N. Matuda

Bio: N. Matuda is an academic researcher from University of Tokyo. The author has contributed to research in topics: Young's modulus & Boron. The author has an hindex of 6, co-authored 7 publications receiving 205 citations.

Thin Film Materials: Stress, Defect Formation and Surface Evolution

Abstract: 1. Introduction and overview 2. Film stress and substrate curvature 3. Stress in anisotropic and patterned films 4. Delamination and fracture 5. Film buckling, bulging and peeling 6. Dislocation formation in epitaxial systems 7. Dislocation interactions and strain relaxation 8. Equilibrium and stability of surfaces 9. The role of stress in mass transport.

Intrinsic stress in sputter-deposited thin films

Abstract: A review of the sputtered film stress literature shows that the intrinsic stress can be tensile or compressive depending on the energetics of the deposition process. Modeling studies of film growth and extensive experimental evidence show a direct link between the energetics of the deposition process and film microstructure, which in turn determines the nature and magnitude of the stress. The fundamental quantities are the particle flux and energy striking the condensing film, which are a function of many process parameters such as pressure (discharge voltage), target/sputtering gas mass ratio, cathode shape, bias voltage, and substrate orientation. Tensile stress is generally observed in zone 1-type, porous films and is explained in terms of the grain boundary relaxation model, whereas compressive stress, observed in zone T-type, dense films, is interpreted in terms of the atomic peening mechanism. Modeling of the atomic peening mechanism and experimental data indicate that the normalized moment...

Mechanical deflection of cantilever microbeams: A new technique for testing the mechanical properties of thin films

Abstract: The mechanical deflection of cantilever microbeams is presented as a new technique for testing the mechanical properties of thin films. Single-layer microbeams of Au and SiO2 have been fabricated using conventional silicon micromachining techniques. Typical thickness, width, and length dimensions of the beams are 1.0,20, and 30 μm, respectively. The beams are mechanically deflected by a Nanoindenter, a submicron indentation instrument that continuously monitors load and deflection. Using simple beam theory and the load-deflection data, the Young’s moduli and the yield strengths of thin-film materials that comprise the beams are determined. The measured mechanical properties are compared to those obtained by indenting similar thin films supported by their substrate.

An intrinsic stress scaling law for polycrystalline thin films prepared by ion beam sputtering

Abstract: The intrinsic stresses of Al, Ti, Fe, Ta, Mo, W, Ge, Si, AlN, TiN, and Si3N4 films prepared by ion beam sputtering were investigated at low Td/Tm values. The intrinsic stress is compressive and its origin is explained in terms of the ion peening model. Knock‐on linear cascade theory of forward sputtering is applied to derive a simple scaling law with the film’s physical properties. The results show that the stress is directly proportional to the elastic energy/mole, given by the quantity Q=EM/(1−ν)D, where E is Young’s modulus, M the atomic mass, D the density, and ν Poisson’s ratio. Stress data taken from the literature for a variety of materials deposited by low‐pressure magnetron sputtering, and rf and ion beam sputtering also fit the correlation with Q. Furthermore, the model predicts a square‐root dependence on the incident ion energy, suggesting that the stress is momentum rather than energy driven.