Peter J. Stern

Bio: Peter J. Stern is an academic researcher from University of Cincinnati. The author has contributed to research in topics: Interphalangeal Joint & Arthrodesis. The author has an hindex of 53, co-authored 235 publications receiving 8622 citations. Previous affiliations of Peter J. Stern include Indiana University Health & Bethesda Hospital.

Severe open fractures of the tibia.

Abstract: Sixty-two Type-III open fractures of the tibial shaft are reported on. Eleven were Type IIIA, and three of them had non-union while none were associated with deep infection or required secondary amputation. Forty-two were Type IIIB, and fifteen of them had non-union, twelve were associated with deep infection, and seven required secondary amputation. However, in the twenty-four Type-IIIB fractures that were treated with early restoration of the damaged soft tissue by local flaps or free tissue transfer, the rate of complications was significantly reduced to five non-unions, two deep infections, and two secondary amputations. Unfortunately, of the nine Type-IIIC injuries, seven ultimately required secondary amputation, from two days to sixty-three months after the initial injury, because of pain, sepsis, non-union, or failure of the vascular repair. Only two patients who had a Type-IIIC fracture have avoided amputation to date, and their results were poor.

Complications and range of motion following plate fixation of metacarpal and phalangeal fractures

Abstract: Eighty-two patients with 105 metacarpal and/or phalangeal fractures stabilized with plates were retrospectively reviewed to assess complications and outcomes. Despite stable fixation and early mobilization, major complications were encountered in 36% of fractures, especially with phalangeal and open fractures. Complications included stiffness, nonunion plate prominence, infection, and tendon rupture. Forty-eight of 63 (76%) metacarpal fractures and 44 of 66 (67%) closed fractures had a final range of motion greater than 220 o ; however, only 4 of 37 (11%) phalangeal fractures and 8 of 34 (24%) open fractures achieved this outcome. Despite technical advances in plate design and instrumentation, including lower-profile titanium plates, complications occur commonly with metacarpal and phalangeal fractures, leadig to a high incidence of unsatisfactory results. We do not condemn plate fixation, and attribute many of our unsatisfactory results to the frequent use of plates in open and phalangeal fractures.

Motion-preserving procedures in the treatment of scapholunate advanced collapse wrist: Proximal row carpectomy versus four-corner arthrodesis

Abstract: Seventeen patients were treated with scaphoid excision and four-corner arthrodesis (lunate, capitate, hamate, triquetrum) for scapholunate advanced collapse wrist and followed for a mean of 27 months. Eleven wrists in 10 patients had a proximal row carpectomy for scapholunate advanced collapse wrist and were followed for a mean of 37 months. The total arc of motion averaged 95° in the four-corner arthrodesis patients and 115° in the proximal row carpectomy patients, which was 47% and 64%, respectively, of the range of motion of the opposite wrist. Grip strength averaged 74% of the opposite wrist in the four-corner arthrodesis group and 94% in the proximal row carpectomy group. Three wrists in the four-corner arthrodesis group failed and were successfully converted to a total wrist fusion; two additional patients are awaiting arthrodesis. There were no failures in the proximal row carpectomy group. Proximal row carpectomy showed a high degree of patient satisfaction and is our motion-preserving procedure of choice except in those wrists with advanced capitolunate arthritis.

Treatment of unstable dorsal proximal interphalangeal fracture/dislocations using a hemi-hamate autograft.

Abstract: Purpose: This retrospective study was designed to evaluate the clinical and radiographic results of a hemi-hamate autograft for the treatment of comminuted dorsal proximal interphalangeal (PIP) joint fracture/dislocations. Methods: Thirteen consecutive patients underwent hemi-hamate autograft for the treatment of an unstable dorsal PIP fracture dislocation. The fractured middle phalangeal base was debrided and the defect was replaced using a size-matched portion of the dorsal/distal hamate osteoarticular surface and was secured with miniscrews. The average middle phalangeal volar lip involvement on initial radiographs was 60% (range, 40% to 80%). The average time to surgery was 45 days (range, 2–175 d). Range of motion, stability, and grip strength were measured at a mean follow-up evaluation of 16 months. Radiographs were evaluated for union, graft incorporation, and/or collapse. Subjective data, satisfaction, and return to work were obtained on 12 of the 13 patients at a mean follow-up evaluation of 17 months. Results: The average arc of motion at the PIP joint was 85° (range, 65° to 100°). The distal interphalangeal (DIP) joint average arc of motion was 60° (range, 35° to 80°). Average grip strength was 80% of the uninjured side. Bony union was achieved in all patients. One graft showed ulnar collapse but graft resorption was not noted. Except for 2 patients with recurrent dorsal subluxation there were no complications. The average pain level was 1.3 (as rated on a visual analog scale of 0–10). Eleven of 12 patients were very satisfied with their function and one was somewhat satisfied; one patient was lost to follow-up. Conclusions: When greater than 50% of the volar base of the middle phalanx is fractured in a PIP fracture/dislocation or the joint remains unstable despite a lesser degree of involvement, a hemi-hamate autograft should be considered. This procedure reconstructs the cup-shaped contour of the middle phalangeal articular surface and facilitates a stable, functional arc of motion at the PIP joint. Additionally, in our experience the procedure renders minimal disability and has a low complication rate.

