Olukayode O. Amund

Bio: Olukayode O. Amund is an academic researcher from University of Lagos. The author has contributed to research in topics: Pyrene & Biodegradation. The author has an hindex of 22, co-authored 110 publications receiving 1787 citations. Previous affiliations of Olukayode O. Amund include Elizade University.

Microbial degradation of petroleum hydrocarbons in a polluted tropical stream

Abstract: Crude oil degradation was observed in water samples from three sites along the course of a polluted stream in Lagos, Nigeria. Consistent increase and decrease in the total viable counts (TVCs) of indigenous organisms occurred in the test and control experiments, respectively. Enrichments of the water samples with crude oil resulted in the isolation of nine bacteria belonging to seven genera. A mixed culture was developed from the assemblage of the nine species. The defined microbial consortium utilized a wide range of pure HCs including cycloalkane and aromatic HCs. Utilization of crude oil and petroleum cuts, i.e., kerosene and diesel resulted in an increase in TVC (till day 10) concomitant with decreases in pH and residual oil concentration. Crude oil, diesel and kerosene were degraded by 88, 85 and 78%, respectively, in 14 days. Substrate uptake studies with axenic cultures showed that growth was not sustainable on either cyclohexane or aromatics while degradation of the petroleum fractions fell below 67% in spite of extended incubation period (20 day). From the GC analysis of recovered oil, while reductions in peaks of n-alkane fractions and in biomarkers namely n-C17/pristane and n-C18/phytane ratios were observed in culture fluids of pure strains, complete removal of all the HC components of kerosene, diesel and crude oil including the isoprenoids was obtained with the consortium within 14 days.

Degradation of hydrocarbons and biosurfactant production by Pseudomonas sp. strain LP1

Abstract: Pseudomonas sp. strain LP1, an organism isolated on the basis of its ability to grow on pyrene, was assayed for its degradative and biosurfactant production potentials when growing on crude, diesel and engine oils. The isolate exhibited specific growth rate and doubling time of 0.304 days−1 and 2.28 days, respectively on crude oil (Escravos Light). The corresponding values on diesel were 0.233 days−1 and 2.97 days, while on engine oil, were 0.122 days−1 and 5.71 days. The organism did not show significant biosurfactant production towards crude oil and diesel, but readily produced biosurfactant on engine oil. The highest Emulsification index (E24) value for the biosurfactant produced by LP1 on engine oil was 80.33 ± 1.20, on day 8 of incubation. Biosurfactant production was growth-associated. The surface-active compound which exhibited zero saline tolerance had its optimal activity at 50°C and pH 2.0.

Genotoxicity of Oil Field Wastewater in Nigeria

Abstract: were cultivated in various concentrations of the wastewater, and after 48 h one root tip from each bulb was harvested and processed for cytological studies by the aceto-orcein squash technique. After 96 h, mean lengths of root bundles were obtained and the Effect Concentration (EC) values calculated. Treatment with wastewater resulted in significant dose- dependent root growth inhibition.

Bacteria with dual resistance to elevated concentrations of heavy metals and antibiotics in Nigerian contaminated systems.

Abstract: Samples of soil, water, and sediments from industrial estates in Lagos were collected and analyzed for heavy metals and physicochemical composition. Bacteria that are resistant to elevated concentrations of metals (Cd(2+), Co(2+), Ni(2+), Cr(6+), and Hg(2+)) were isolated from the samples, and they were further screened for antibiotic sensitivity. The minimum tolerance concentrations (MTCs) of the isolates with dual resistance to the metals were determined. The physicochemistry of all the samples indicated were heavily polluted. Twenty-two of the 270 bacterial strains isolated showed dual resistances to antibiotics and heavy metals. The MTCs of isolates to the metals were 14 mM for Cd(2+), 15 mM for Co(2+) and Ni(2+), 17 mM for Cr(6+), and 10 mM for Hg(2+). Five strains (Pseudomonas aeruginosa, Actinomyces turicensis, Acinetobacter junni, Nocardia sp., and Micrococcus sp.) resisted all the 18 antibiotics tested. Whereas Rhodococcus sp. and Micrococcus sp. resisted 15 mM Ni(2+), P. aeruginosa resisted 10 mM Co(2+). To our knowledge, there has not been any report of bacterial strains resisting such high doses of metals coupled with wide range of antibiotics. Therefore, dual expressions of antibiotics and heavy-metal resistance make the isolates, potential seeds for decommissioning of sites polluted with industrial effluents rich in heavy metals, since the bacteria will be able to withstand in situ antibiosis that may prevail in such ecosystems.

