Mikihiko Oogane

Bio: Mikihiko Oogane is an academic researcher from Tohoku University. The author has contributed to research in topics: Tunnel magnetoresistance & Magnetoresistance. The author has an hindex of 44, co-authored 266 publications receiving 7006 citations.

Giant tunneling magnetoresistance in Co2MnSi∕Al–O∕Co2MnSi magnetic tunnel junctions

Abstract: Magnetic tunnel junctions (MTJs) with a stacking structure of Co2MnSi∕Al–O∕Co2MnSi were fabricated using magnetron sputtering system. Fabricated MTJ exhibited an extremely large tunneling magnetoresistance (TMR) ratio of 570% at low temperature, which is the highest TMR ratio reported to date for an amorphous Al–O tunneling barrier. The observed dependence of tunneling conductance on bias voltage clearly reveals the half-metallic energy gap of Co2MnSi. The origins of large temperature dependence of TMR ratio were discussed on the basis of the present results.

Long-lived ultrafast spin precession in manganese alloys films with a large perpendicular magnetic anisotropy.

Abstract: Spin precession with frequencies up to 280 GHz is observed in Mn(3-δ)Ga alloy films with a perpendicular magnetic anisotropy constant K(u)∼15 M erg/cm(3). The damping constant α, characterizing macroscopic spin relaxation and being a key factor in spin-transfer-torque systems, is not larger than 0.008 (0.015) for the δ=1.46 (0.88) film. Those are about one-tenth of α values for known materials with large K(u). First-principles calculations well describe both low α and large K(u) for these alloys.

Low damping constant for Co2FeAl Heusler alloy films and its correlation with density of states

Abstract: Gilbert damping for the epitaxial Co2FeAl Heusler alloy films was investigated. Gilbert damping constant for the films was evaluated by analyzing the data of ferromagnetic resonance measured at the frequency of 2–20 GHz. Gilbert damping constant for the film without annealing was rather large, while it decreased remarkably with postannealing. Gilbert damping constant for the film annealed at 600 °C was ≃0.001. These behavior of Gilbert damping constant can be well explained by the fact that the density of states calculated from first principles decreases with increasing the degree of B2 order.

Lower-current and fast switching of a perpendicular TMR for high speed and high density spin-transfer-torque MRAM

Abstract: We investigate extremely low programming current and fast switching time of a perpendicular tunnel-magnetoresistance (P-TMR) for spin-transfer torque using a P-TMR cell of 50 nm-diameter. A L10-crystalline ordered alloy is used as a free layer that has excellent thermal stability and a damping constant of about 0.03. The programming current of 49 uA and the switching time of 4 nsec are also demonstrated.

Large tunnel magnetoresistance in magnetic tunnel junctions using a Co2MnSi Heusler alloy electrode and a MgO barrier

Abstract: A large tunnel magnetoresistance (TMR) ratio of 753% has been observed at 2 K in a magnetic tunnel junction (MTJ) using a Co2MnSi Heusler alloy electrode and a crystalline MgO tunnel barrier. This TMR ratio is the largest reported to date in MTJs using a Heusler alloy electrode. Moreover, we have observed a large TMR ratio of 217% at room temperature (RT). This TMR at RT is much larger than that of MTJs using an amorphous Al-oxide tunnel barrier. However, the temperature dependence of the TMR ratio is still large because of inelastic tunneling in the antiparallel magnetic configuration.

Spin-torque switching with the giant spin hall effect of tantalum

Abstract: Spin currents can apply useful torques in spintronic devices. The spin Hall effect has been proposed as a source of spin current, but its modest strength has limited its usefulness. We report a giant spin Hall effect (SHE) in β-tantalum that generates spin currents intense enough to induce efficient spin-torque switching of ferromagnets at room temperature. We quantify this SHE by three independent methods and demonstrate spin-torque switching of both out-of-plane and in-plane magnetized layers. We furthermore implement a three-terminal device that uses current passing through a tantalum-ferromagnet bilayer to switch a nanomagnet, with a magnetic tunnel junction for read-out. This simple, reliable, and efficient design may eliminate the main obstacles to the development of magnetic memory and nonvolatile spin logic technologies.

A perpendicular-anisotropy CoFeB–MgO magnetic tunnel junction

Abstract: Magnetic tunnel junctions (MTJs) with ferromagnetic electrodes possessing a perpendicular magnetic easy axis are of great interest as they have a potential for realizing next-generation high-density non-volatile memory and logic chips with high thermal stability and low critical current for current-induced magnetization switching. To attain perpendicular anisotropy, a number of material systems have been explored as electrodes, which include rare-earth/transition-metal alloys, L1(0)-ordered (Co, Fe)-Pt alloys and Co/(Pd, Pt) multilayers. However, none of them so far satisfy high thermal stability at reduced dimension, low-current current-induced magnetization switching and high tunnel magnetoresistance ratio all at the same time. Here, we use interfacial perpendicular anisotropy between the ferromagnetic electrodes and the tunnel barrier of the MTJ by employing the material combination of CoFeB-MgO, a system widely adopted to produce a giant tunnel magnetoresistance ratio in MTJs with in-plane anisotropy. This approach requires no material other than those used in conventional in-plane-anisotropy MTJs. The perpendicular MTJs consisting of Ta/CoFeB/MgO/CoFeB/Ta show a high tunnel magnetoresistance ratio, over 120%, high thermal stability at dimension as low as 40 nm diameter and a low switching current of 49 microA.

Current-driven dynamics of chiral ferromagnetic domain walls

Abstract: In most ferromagnets the magnetization rotates from one domain to the next with no preferred handedness. However, broken inversion symmetry can lift the chiral degeneracy, leading to topologically rich spin textures such as spin spirals and skyrmions through the Dzyaloshinskii-Moriya interaction (DMI). Here we show that in ultrathin metallic ferromagnets sandwiched between a heavy metal and an oxide, the DMI stabilizes chiral domain walls (DWs) whose spin texture enables extremely efficient current-driven motion. We show that spin torque from the spin Hall effect drives DWs in opposite directions in Pt/CoFe/MgO and Ta/CoFe/MgO, which can be explained only if the DWs assume a Neel configuration with left-handed chirality. We directly confirm the DW chirality and rigidity by examining current-driven DW dynamics with magnetic fields applied perpendicular and parallel to the spin spiral. This work resolves the origin of controversial experimental results and highlights a new path towards interfacial design of spintronic devices.

Current-induced switching of perpendicularly magnetized magnetic layers using spin torque from the spin Hall effect.

Abstract: We show that in a perpendicularly magnetized Pt/Co bilayer the spin-Hall effect (SHE) in Pt can produce a spin torque strong enough to efficiently rotate and switch the Co magnetization. We calculate the phase diagram of switching driven by this torque, finding quantitative agreement with experiments. When optimized, the SHE torque can enable memory and logic devices with similar critical currents and improved reliability compared to conventional spin-torque switching. We suggest that the SHE torque also affects current-driven magnetic domain wall motion in Pt/ferromagnet bilayers.