scispace - formally typeset
Search or ask a question
Author

Nicola Tartoni

Bio: Nicola Tartoni is an academic researcher from Diamond Light Source (United Kingdom). The author has contributed to research in topics: Detector & Semiconductor detector. The author has an hindex of 16, co-authored 75 publications receiving 719 citations.


Papers
More filters
Journal ArticleDOI
TL;DR: In this article, the authors compared the performance of the charge summing mode (CSM) and single pixel mode (SPM) on the Medipix3 photon counting readout chip.
Abstract: Medipix3 is the latest generation of photon counting readout chips of the Medipix family. With the same dimensions as Medipix2 (256 × 256 pixels of 55 μm × 55 μm pitch each), Medipix3 is however implemented in an 8-layer metallization 0.13 μm CMOS technology which leads to an increase in the functionality associated with each pixel over Medipix2. One of the new operational modes implemented in the front-end architecture is the Charge Summing Mode (CSM). This mode consists of a charge reconstruction and hit allocation algorithm which eliminates event-by-event the low energy counts produced by charge-shared events between adjacent pixels. The present work focuses on the study of the CSM mode and compares it to the Single Pixel Mode (SPM) which is the conventional readout method for these kind of detectors and it is also implemented in Medipix3. Tests of a Medipix3 chip bump-bonded to a 300 μm thick silicon photodiode sensor were performed at the Diamond Light Source synchrotron to evaluate the performance of the new Medipix chip. Studies showed that when Medipix3 is operated in CSM mode, it generates a single count per detected event and consequently the charge sharing effect between adjacent pixels is eliminated. However in CSM mode, it was also observed that an incorrect allocation of X-rays counts in the pixels occurred due to an unexpectedly high pixel-to-pixel threshold variation. The present experiment helped to better understand the CSM operating mode and to redesign the Medipix3 to overcome this pixel-to-pixel mismatch.

80 citations

Journal ArticleDOI
TL;DR: The Merlin system as mentioned in this paper is based on a National Instruments PXI/FlexRIO system running a Xilinx Virtex5 FPGA and is capable of recording Medipix3 256 by 256 by 12 bit data frames at over 1 kHz in bursts of 1200 frames and running at over 100 Hz continuously to disk or over a TCP/IP link.
Abstract: This contribution reports on the development of a new high rate readout system for the Medipix3 hybrid pixel ASIC developed by the Detector Group at Diamond Light Source. It details the current functionality of the system and initial results from tests on Diamond's B16 beamline. The Merlin system is based on a National Instruments PXI/FlexRIO system running a Xilinx Virtex5 FPGA. It is capable of recording Medipix3 256 by 256 by 12 bit data frames at over 1 kHz in bursts of 1200 frames and running at over 100 Hz continuously to disk or over a TCP/IP link. It is compatible with the standard Medipix3 single chipboards developed at CERN and is capable of driving them over cable lengths of up to 10 m depending on the data rate required. In addition to a standalone graphical interface, a system of remote TCP/IP control and data transfer has been developed to allow easy integration with third party control systems and scripting languages. Two Merlin systems are being deployed on the B16 and I16 beamlines at Diamond and the system has been integrated with the EPICS/GDA control systems used. Results from trigger synchronisation, fast burst and high rate tests made on B16 in March are reported and demonstrate an encouraging reliability and timing accuracy. In addition to normal high resolution imaging applications of Medipix3, the results indicate the system could profitably be used in `pump and probe' style experiments, where a very accurate, high frame rate is especially beneficial. In addition to these two systems, Merlin is being used by the Detector Group to test the Excalibur 16 chip hybrid modules, and by the LHCb VELO Pixel Upgrade group in their forthcoming testbeams. Additionally the contribution looks forward to further developments and improvements in the system, including full rate quad chip readout capability, multi-FPGA support, long distance optical communication and further functionality enhancements built on the capabilities of the Medipix3 chips.

65 citations

Journal ArticleDOI
TL;DR: In this paper, the performances of various 3D detector structures are simulated with up to 1 × 10 16 ǫ-1 MeV-n eq / cm 2 radiation damage.
Abstract: Future high-luminosity colliders, such as the Super-LHC at CERN, will require pixel detectors capable of withstanding extremely high radiation damage. In this article, the performances of various 3D detector structures are simulated with up to 1 × 10 16 1 MeV- n eq / cm 2 radiation damage. The simulations show that 3D detectors have higher collection efficiency and lower depletion voltages than planar detectors due to their small electrode spacing. When designing a 3D detector with a large pixel size, such as an ATLAS sensor, different electrode column layouts are possible. Using a small number of n + readout electrodes per pixel leads to higher depletion voltages and lower collection efficiency, due to the larger electrode spacing. Conversely, using more electrodes increases both the insensitive volume occupied by the electrode columns and the capacitive noise. Overall, the best performance after 1 × 10 16 1 MeV- n eq / cm 2 damage is achieved by using 4–6 n + electrodes per pixel.