Pyrene-degradation potentials of Pseudomonas species isolated from polluted tropical soils

Abstract: Three Pseudomonas species isolated from oil polluted soils in Lagos, Nigeria were studied for their pyrene degradation potentials. These isolates exhibited broad substrate specificities for hydrocarbon substrates including polycyclic aromatic hydrocarbons, petroleum fractions and chlorobenzoates. All three isolates tolerated salt concentrations of more than 3%. They resisted ampi- cillin, cenfuroxime, but susceptible to ofloxacin and ciprofloxacin. Pseudomonas sp. strain LP1 exhibited growth rates and pyrene degradation rates of 0.018 h -1 and 0.111 mg l -1 h -1 respectively, while P. aeruginosa strains LP5 and LP6 had corresponding values of 0.024, 0.082 and 0.017, 0.067 respectively. The overall respective percent- age removal of pyrene obtained for strains LP1, LP5 and LP6 after a 30-day incubation period were 67.79, 66.61 and 47.09. Resting cell assay revealed that strain LP1 had the highest uptake rate. Strains LP1, LP5, and LP6 also used the ortho-cleavage pathway. Enzyme study confirmed activity of catechol 1,2-dioxygenase in all with values 0.6823, 0.9199, and 0.8344 lmol min -1 mg -1 respectively for LP1, LP3 and LP6. To the best of our knowledge, ours is the first report of pyrene-degraders from the sub-Saharan African environment.

Microbial Degradation of Petroleum Hydrocarbon Contaminants: An Overview

Abstract: One of the major environmental problems today is hydrocarbon contamination resulting from the activities related to the petrochemical industry. Accidental releases of petroleum products are of particular concern in the environment. Hydrocarbon components have been known to belong to the family of carcinogens and neurotoxic organic pollutants. Currently accepted disposal methods of incineration or burial insecure landfills can become prohibitively expensive when amounts of contaminants are large. Mechanical and chemical methods generally used to remove hydrocarbons from contaminated sites have limited effectiveness and can be expensive. Bioremediation is the promising technology for the treatment of these contaminated sites since it is cost-effective and will lead to complete mineralization. Bioremediation functions basically on biodegradation, which may refer to complete mineralization of organic contaminants into carbon dioxide, water, inorganic compounds, and cell protein or transformation of complex organic contaminants to other simpler organic compounds by biological agents like microorganisms. Many indigenous microorganisms in water and soil are capable of degrading hydrocarbon contaminants. This paper presents an updated overview of petroleum hydrocarbon degradation by microorganisms under different ecosystems.

Polycyclic Aromatic Hydrocarbons

Abstract: Polycyclic Hydrocarbons Vol. 1. Pp. xxvi + 487. 126S. (With a chapter on carcinogenesis by Regina Schoental.) Vol. 2. Pp. lvii + 487. 140s. By E. Clar. (London and New York: Academic Press; Berlin: Springer-Verlag, 1964.)

Environmental applications of biosurfactants: Recent advances

Abstract: Increasing public awareness of environmental pollution influences the search and development of technologies that help in clean up of organic and inorganic contaminants such as hydrocarbons and metals. An alternative and eco-friendly method of remediation technology of environments contaminated with these pollutants is the use of biosurfactants and biosurfactant-producing microorganisms. The diversity of biosurfactants makes them an attractive group of compounds for potential use in a wide variety of industrial and biotechnological applications. The purpose of this review is to provide a comprehensive overview of advances in the applications of biosurfactants and biosurfactant-producing microorganisms in hydrocarbon and metal remediation technologies.

Allium cepa test in environmental monitoring: a review on its application.

Abstract: Higher plants are recognized as excellent genetic models to detect environmental mutagens and are frequently used in monitoring studies. Among the plant species, Alium cepa has been used to evaluate DNA damages, such as chromosome aberrations and disturbances in the mitotic cycle. Employing the A. cepa as a test system to detect mutagens dates back to the 40s. It has been used to this day to assess a great number of chemical agents, which contributes to its increasing application in environmental monitoring. The A. cepa is characterized as a low cost test. It is easily handled and has advantages over other short-term tests that require previous preparations of tested samples, as well as the addition of exogenous metabolic system. Higher plants, even showing low concentrations of oxidase enzymes and a limitation in the substrate specification in relation to other organism groups, present consistent results that may serve as a warning to other biological systems, since the target is DNA, common to all organisms. The A. cepa test also enables the evaluation of different endpoints. Among the endpoints, chromosome aberrations have been the most used one to detect genotoxicity along the years. The mitotic index and some nuclear abnormalities are used to evaluate citotoxicity and analyze micronucleus to verify mutagenicity of different chemicals. Moreover, the A. cepa test system provides important information to evaluate action mechanisms of an agent about its effects on the genetic material (clastogenic and/or aneugenic effects). In the face of all the advantages that the A. cepa test system offers, it has been widely used to assess the impacts caused by xenobiotics, characterizing an important tool for environmental monitoring studies, where satisfactory results have been reported.