Piotr Garstecki

Bio: Piotr Garstecki is an academic researcher from Polish Academy of Sciences. The author has contributed to research in topics: Microfluidics & Flow focusing. The author has an hindex of 50, co-authored 195 publications receiving 11801 citations. Previous affiliations of Piotr Garstecki include University of Warsaw & Harvard University.

Formation of droplets and bubbles in a microfluidic T-junction-scaling and mechanism of break-up.

Abstract: This article describes the process of formation of droplets and bubbles in microfluidic T-junction geometries. At low capillary numbers break-up is not dominated by shear stresses: experimental results support the assertion that the dominant contribution to the dynamics of break-up arises from the pressure drop across the emerging droplet or bubble. This pressure drop results from the high resistance to flow of the continuous (carrier) fluid in the thin films that separate the droplet from the walls of the microchannel when the droplet fills almost the entire cross-section of the channel. A simple scaling relation, based on this assertion, predicts the size of droplets and bubbles produced in the T-junctions over a range of rates of flow of the two immiscible phases, the viscosity of the continuous phase, the interfacial tension, and the geometrical dimensions of the device.

Generation of Monodisperse Particles by Using Microfluidics: Control over Size, Shape, and Composition

Abstract: Herein we describe a versatile new strategy for producing monodisperse solid particles with sizes from 20 to 1000 mm. The method involves the formation of monodisperse liquid droplets by using a microfluidic device and shaping the droplets in a microchannel and then solidifying these drops in situ either by polymerizing a liquid monomer or by lowering the temperature of a liquid that sets thermally. This method has the following features: 1) It produces particles with an exceptionally narrow range of sizes. 2) A new level of control over the shapes of the particles is offered. 3) The mechanism for droplet formation allows the use of a wide variety of materials including gels, metals, polymers, and polymers doped with functional additives. 4) The procedure can be scaled up to produce large numbers of particles. A number of methods exist for making inorganic and organic particles with narrow polydispersity. Inorganic colloids are typically prepared by precipitation reactions from organometallic precursors. Polymer colloids with sizes from 20 nm to approximately 1 mm are usually prepared by a variation of emulsion polymerization techniques. Larger beads are accessible through miniemulsion polymerization,

Formation of monodisperse bubbles in a microfluidic flow-focusing device

Abstract: This letter describes a method for generating monodisperse gaseous bubbles in a microfluidic flow-focusing device. The bubbles can be obtained in a range of diameters from 10 to 1000μm. The volume Vb of the bubbles scales with the flow rate q and the viscosity μ of the liquid, and the pressure p of the gas stream as Vb∝p∕qμ. This method allows simultaneous, independent control of the size of the individual bubbles and volume fraction of the dispersed phase. Under appropriate conditions, bubbles self-assemble into highly ordered, flowing lattices. Structures of these lattices can be adjusted dynamically by changing the flow parameters.

Transition from squeezing to dripping in a microfluidic T-shaped junction

Abstract: We describe the results of a numerical investigation of the dynamics of breakup of streams of immiscible fluids in the confined geometry of a microfluidic T-junction. We identify three distinct regimes of formation of droplets: squeezing, dripping and jetting, providing a unifying picture of emulsification processes typical for microfluidic systems. The squeezing mechanism of breakup is particular to microfluidic systems, since the physical confinement of the fluids has pronounced effects on the interfacial dynamics. In this regime, the breakup process is driven chiefly by the buildup of pressure upstream of an emerging droplet and both the dynamics of breakup and the scaling of the sizes of droplets are influenced only very weakly by the value of the capillary number. The dripping regime, while apparently homologous to the unbounded case, is also significantly influenced by the constrained geometry; these effects modify the scaling law for the size of the droplets derived from the balance of interfacial and viscous stresses. Finally, the jetting regime sets in only at very high flow rates, or with low interfacial tension, i.e. higher values of the capillary number, similar to the unbounded case.

Mechanism for flow-rate controlled breakup in confined geometries: a route to monodisperse emulsions.

Abstract: This Letter describes a quasistationary breakup of an immiscible, inviscid fluid at low capillary numbers. The breakup proceeds in a coflowing, viscous liquid, in a confined geometry of a long and narrow orifice. In contrast to the capillary instability in an unbounded fluid, the collapse proceeds through a series of equilibria, each yielding the minimum interfacial energy of the fluid-fluid interface. The process is slow in comparison to typical relaxation speeds of the interface, and it is reversible. Its quasistatic character of collapse forms the basis for controlled, high-throughput generation of monodisperse fluid dispersions.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

The origins and the future of microfluidics

Abstract: The manipulation of fluids in channels with dimensions of tens of micrometres--microfluidics--has emerged as a distinct new field. Microfluidics has the potential to influence subject areas from chemical synthesis and biological analysis to optics and information technology. But the field is still at an early stage of development. Even as the basic science and technological demonstrations develop, other problems must be addressed: choosing and focusing on initial applications, and developing strategies to complete the cycle of development, including commercialization. The solutions to these problems will require imagination and ingenuity.

Microfluidics: Fluid physics at the nanoliter scale

Abstract: Microfabricated integrated circuits revolutionized computation by vastly reducing the space, labor, and time required for calculations. Microfluidic systems hold similar promise for the large-scale automation of chemistry and biology, suggesting the possibility of numerous experiments performed rapidly and in parallel, while consuming little reagent. While it is too early to tell whether such a vision will be realized, significant progress has been achieved, and various applications of significant scientific and practical interest have been developed. Here a review of the physics of small volumes (nanoliters) of fluids is presented, as parametrized by a series of dimensionless numbers expressing the relative importance of various physical phenomena. Specifically, this review explores the Reynolds number Re, addressing inertial effects; the Peclet number Pe, which concerns convective and diffusive transport; the capillary number Ca expressing the importance of interfacial tension; the Deborah, Weissenberg, and elasticity numbers De, Wi, and El, describing elastic effects due to deformable microstructural elements like polymers; the Grashof and Rayleigh numbers Gr and Ra, describing density-driven flows; and the Knudsen number, describing the importance of noncontinuum molecular effects. Furthermore, the long-range nature of viscous flows and the small device dimensions inherent in microfluidics mean that the influence of boundaries is typically significant. A variety of strategies have been developed to manipulate fluids by exploiting boundary effects; among these are electrokinetic effects, acoustic streaming, and fluid-structure interactions. The goal is to describe the physics behind the rich variety of fluid phenomena occurring on the nanoliter scale using simple scaling arguments, with the hopes of developing an intuitive sense for this occasionally counterintuitive world.

Photonic crystals

Abstract: The term photonic crystals appears because of the analogy between electron waves in crystals and the light waves in artificial periodic dielectric structures. During the recent years the investigation of one-, two-and three-dimensional periodic structures has attracted a widespread attention of the world optics community because of great potentiality of such structures in advanced applied optical fields. The interest in periodic structures has been stimulated by the fast development of semiconductor technology that now allows the fabrication of artificial structures, whose period is comparable with the wavelength of light in the visible and infrared ranges.