Patrick Davidson

Bio: Patrick Davidson is an academic researcher from Université Paris-Saclay. The author has contributed to research in topics: Liquid crystal & Phase (matter). The author has an hindex of 45, co-authored 206 publications receiving 7287 citations. Previous affiliations of Patrick Davidson include European Synchrotron Radiation Facility & Pierre-and-Marie-Curie University.

Existence of a Microporous Corona around the Mesopores of Silica-Based SBA-15 Materials Templated by Triblock Copolymers

Abstract: Materials showing long-range two-dimensional hexagonal order (called SBA-15 in the literature) were produced by templating a silica precursor (TEOS) with two Pluronic copolymers, EOxPOyEOx, of nearly the same x/y (0.3) ratio but different y values (x = 18, y = 60 and x = 20, y = 70, respectively). These materials were hydrothermally treated to increase the condensation of silicate species around the Pluronic aggregates and calcined to liberate the hexagonal array of mesopores. All materials, i.e., before and after hydrothermal treatment and calcination, were investigated by X-ray diffraction (XRD), and all calcined samples were further characterized by transmission electron microscopy and N2 sorption experiments. The large number and narrow width of the XRD powder diffraction lines demonstrate the good crystallographic quality of the materials. This allows us to quantitatively exploit the XRD reflection intensities and to show that simple structural models of the silica lattice cannot account for them. Th...

Observation of Nematic Liquid-Crystal Textures in Aqueous Gels of Smectite Clays

Abstract: Aqueous suspensions of two smectite clays, natural bentonite and synthetic laponite B, were prepared at concentrations ranging from 0.01 to 0.1 g/cm3. Viewed at rest between crossed polarizers, con...

Liquid–crystalline aqueous clay suspensions

Abstract: This article demonstrates the occurrence of a true isotropic/nematic transition in colloidal Brownian aqueous suspensions of natural nontronite clay. The liquid–crystalline character is further evidenced by polarized light microscopy and small-angle x-ray scattering experiments in the presence and absence of modest external magnetic fields. The complete phase diagram ionic strength/volume fraction then exhibits a clear biphasic domain in the sol region just before the gel transition in contrast with the situation observed for other swelling clays in which the sol/gel transition hinders the isotropic/nematic transition. Small-angle x-ray scattering measurements of gel samples reveal strong positional and orientational orders of the particles, proving unambiguously the nematic character of the gel and, thus, clearly refuting the still prevalent “house of cards” model, which explains the gel structure by means of attractive interactions between clay platelets. Such order also is observed in various other swelling clay minerals; therefore, this very general behavior must be taken into account to reach a better understanding of the rheological properties and phase behavior of these systems.

Swollen liquid-crystalline lamellar phase based on extended solid-like sheets

Abstract: Ordering particles at the nanometre length scale is a challenging and active research area in materials science. Several approaches have so far been developed, ranging from the manipulation of individual particles to the exploitation of self-assembly in colloids. Nanometre-scale ordering is well known to appear spontaneously when anisotropic organic moieties form liquid-crystalline phases; this behaviour is also observed for anisotropic mineral nanoparticles resulting in the formation of nematic, smectic and hexagonal mesophases. Here we describe a lyotropic liquid-crystalline lamellar phase comprising an aqueous dispersion of planar solid-like sheets in which all the atoms involved in a layer are covalently bonded. The spacing of these phosphatoantimonate single layers can be increased 100-fold, resulting in one-dimensional structures whose periodicity can be tuned from 1.5 to 225 nanometres. These highly organized materials can be mechanically or magnetically aligned over large pH and temperature ranges, and this property can be used to measure residual dipolar couplings for the structure determination of biomolecules by liquid-state NMR. We also expect that our approach will result in the discovery of other classes of mineral lyotropic lamellar phases.