52 citations

Journal ArticleDOI
TL;DR: In this article, the charge-sharing effect when the MEDIPIX3 is operated in charge summing mode compared to the conventional readout mode, referred to as Single Pixel Mode.
Abstract: X-ray photon-counting detectors consisting of a silicon pixel array sensor bump-bonded to a CMOS electronic readout chip offer several advantages over traditional X-ray detection technologies used for synchrotron applications. They offer high frame rate, dynamic range, count rate capability and signal-to-noise ratio. A survey of the requirements for future synchrotron detectors carried out at the Diamond Light Source synchrotron highlighted the needs for detectors with a pixel size of the order of 50?m. Reducing the pixel size leads to an increase of charge-sharing events between adjacent pixels and, therefore, to a degradation of the energy resolution and image quality of the detector. This effect was observed with MEDIPIX2, a photon-counting readout chip with a pixel size of 55?m. The lastest generation of the MEDIPIX family, MEDIPIX3, is designed to overcome this charge-sharing effect in an implemented readout operating mode referred to as Charge Summing Mode. MEDIPIX3 has the same pixel size as MEDIPIX2, but it is implemented in an 8-metal 0.13?m CMOS technology which enables increased functionality per pixel. The present work focuses on the study of the charge-sharing effect when the MEDIPIX3 is operated in Charge Summing Mode compared to the conventional readout mode, referred to as Single Pixel Mode. Tests of a standard silicon photodiode array bump-bonded to MEDIPIX3 were performed in beamline B16 at the Diamond Light Source synchrotron. A monochromatic micro-focused beam of 2.9?m x 2.2?m size at 15keV was used to scan a cluster of nine pixels in order to study the charge collection and X-ray count allocation process for each readout mode, Single Pixel Mode and Charge Summing Mode. The study showed that charge-shared events were eliminated when Medipix3 was operated in Charge Summing Mode.

48 citations

Journal ArticleDOI
TL;DR: In this article, the authors report on progress with Schottky diode and p-i-n diode GaAs detectors for minimum ionising particles and show that the radiation hardness and potential speed of simple diodes is more than competitive with silicon detector.
Abstract: We report on progress with Schottky diode and p-i-n diode GaAs detectors for minimum ionising particles. The radiation hardness and potential speed of simple diodes is shown to be more than competitive with silicon detector. A discussion is given of the present understanding of the charge transport mechanism in the detectors since it influences their charge collection efficiency. Early results from microstrip detectors are also described.

41 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: X-ray microtomographic imaging is a non-destructive technique for quantifying these processes in three dimensions within individual pores, and as reported here, with rapidly increasing spatial and temporal resolution.

968 citations

Journal ArticleDOI
TL;DR: The authors offer the vision for the future ofPCD-CT and PCD-XR with the review of the current status and the prediction of detector technologies, imaging technologies, system technologies, and potential clinical benefits with PCDs.
Abstract: Photon counting detectors (PCDs) with energy discrimination capabilities have been developed for medical x-ray computed tomography (CT) and x-ray (XR) imaging. Using detection mechanisms that are completely different from the current energy integrating detectors and measuring the material information of the object to be imaged, these PCDs have the potential not only to improve the current CT and XR images, such as dose reduction, but also to open revolutionary novel applications such as molecular CT and XR imaging. The performance of PCDs is not flawless, however, and it seems extremely challenging to develop PCDs with close to ideal characteristics. In this paper, the authors offer our vision for the future of PCD-CT and PCD-XR with the review of the current status and the prediction of (1) detector technologies, (2) imaging technologies, (3) system technologies, and (4) potential clinical benefits with PCDs.

778 citations

Journal ArticleDOI
TL;DR: A review of the areas in which ideas from coherent X-ray methods are contributing to methods for the neutron, electron and optical communities is presented in this article, along with associated experiments in materials science.
Abstract: X-ray sources are developing rapidly and their coherent output is growing correspondingly. The increased coherent flux from modern X-ray sources is being matched with an associated development in experimental methods. This article reviews the literature describing the ideas that utilize the increased brilliance from modern X-ray sources. It explores how ideas in coherent X-ray science are leading to developments in other areas, and vice versa. The article describes measurements of coherence properties and uses this discussion as a base from which to describe partially coherent diffraction and X-ray phase-contrast imaging, with applications in materials science, engineering and medicine. Coherent diffraction imaging methods are reviewed along with associated experiments in materials science. Proposals for experiments to be performed with the new X-ray free-electron lasers are briefly discussed. The literature on X-ray photon-correlation spectroscopy is described and the features it has in common with other coherent X-ray methods are identified. Many of the ideas used in the coherent X-ray literature have their origins in the optical and electron communities and these connections are explored. A review of the areas in which ideas from coherent X-ray methods are contributing to methods for the neutron, electron and optical communities is presented.

450 citations

Journal ArticleDOI
TL;DR: In this article, an in situ small and wide-angle X-ray scattering (SAXS/WAXS) study of the mechanisms and kinetics of amorphous calcium carbonate (ACC) crystallization at rapid time scales (seconds) is presented.
Abstract: Many organisms use amorphous calcium carbonate (ACC) during crystalline calcium carbonate biomineralization, as a means to control particle shape/size and phase stability. Here, we present an in situ small- and wide-angle X-ray scattering (SAXS/WAXS) study of the mechanisms and kinetics of ACC crystallization at rapid time scales (seconds). Combined with offline solid and solution characterization, we show that ACC crystallizes to vaterite via a three-stage process. First, hydrated and disordered ACC forms, then rapidly transforms to more ordered and dehydrated ACC; in conjunction with this, vaterite forms via a spherulitic growth mechanism. Second, when the supersaturation of the solution with respect to vaterite decreases sufficiently, the mechanism changes to ACC dissolution and vaterite crystal growth. The third stage is controlled by Ostwald ripening of the vaterite particles. Combining this information with previous studies, allowed us to develop a mechanistic understanding of the abiotic crystalliz...

319 citations

Journal ArticleDOI
TL;DR: A summary of the present status of several compound semiconductor radiation detectors, including detectors fabricated from GaAs, HgI2, CdTe and PbI2 can be found in this paper.
Abstract: A summary is presented of the present status of several compound semiconductor radiation detectors, including detectors fabricated from GaAs, HgI2, CdTe, Cd1−xZnxTe and PbI2

237 citations