Wall-bounded turbulent flows at high Reynolds numbers have become an increasingly active area of research in recent years. Many challenges remain in theory, scaling, physical understanding, experimental techniques, and numerical simulations. In this paper we distill the salient advances of recent origin, particularly those that challenge textbook orthodoxy. Some of the outstanding questions, such as the extent of the logarithmic overlap layer, the universality or otherwise of the principal model parameters such as the von Karman “constant,” the parametrization of roughness effects, and the scaling of mean flow and Reynolds stresses, are highlighted. Research avenues that may provide answers to these questions, notably the improvement of measuring techniques and the construction of new facilities, are identified. We also highlight aspects where differences of opinion persist, with the expectation that this discussion might mark the beginning of their resolution.

/pdf/wall-bounded-turbulent-flows-at-high-reynolds-numbers-recent-ogu7wzlf0n.pdf

Wall-bounded turbulent flows at high Reynolds numbers: Recent advances and key issues

Modern developments in shear-stress measurement ☆

Two independent experimental investigations of the behavior of turbulent boundary layers with increasing Reynolds number were recently completed. The experiments were performed in two facilities, the Minimum Turbulence Level (MTL) wind tunnel at Royal Institute of Technology (KTH) and the National Diagnostic Facility (NDF) wind tunnel at Illinois Institute of Technology (IIT). Both experiments utilized oil-film interferometry to obtain an independent measure of the wall-shear stress. A collaborative study by the principals of the two experiments, aimed at understanding the characteristics of the overlap region between the inner and outer parts of the boundary layer, has just been completed. The results are summarized here, utilizing the profiles of the mean velocity, for Reynolds numbers based on the momentum thickness ranging from 2500 to 27 000. Contrary to the conclusions of some earlier publications, careful analysis of the data reveals no significant Reynolds number dependence for the parameters desc...

/pdf/a-note-on-the-overlap-region-in-turbulent-boundary-layers-16nfaex2u4.pdf

A note on the overlap region in turbulent boundary layers

This thesis deals with the problem of high Reynolds number zero pressuregradient turbulent boundary layers in an incompressible flow without any effects of heat-transfer. The zero-pressure gradient turbulent boundary layer is one of the canonical shear flows important in many applications and of large theoretical interest. The investigation was carried out through an experimental study in the MTL wind-tunnel at KTH, where the fluctuating velocity components and the fluctuating wall-shear stress in a turbulent boundary layer were measured using hot-wire and hot-film anemometry. Attempts were made to answer some basic and “classical” questions concerning turbulent boundary boundary layers. The classical two layer theory was confirmed and constant values of the slope of the logarithmic overlap region (i.e. the von Karman constant) and the additive constants were found and estimated to κ = 0.38, B = 4.1 and B1 = 3.6 (δ = δ95). The inner limit of overlap region was found to scale on the viscous length scale (ν/uτ) and was estimated to be y = 200, i.e. considerably further out compared to previous knowledge. The outer limit of the overlap region was found to scale on the outer length scale and was estimated to be y/δ = 0.15. This also means that a universal overlap region only can exist for Reynolds numbers of at least Reθ ≈ 6000. The values of the newly determined limits explain the Reynolds number variation found in some earlier experiments. Measurements of the fluctuating wall-shear stress using the hot-wire-onthe-wall technique and a MEMS hot-film sensor show that the turbulence intensity τr.m.s./τw is close to 0.41 at Reθ ≈ 9800. A numerical and experimental investigation of the behavior of double wire probes were carried out and showed that the Peclet number based on wire separation should be larger than about 50 to ensure an acceptably low level of thermal interaction. Results are presented for two-point correlations between the wall-shear stress and the streamwise velocity component for separations in both the wallnormal-streamwise plane and the wall-normal-spanwise plane. Turbulence producing events are further investigated using conditional averaging of isolated shear-layer events. Comparisons are made with results from other experiments and numerical simulations. Descriptors: Fluid mechanics, turbulence, boundary layers, high Reynolds number, zero-pressure gradient, hot-wire, hot-film anemometry, oil-film interferometry, structures, streak spacing, micro-electro-mechanical-systems.

/pdf/experimental-studies-of-zero-pressure-gradient-turbulent-1k4hgn3qhc.pdf

Experimental studies of zero pressure-gradient turbulent boundary layer flow

This article is concerned with the mean velocity distributions of two-dimensional fully developed turbulent plane-channel flows. To yield reliable information, the authors performed detailed hot-wire measurements for more than 12 Reynolds numbers. The experimental investigations covered a wide range of the Reynolds numbers up to Reτ≈5×103, where Reτ is based on the wall friction velocity and the channel half-height. From the distribution of the mean velocity gradient (dU+/dy+)=f(y+) the entire flow field was analyzed, resulting in a logarithmic region for the mean velocity profile in the inertial sublayer, extending almost up to the center of the channel at higher Reynolds numbers. The analysis of the experimental results yield a value of the von Karman constant, κ, close to 0.37(≈1/e) independent of the Reynolds number and the additive constant B=3.70, which is close to 10/e, i.e., U+=e ln y++10/e=(1/0.37)ln y++3.70.

Evaluating the law of the wall in two-dimensional fully developed turbulent channel flows

This survey covers recent developments and applications of four skin-friction measurement techniques (oil-film interferometry, wall hot wire, surface fence and wall pulsed wire). Comparisons of the techniques with each other and with other methods are presented. Applications in attached and separated fully turbulent boundary layers and in highly accelerated laminar-like flows will be shown to demonstrate the application range and the limits of the various techniques.

https://iopscience.iop.org/article/10.1088/0957-0233/7/10/010/pdf

P M Wagner

Papers

New developments and applications of skin-friction measuring techniques