Lithium Batteries and Cathode Materials

Abstract: In the previous paper Ralph Brodd and Martin Winter described the different kinds of batteries and fuel cells. In this paper I will describe lithium batteries in more detail, building an overall foundation for the papers that follow which describe specific components in some depth and usually with an emphasis on the materials behavior. The lithium battery industry is undergoing rapid expansion, now representing the largest segment of the portable battery industry and dominating the computer, cell phone, and camera power source industry. However, the present secondary batteries use expensive components, which are not in sufficient supply to allow the industry to grow at the same rate in the next decade. Moreover, the safety of the system is questionable for the large-scale batteries needed for hybrid electric vehicles (HEV). Another battery need is for a high-power system that can be used for power tools, where only the environmentally hazardous Ni/ Cd battery presently meets the requirements. A battery is a transducer that converts chemical energy into electrical energy and vice versa. It contains an anode, a cathode, and an electrolyte. The anode, in the case of a lithium battery, is the source of lithium ions. The cathode is the sink for the lithium ions and is chosen to optimize a number of parameters, discussed below. The electrolyte provides for the separation of ionic transport and electronic transport, and in a perfect battery the lithium ion transport number will be unity in the electrolyte. The cell potential is determined by the difference between the chemical potential of the lithium in the anode and cathode, ∆G ) -EF. As noted above, the lithium ions flow through the electrolyte whereas the electrons generated from the reaction, Li ) Li+ + e-, go through the external circuit to do work. Thus, the electrode system must allow for the flow of both lithium ions and electrons. That is, it must be both a good ionic conductor and an electronic conductor. As discussed below, many electrochemically active materials are not good electronic conductors, so it is necessary to add an electronically conductive material such as carbon * To whom correspondence should be addressed. Phone and fax: (607) 777-4623. E-mail: stanwhit@binghamton.edu. 4271 Chem. Rev. 2004, 104, 4271−4301

Shape‐Controlled Synthesis of Metal Nanocrystals: Simple Chemistry Meets Complex Physics?

Abstract: Nanocrystals are fundamental to modern science and technology. Mastery over the shape of a nanocrystal enables control of its properties and enhancement of its usefulness for a given application. Our aim is to present a comprehensive review of current research activities that center on the shape-controlled synthesis of metal nanocrystals. We begin with a brief introduction to nucleation and growth within the context of metal nanocrystal synthesis, followed by a discussion of the possible shapes that a metal nanocrystal might take under different conditions. We then focus on a variety of experimental parameters that have been explored to manipulate the nucleation and growth of metal nanocrystals in solution-phase syntheses in an effort to generate specific shapes. We then elaborate on these approaches by selecting examples in which there is already reasonable understanding for the observed shape control or at least the protocols have proven to be reproducible and controllable. Finally, we highlight a number of applications that have been enabled and/or enhanced by the shape-controlled synthesis of metal nanocrystals. We conclude this article with personal perspectives on the directions toward which future research in this field might take.

Recent advances in the liquid-phase syntheses of inorganic nanoparticles.

Abstract: The development of novel materials is a fundamental focal point of chemical research; and this interest is mandated by advancements in all areas of industry and technology. A good example of the synergism between scientific discovery and technological development is the electronics industry, where discoveries of new semiconducting materials resulted in the evolution from vacuum tubes to diodes and transistors, and eventually to miniature chips. The progression of this technology led to the development * To whom correspondence should be addressed. B.L.C.: (504) 2801385 (phone); (504) 280-3185 (fax); bcushing@uno.edu (e-mail). C.J.O.: (504)280-6846(phone);(504)280-3185(fax);coconnor@uno.edu (e-mail). 3893 Chem. Rev. 2004, 104, 3893−3946

Polymersomes: tough vesicles made from diblock copolymers.

Abstract: Vesicles were made from amphiphilic diblock copolymers and characterized by micromanipulation. The average molecular weight of the specific polymer studied, polyethyleneoxide-polyethylethylene (EO40-EE37), is several times greater than that of typical phospholipids in natural membranes. Both the membrane bending and area expansion moduli of electroformed polymersomes (polymer-based liposomes) fell within the range of lipid membrane measurements, but the giant polymersomes proved to be almost an order of magnitude tougher and sustained far greater areal strain before rupture. The polymersome membrane was also at least 10 times less permeable to water than common phospholipid bilayers. The results suggest a new class of synthetic thin-shelled capsules based on block copolymer chemistry.