Phyllosilicates, and among them clay minerals, are of great interest not only for the scientific community but also for their potential applications in many novel and advanced areas. However, the correct application of these minerals requires a thorough knowledge of their crystal chemical properties. This chapter provides crystal chemical and structural details related to phyllosilicates and describes the fundamental features leading to their different behaviour in different natural or technical processes, as also detailed in other chapters of this book. Phyllosilicates, described in this chapter, are minerals of the (i) kaolin-serpentine group (e.g. kaolinite, dickite, nacrite, halloysite, hisingerite, lizardite, antigorite, chrysotile, amesite, carlosturanite, greenalite); (ii) talc and pyrophyllite group (e.g. pyrophyllite, ferripyrophyllite); (iii) mica group, with particular focus to illite; (iv) smectite group (e.g. montmorillonite, beidellite, nontronite, saponite, hectorite, sauconite); (v) vermiculite group; (vi) chlorite group; (vii) some 2:1 layer silicates involving a discontinuous octahedral sheet and a modulated tetrahedral sheet such as kalifersite, palygorskite and sepiolite; (viii) allophane and imogolite and (ix) mixed layer structures with particular focus on illite-smectite.

Structure and Mineralogy of Clay Minerals

Structures of Layer Silicates

Publisher Summary This chapter describes structures and mineralogy of clay minerals. Phyllosilicates considered in this chapter ideally contain a continuous tetrahedral sheet. Each tetrahedron consists of a cation, T, coordinated to four oxygen atoms and linked to adjacent tetrahedra by sharing three corners (the basal oxygen atoms, Ob) to form an infinite two-dimensional hexagonal mesh pattern along the a, b crystallographic directions. The free corners (the tetrahedral apical oxygen atoms, Oa) of all tetrahedra point to the same side of the sheet and connect the tetrahedral and octahedral sheets to form a common plane with octahedral anionic position Ooct. Ooct anions lie near to the center of each tetrahedral 6-fold ring, but are not shared with tetrahedra. The 1:1 layer structure consists of the repetition of one tetrahedral and one octahedral sheet, while in the 2:1 layer structure one octahedral sheet is sandwiched between two tetrahedral sheets. In the 1:1 layer structure, the unit cell includes six octahedral sites (i.e., four cis and two trans-oriented octahedral) and four tetrahedral sites. Six octahedral sites and eight tetrahedral sites characterize the 2:1 layer unit cell. Structures with all the six octahedral sites occupied are known as “trioctahedral.” If only four of the six octahedra are occupied, the structure is referred to as “dioctahedral.” The structural formula is often reported based on the half unit-cell content—that is, it is based on three octahedral sites.

Chapter 2 Structures and Mineralogy of Clay Minerals

Miocene of the S.E. United States: A model for chemical sedimentation in a peri-marine environment

Rietveld refinements using synchrotron powder X-ray diffraction data were used to study the crystal structure and dehydration behavior of pure monoclinic palygorskite samples from Korea and Alaska. The 300 and 100 K palygorskite structures in air compare well with previous models but provide additional details about zeolitic H2O sites and reveal that the Al atoms are ordered into the inner M2 octahedral sites and the Mg cations into the M3 sites at the edges of the tunnels. Real-time, temperature-resolved synchrotron powder X-ray diffraction data and Rietveld refinements were used to investigate the monoclinic palygorskite structure from 300 to 1400 K (in air). Rietveld refinements showed that most of the zeolitic H2O is lost by 425 K, accompanied by a decrease in the unit-cell volume of 1.3%, primarily owing to a decrease in the a unit-cell parameter and an increase in the ? angle. The structurally bound H2O is lost in two stages, at temperature intervals of 475-540 and 580-725 K. Above 825 K in air a portion of the Korean sample transformed to a folded structure; the Alaskan sample folded at 575 K under vacuum. A structure model was refined for the folded structure. At 1015 K for the samplemore » heated in air, ?-quartz diffraction peaks appeared and increased in intensity as heating continued to the maximum temperature. Cristobalite formed above 1050 K, along with a small amount of clinoenstatite, and both phases persisted to the maximum temperature studied.« less

/pdf/synchrotron-powder-x-ray-diffraction-study-of-the-structure-2390fckqt8.pdf

P. B. Hostetler

Papers

Palygorskite: New X-Ray data