P.H. Moose

Bio: P.H. Moose is an academic researcher from Naval Postgraduate School. The author has contributed to research in topics: Frequency modulation & Interference (wave propagation). The author has an hindex of 1, co-authored 1 publications receiving 2418 citations.

A technique for orthogonal frequency division multiplexing frequency offset correction

Abstract: This paper discusses the effects of frequency offset on the performance of orthogonal frequency division multiplexing (OFDM) digital communications. The main problem with frequency offset is that it introduces interference among the multiplicity of carriers in the OFDM signal. It is shown, and confirmed by simulation, that to maintain signal-to-interference ratios of 20 dB or greater for the OFDM carriers, offset is limited to 4% or less of the intercarrier spacing. Next, the paper describes a technique to estimate frequency offset using a repeated data symbol. A maximum likelihood estimation (MLE) algorithm is derived and its performance computed and compared with simulation results. Since the intercarrier interference energy and signal energy both contribute coherently to the estimate, the algorithm generates extremely accurate estimates even when the offset is far too great to demodulate the data values. Also, the estimation error depends only on total symbol energy so it is insensitive to channel spreading and frequency selective fading. A strategy is described for initial acquisition in the event of uncertainty in the initial offset that exceeds 1/2 the carrier spacing, the limit of the MLE algorithm. >

Robust frequency and timing synchronization for OFDM

Abstract: A rapid synchronization method is presented for an orthogonal frequency-division multiplexing (OFDM) system using either a continuous transmission or a burst operation over a frequency-selective channel. The presence of a signal can be detected upon the receipt of just one training sequence of two symbols. The start of the frame and the beginning of the symbol can be found, and carrier frequency offsets of many subchannels spacings can be corrected. The algorithms operate near the Cramer-Rao lower bound for the variance of the frequency offset estimate, and the inherent averaging over many subcarriers allows acquisition at very low signal-to-noise ratios (SNRs).

ML estimation of time and frequency offset in OFDM systems

Abstract: We present the joint maximum likelihood (ML) symbol-time and carrier-frequency offset estimator in orthogonal frequency-division multiplexing (OFDM) systems. Redundant information contained within the cyclic prefix enables this estimation without additional pilots. Simulations show that the frequency estimator may be used in a tracking mode and the time estimator in an acquisition mode.

OFDM and Its Wireless Applications: A Survey

Abstract: Orthogonal frequency-division multiplexing (OFDM) effectively mitigates intersymbol interference (ISI) caused by the delay spread of wireless channels. Therefore, it has been used in many wireless systems and adopted by various standards. In this paper, we present a comprehensive survey on OFDM for wireless communications. We address basic OFDM and related modulations, as well as techniques to improve the performance of OFDM for wireless communications, including channel estimation and signal detection, time- and frequency-offset estimation and correction, peak-to-average power ratio reduction, and multiple-input-multiple-output (MIMO) techniques. We also describe the applications of OFDM in current systems and standards.

Optimum receiver design for wireless broad-band systems using OFDM. I

Abstract: Orthogonal frequency-division multiplexing (OFDM) is the technique of choice in digital broad-band applications that must cope with highly dispersive transmission media at low receiver implementation cost. In this paper, we focus on the inner OFDM receiver and its functions necessary to demodulate the received signal and deliver soft information to the outer receiver for decoding. The effects of relevant nonideal transmission conditions are thoroughly analyzed: imperfect channel estimation, symbol frame offset, carrier and sampling clock frequency offset, time-selective fading, and critical analog components. Through an appropriate optimization criterion (signal-to-noise ratio loss), minimum requirements on each receiver synchronization function are systematically derived. An equivalent signal model encompassing the effects of all relevant imperfections is then formulated in a generalized framework. The paper concludes with an outline of synchronization strategies.

Multi-Carrier and Spread Spectrum Systems

Abstract: From the Publisher: Frequency spectrum is a limited and valuable resource for wireless communications. A good example can be observed among network operators in Europe for the prices to pay for UMTS-frequency bands. Therefore, the first goal when designing future wireless communication systems (e.g. 4G - fourth generation) has to be the increase in spectral efficiency. The development in digital communications in the past years has enabled efficient modulation and coding techniques for robust and spectral efficient data, speech, audio and video transmission. These are the multi-carrier modulation (e.g. OFDM) and the spread spectrum technique (e.g. DS-CDMA), where OFDM was chosen for broadcast applications (DVB, DAB) as well as for broadband wireless indoor standards (ETSI HIPERLAN-II, IEEE-802.11) and the DS-CDMA was selected in mobile communications (IS-95, third generation mobile radio systems world wide, UMTS/IMT 2000). Since 1993 various combinations of multi-carrier (MC) modulation and the spread spectrum (SS) technique have been introduced and the field of MC-SS communications has become an independent and important research topic with increasing activities. New application fields have been proposed such as high rate cellular mobile, high rate wireless indoor and LMDS. It has been shown that MC-SS offers the high spectral efficiency, robustness and flexibility that is required for the next generation systems. Meanwhile, different alternative hybrid schemes such as OFDM/OFDMA, MC-TDMA, etc. have been deeply analysed and adopted in different international standards (ETSI-BRAN, IEEE-802 & MMAC). Multi-Carrier & Spread-Spectrum: Analysis of Hybrid Air Interfaces draws together all ofthe above mentioned hybrid schemes therefore providing a greatly needed resource for system engineers, telecommunication designers and researchers in order to enable them to develop, build and deploy several schemes based on MC-transmission for the next generation systems (which will be an integration of broadband multimedia services covering both 4G mobile and fixed wireless systems). Offers a complete treatment of multi-carrier, spread-spectrum (SS) and time division multiplexing (TDM) techniquesProvides an in-depth insight into hybrid multiple access techniques based on multi-carrier (MC) transmissionPresents numerous hybrid multiple access and air interface architectures including OFDM/CDMA, MC-CDMA, MC-DS-CDMA and MT-CDMACovers new techniques such as space-time coding and software radio Telecommunications engineers, hardware & software system designers and researchers as well as students, lecturers and technicians will all find this an invaluable addition to their bookshelf.