Metacarpophalangeal joint arthroplasty in rheumatoid arthritis. A long-term assessment.

Abstract: Background: The long-term results of silicone metacarpophalangeal arthroplasty in patients with rheumatoid arthritis are uncertain. The purpose of this investigation was to evaluate the subjective, objective, and radiographic outcomes at the time of long-term follow-up. Methods: Patients with rheumatoid arthritis who underwent simultaneous silicone metacarpophalangeal joint arthroplasties of all four fingers by one surgeon were eligible for inclusion in the study. The results of a total of 208 arthroplasties in fifty-two hands of thirty-six patients were evaluated at an average of fourteen years postoperatively. Active metacarpophalangeal joint motion, ulnar drift, and radiographs were assessed. The radiographs were reviewed for changes in bone length, erosions, and implant fractures. The Michigan Hand Outcomes Questionnaire (MHQ) was administered to the patients. Results: The mean arc of motion of the metacarpophalangeal joints improved from 30° preoperatively to 46° immediately after the surgery but decreased to 36° at the time of final follow-up. The mean extension deficit of the metacarpophalangeal joints improved from 57° preoperatively to 11° immediately after the surgery but worsened to 23° at the time of final follow-up. The mean ulnar drift improved from 26° preoperatively to <5° in the immediate postoperative period and then recurred to an average of 16° at the time of final follow-up. Implant fractures were associated with increased ulnar drift (p < 0.001). Bone reaction adjacent to the implant was demonstrated by bone-shortening in most patients and by erosions in 29% of the patients. One hundred and thirty implants (63%) were broken and forty-five (22%) more were deformed at the time of final follow-up. The MHQ score averaged 48 of 100 points. The patients expressed satisfaction with the function of only 38% of the hands, and only 27% of the hands were pain-free at the time of final follow-up. A greater degree of ulnar drift was associated with decreased patient satisfaction and a decreased score for the cosmetic appearance (p ≤ 0.01). Conclusions: The outcome after silicone metacarpophalangeal joint arthroplasty in patients with rheumatoid arthritis worsens with long-term follow-up. Given these findings, the indications for and long-term expectations of silicone metacarpophalangeal arthroplasty must be carefully examined in light of the improvements in the medical management of rheumatoid disease. Level of Evidence: Therapeutic study, Level IV (case series [no, or historical, control group]). See Instructions to Authors for a complete description of levels of evidence.

Burnout and medical errors among American surgeons.

Abstract: Objective:To evaluate the relationship between burnout and perceived major medical errors among American surgeons.Background:Despite efforts to improve patient safety, medical errors by physicians remain a common cause of morbidity and mortality.Methods:Members of the American College of Surgeons we

Recombinant human bone morphogenetic protein-2 for treatment of open tibial fractures a prospective, controlled, randomized study of four hundred and fifty patients

Abstract: Background:The treatment of open fractures of the tibial shaft is often complicated by delayed union and nonunion. The objective of this study was to evaluate the safety and efficacy of the use of recombinant human bone morphogenetic protein-2 (rhBMP-2; dibotermin alfa) to accelerate healing of open

Biomaterials in orthopaedics.

Abstract: At present, strong requirements in orthopaedics are still to be met, both in bone and joint substitution and in the repair and regeneration of bone defects. In this framework, tremendous advances in the biomaterials field have been made in the last 50 years where materials intended for biomedical purposes have evolved through three different generations, namely first generation (bioinert materials), second generation (bioactive and biodegradable materials) and third generation (materials designed to stimulate specific responses at the molecular level). In this review, the evolution of different metals, ceramics and polymers most commonly used in orthopaedic applications is discussed, as well as the different approaches used to fulfil the challenges faced by this medical field.