a lower Fermi energy level at equilibrium between TiO2 and perovskite. Using a 260 nm-thick rutile TiO2 film, the highest PCE of 14.46% was achieved by depositing CH3NH3PbI3 using a two-step method, in which photocurrent density of 20.02 mA cm−2, open-circuit voltage of 1.022 V and fill factor of 0.71 were demonstrated.

Transforming Hybrid Organic Inorganic Perovskites by Rapid Halide Exchange

Abstract: We report on rapid halide exchange in metal halide perovskite of the general formula MAPbX3 (X = Cl, Br, or I). We find that when the perovskite is infiltrated in a mesoscopic scaffold, halide substitution on the perovskite lattice is strikingly fast, being completed within seconds or minutes after contact with the halide solution. An exception is the exchange of bromide by iodide, which is slower and incomplete. Halide substitution occurs rapidly even for planar perovskite films which are several tens of nanometers thick. However, with thicker films the reaction requires hours, showing that the mesoscale greatly accelerates the halide exchange process. The time course of the substitution reactions has been monitored by in situ photoluminescence, absorption spectroscopy, and X-ray diffraction measurements. We show that the halide exchange can be a powerful tool to effect perovskite transformations.

Applied physics: Solar cells to dye for.

Abstract: The idea of producing electricity from sunlight is attractive, but in practice the technology to do so is expensive. A new device, moving away from the traditional silicon design, shows promise.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Fast parallel algorithms for short-range molecular dynamics

Abstract: Three parallel algorithms for classical molecular dynamics are presented. The first assigns each processor a fixed subset of atoms; the second assigns each a fixed subset of inter-atomic forces to compute; the third assigns each a fixed spatial region. The algorithms are suitable for molecular dynamics models which can be difficult to parallelize efficiently—those with short-range forces where the neighbors of each atom change rapidly. They can be implemented on any distributed-memory parallel machine which allows for message-passing of data between independently executing processors. The algorithms are tested on a standard Lennard-Jones benchmark problem for system sizes ranging from 500 to 100,000,000 atoms on several parallel supercomputers--the nCUBE 2, Intel iPSC/860 and Paragon, and Cray T3D. Comparing the results to the fastest reported vectorized Cray Y-MP and C90 algorithm shows that the current generation of parallel machines is competitive with conventional vector supercomputers even for small problems. For large problems, the spatial algorithm achieves parallel efficiencies of 90% and a 1840-node Intel Paragon performs up to 165 faster than a single Cray C9O processor. Trade-offs between the three algorithms and guidelines for adapting them to more complex molecular dynamics simulations are also discussed.

A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films

Abstract: THE large-scale use of photovoltaic devices for electricity generation is prohibitively expensive at present: generation from existing commercial devices costs about ten times more than conventional methods1. Here we describe a photovoltaic cell, created from low-to medium-purity materials through low-cost processes, which exhibits a commercially realistic energy-conversion efficiency. The device is based on a 10-µm-thick, optically transparent film of titanium dioxide particles a few nanometres in size, coated with a monolayer of a charge-transfer dye to sensitize the film for light harvesting. Because of the high surface area of the semiconductor film and the ideal spectral characteristics of the dye, the device harvests a high proportion of the incident solar energy flux (46%) and shows exceptionally high efficiencies for the conversion of incident photons to electrical current (more than 80%). The overall light-to-electric energy conversion yield is 7.1-7.9% in simulated solar light and 12% in diffuse daylight. The large current densities (greater than 12 mA cm-2) and exceptional stability (sustaining at least five million turnovers without decomposition), as well as the low cost, make practical applications feasible.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Environmental Applications of Semiconductor Photocatalysis

Abstract: The civilian, commercial, and defense sectors of most advanced industrialized nations are faced with a tremendous set of environmental problems related to the remediation of hazardous wastes, contaminated groundwaters, and the control of toxic air contaminants. For example, the slow pace of hazardous waste remediation at military installations around the world is causing a serious delay in conversion of many of these facilities to civilian uses. Over the last 10 years problems related to hazardous waste remediation have emerged as a high national and international priority.