scispace - formally typeset
Search or ask a question
Author

Nils E. Erickson

Bio: Nils E. Erickson is an academic researcher from National Institute of Standards and Technology. The author has contributed to research in topics: X-ray photoelectron spectroscopy & Adsorption. The author has an hindex of 9, co-authored 12 publications receiving 546 citations.

Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, the X-ray photoelectron spectroscopy (ESCA) has been used in a study of CO and O2 chemisorbed on polycrystalline tungsten sample.

103 citations

Journal ArticleDOI
TL;DR: In this article, the chemisorption of both CO and O 2 on a clean tungsten ribbon has been studied using an ultrahigh vacuum X-ray photoelectron spectrometer.

90 citations

Journal ArticleDOI
TL;DR: In this paper, X-ray photoelectron spectroscopy has been used in a study of N 2 and NO adsorbed on a polycrystalline tungsten ribbon.

77 citations

Journal ArticleDOI
TL;DR: In this article, the results of a round robin involving kinetic energy (KE) and relative intensity measurements on high-purity samples of copper and gold by Auger-electron spectroscopy were reported.

76 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: In this article, an empirical set has been developed, based upon data from 135 compounds of 62 elements, for which the sensitivity factors are based on intensity ratios of spectral lines with F1s as a primary standard, value unity, and K2p3/2 as a secondary standard.
Abstract: Quantitative information from electron spectroscopy for chemical analysis requires the use of suitable atomic sensitivity factors. An empirical set has been developed, based upon data from 135 compounds of 62 elements. Data upon which the factors are based are intensity ratios of spectral lines with F1s as a primary standard, value unity, and K2p3/2 as a secondary standard. The data were obtained on two instruments, the Physical Electronics 550 and the Varian IEE-15, two instruments that use electron retardation for scanning, with constant pass energy. The agreement in data from the two instruments on the same compounds is good. How closely the data can apply to instruments with input lens systems is not known. Calculated cross-section data plotted against binding energy on a log-log plot provide curves composed of simple linear segments for the strong lines: 1s, 2p3/2, 3d5/2 and 4f7/2. Similarly, the plots for the secondary lines, 2s, 3p3/2, 4d5/2 and 5d5/2, are shown to be composed of linear segments. Theoretical sensitivity factors relative to F1s should fall on similar curves, with minor correction for the combined energy dependence of instrumental transmission and mean free path. Experimental intensity ratios relative to F1s were plotted similarly, and best fit curves were calculated using the shapes of the theoretical curves as a guide. The intercepts of these best fit curves with appropriate binding energies provide sensitivity factors for the strong lines and the secondary lines for all of the elements except the rare earths and the first series of transition metals. For these elements the sensitivity factors are lower than expected, and variable, because of multi-electron processes that vary with chemical state. From the data it can be shown that many of the commonly-accepted calculated cross-section data must be significantly in error—as much as 40% in some cases for the strong lines, and far more than that for some of the secondary lines.

1,817 citations

Journal ArticleDOI
TL;DR: In this paper, the surface chemistry of the nickel-oxygen system using both temperature changes and ion bombardment as techniques for elucidating the surface structure was studied using both X-ray photoelectron lines and the Auger transitions.

737 citations

Journal ArticleDOI
TL;DR: In this article, the effects of extra-atomic relaxation on chemical shifts were examined in order to elucidate the cause of the anomalous chemical shifts for Cd and Ag oxides.
Abstract: The factors which influence chemical shifts are examined in order to elucidate the cause of the anomalous chemical shifts for Cd and Ag oxides. The effects of extra‐atomic relaxation are accounted for using a procedure employing experimental Auger and binding energies. Atomic partial ionic charges for some simple Cd, Ag, and Zn compounds are calculated from experimental binding energies using a model which includes the effects of lattice potentials and extra‐atomic relaxation. Inclusion of extra‐atomic relaxation effects did not have a drastic effect on the relative ionicities computed for these selected compounds. However, for CdO, a large extra‐atomic relaxation energy contribution reduces the binding energy by 0.5 eV more than is predicted from nearest neighbor electronegativity arguments.

693 citations

Journal ArticleDOI
TL;DR: In this paper, an attempt is made to draw correlations between thermal desorption and structural studies of chemisorption on metal surfaces, in particular with relation to the adsorption of hydrogen and carbon monoxide on tungsten.

650 citations

Journal ArticleDOI
TL;DR: A review of core-level binding energy shifts observed in photoelectron spectroscopy can be found in this paper, where the authors focus on shifts since most of the chemical and physical insights provided by core levels are derived not from the core energies themselves but from shifts they exhibit.

588 citations