scispace - formally typeset
Search or ask a question
Author

Petko Vitanov

Bio: Petko Vitanov is an academic researcher from Bulgarian Academy of Sciences. The author has contributed to research in topics: Thin film & Dielectric. The author has an hindex of 15, co-authored 86 publications receiving 1162 citations.
Topics: Thin film, Dielectric, Spin coating, Band gap, Silicon


Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, surface recombination velocities as low as 10 cm/s have been obtained by treated atomic layer deposition (ALD) of Al 2 O 3 layers on p-type CZ silicon wafers.

441 citations

Journal ArticleDOI
TL;DR: In this paper, a uniform Al2O3 films were deposited on silicon substrates by the sol-gel process from stable coating solutions and the technological procedure includes spin coating deposition and investigating the influence of the annealing temperature on the dielectric properties.

81 citations

Journal ArticleDOI
TL;DR: In this paper, direct plasma-enhanced chemical vapor deposited silicon nitride (SiNx) films on low resistivity (1.5 Ω cm) p-type Czochralski silicon substrate surfaces with different textures, to elucidate the influence of microroughness of the substrate surface on the surface-passivating properties of thin SiNx films.
Abstract: In this article, we report on the use of direct plasma-enhanced chemical vapor deposited silicon nitride (SiNx) films deposited at low excitation frequency (440 kHz) on low-resistivity (1.5 Ω cm) p-type Czochralski silicon substrate surfaces with different textures, to elucidate the influence of microroughness of the substrate surface on the surface-passivating properties of thin SiNx films. Whereas flat surfaces get the best passivation from Si-rich SiNx films, the optimum passivation shifts towards stoichiometric nitride as the microroughness increases, which points to the increasing relative importance of a charge-induced field effect. When short high-temperature (firing) treatments are applied upon passivation layer deposition, the process window to yield good surface passivation broadens, although very Si-rich films tend to suffer from blistering.

77 citations

Journal ArticleDOI
TL;DR: The performance improvement of solar cells due to the formation of a porous silicon layer on deep-junction n+/p silicon structures has been investigated in this paper, where the photovoltaic properties of two identical sample groups with and without porous silicon layers are compared.

72 citations

Patent
17 Jun 2004
TL;DR: In this article, a method for dielectric passivating the surface of a solar cell by accumulation of negative fixed charges of a first type at the interface between semiconductor material and a passivating material is presented.
Abstract: The present invention provides a method for dielectric passivating the surface of a solar cell by accumulation of negative fixed charges of a first type at the interface between semiconductor material and a passivating material. According to the invention the passivating material comprises an oxide system, for example a binary oxide system, comprising Al2O3 and at least one metal oxide or metalloid oxide which enhances the tetrahedral structure of Al2O3, for example, an (Al2O3)x(TiO2)1-x alloy. In this way it is possible to combine the desirable properties from at least two different oxides, while eliminating the undesirable properties of each individual material. The oxide system can be deposited onto the semiconductor surface by means of a sol-gel method, comprising the steps of formation of the metal oxide and/or metalloid oxide sol and the aluminum solution and then carefully mixing these together under stirring and ultrasonic treatment. Thin films of the oxide system can then be deposited onto the semiconductor surface by means of spin coating followed by a temperature treatment.

48 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: In this article, the photovoltaic technology, its power generating capability, the different existing light absorbing materials used, its environmental aspect coupled with a variety of its applications have been discussed.
Abstract: Global environmental concerns and the escalating demand for energy, coupled with steady progress in renewable energy technologies, are opening up new opportunities for utilization of renewable energy resources. Solar energy is the most abundant, inexhaustible and clean of all the renewable energy resources till date. The power from sun intercepted by the earth is about 1.8 × 1011 MW, which is many times larger than the present rate of all the energy consumption. Photovoltaic technology is one of the finest ways to harness the solar power. This paper reviews the photovoltaic technology, its power generating capability, the different existing light absorbing materials used, its environmental aspect coupled with a variety of its applications. The different existing performance and reliability evaluation models, sizing and control, grid connection and distribution have also been discussed. © 2011 Published by Elsevier Ltd.

1,524 citations

Journal ArticleDOI
TL;DR: A detailed explanation of the unique properties associated with the one-dimensional nanowire geometry will be presented, and the benefits of these properties for the various applications will be highlighted.
Abstract: Semiconductor nanowires (NWs) have been studied extensively for over two decades for their novel electronic, photonic, thermal, electrochemical and mechanical properties. This comprehensive review article summarizes major advances in the synthesis, characterization, and application of these materials in the past decade. Developments in the understanding of the fundamental principles of "bottom-up" growth mechanisms are presented, with an emphasis on rational control of the morphology, stoichiometry, and crystal structure of the materials. This is followed by a discussion of the application of nanowires in i) electronic, ii) sensor, iii) photonic, iv) thermoelectric, v) photovoltaic, vi) photoelectrochemical, vii) battery, viii) mechanical, and ix) biological applications. Throughout the discussion, a detailed explanation of the unique properties associated with the one-dimensional nanowire geometry will be presented, and the benefits of these properties for the various applications will be highlighted. The review concludes with a brief perspective on future research directions, and remaining barriers which must be overcome for the successful commercial application of these technologies.

789 citations

Journal ArticleDOI
TL;DR: In this article, the authors review the dynamic field of crystalline silicon photovoltaics from a device-engineering perspective and give an up-to-date summary of promising recent pathways for further efficiency improvements and cost reduction employing novel carrierselective passivating contact schemes, as well as tandem multi-junction architectures, in particular those that combine silicon absorbers with organic-inorganic perovskite materials.
Abstract: With a global market share of about 90%, crystalline silicon is by far the most important photovoltaic technology today. This article reviews the dynamic field of crystalline silicon photovoltaics from a device-engineering perspective. First, it discusses key factors responsible for the success of the classic dopant-diffused silicon homojunction solar cell. Next it analyzes two archetypal high-efficiency device architectures – the interdigitated back-contact silicon cell and the silicon heterojunction cell – both of which have demonstrated power conversion efficiencies greater than 25%. Last, it gives an up-to-date summary of promising recent pathways for further efficiency improvements and cost reduction employing novel carrier-selective passivating contact schemes, as well as tandem multi-junction architectures, in particular those that combine silicon absorbers with organic–inorganic perovskite materials.

751 citations

Journal ArticleDOI
TL;DR: In this paper, aluminum oxide (Al2O3) nanolayers synthesized by atomic layer deposition (ALD) have been used for the passivation of p-and n-type crystalline Si (c-Si) surfaces.
Abstract: The reduction in electronic recombination losses by the passivation of silicon surfaces is a critical enabler for high-efficiency solar cells. In 2006, aluminum oxide (Al2O3) nanolayers synthesized by atomic layer deposition (ALD) emerged as a novel solution for the passivation of p- and n-type crystalline Si (c-Si) surfaces. Today, high efficiencies have been realized by the implementation of ultrathin Al2O3 films in laboratory-type and industrial solar cells. This article reviews and summarizes recent work concerning Al2O3 thin films in the context of Si photovoltaics. Topics range from fundamental aspects related to material, interface, and passivation properties to synthesis methods and the implementation of the films in solar cells. Al2O3 uniquely features a combination of field-effect passivation by negative fixed charges, a low interface defect density, an adequate stability during processing, and the ability to use ultrathin films down to a few nanometers in thickness. Although various methods can be used to synthesize Al2O3, this review focuses on ALD—a new technology in the field of c-Si photovoltaics. The authors discuss how the unique features of ALD can be exploited for interface engineering and tailoring the properties of nanolayer surface passivation schemes while also addressing its compatibility with high-throughput manufacturing. The recent progress achieved in the field of surface passivation allows for higher efficiencies of industrial solar cells, which is critical for realizing lower-cost solar electricity in the near future.

684 citations

Journal ArticleDOI
TL;DR: In this article, the authors demonstrate that the surface passivation of Al2O3 can be related to a satisfactory low interface defect density in combination with a strong field-effect passivation induced by a negative fixed charge density.
Abstract: Al2O3 is a versatile high-κ dielectric that has excellent surface passivation properties on crystalline Si (c-Si), which are of vital importance for devices such as light emitting diodes and high-efficiency solar cells. We demonstrate both experimentally and by simulations that the surface passivation can be related to a satisfactory low interface defect density in combination with a strong field-effect passivation induced by a negative fixed charge density Qf of up to 1013 cm−2 present in the Al2O3 film at the interface with the underlying Si substrate. The negative polarity of Qf in Al2O3 is especially beneficial for the passivation of p-type c-Si as the bulk minority carriers are shielded from the c-Si surface. As the level of field-effect passivation is shown to scale with Qf2, the high Qf in Al2O3 tolerates a higher interface defect density on c-Si compared to alternative surface passivation schemes.

518 citations