Qingfeng Dong

Bio: Qingfeng Dong is an academic researcher from Jilin University. The author has contributed to research in topics: Perovskite (structure) & Polymer solar cell. The author has an hindex of 40, co-authored 93 publications receiving 15817 citations. Previous affiliations of Qingfeng Dong include University of Nebraska–Lincoln & Chinese Academy of Sciences.

Electron-hole diffusion lengths > 175 μm in solution-grown CH3NH3PbI3 single crystals

Abstract: Long, balanced electron and hole diffusion lengths greater than 100 nanometers in the polycrystalline organolead trihalide compound CH3NH3PbI3 are critical for highly efficient perovskite solar cells. We found that the diffusion lengths in CH3NH3PbI3 single crystals grown by a solution-growth method can exceed 175 micrometers under 1 sun (100 mW cm(-2)) illumination and exceed 3 millimeters under weak light for both electrons and holes. The internal quantum efficiencies approach 100% in 3-millimeter-thick single-crystal perovskite solar cells under weak light. These long diffusion lengths result from greater carrier mobility, longer lifetime, and much smaller trap densities in the single crystals than in polycrystalline thin films. The long carrier diffusion lengths enabled the use of CH3NH3PbI3 in radiation sensing and energy harvesting through the gammavoltaic effect, with an efficiency of 3.9% measured with an intense cesium-137 source.

Solvent annealing of perovskite-induced crystal growth for photovoltaic-device efficiency enhancement.

Abstract: Solvent-annealing is found to be an effective method to increase the grain size and carrier diffusion lengths of trihalide perovskite materials. The carrier diffusion length of MAPbI3 is increased to over 1 μm. The efficiency remains above 14.5% when the MAPbI3 thickness changes from 250 nm to 1 μm, with the highest efficiency reaching 15.6%.

Giant switchable photovoltaic effect in organometal trihalide perovskite devices

Abstract: Organolead trihalide perovskite (OTP) materials are emerging as naturally abundant materials for low-cost, solution-processed and highly efficient solar cells. Here, we show that, in OTP-based photovoltaic devices with vertical and lateral cell configurations, the photocurrent direction can be switched repeatedly by applying a small electric field of <1 V μm(-1). The switchable photocurrent, generally observed in devices based on ferroelectric materials, reached 20.1 mA cm(-2) under one sun illumination in OTP devices with a vertical architecture, which is four orders of magnitude larger than that measured in other ferroelectric photovoltaic devices. This field-switchable photovoltaic effect can be explained by the formation of reversible p-i-n structures induced by ion drift in the perovskite layer. The demonstration of switchable OTP photovoltaics and electric-field-manipulated doping paves the way for innovative solar cell designs and for the exploitation of OTP materials in electrically and optically readable memristors and circuits.

Efficient, high yield perovskite photovoltaic devices grown by interdiffusion of solution-processed precursor stacking layers

Abstract: We report on an interdiffusion method to fabricate pin-hole free perovskite films using a low temperature (<105 °C) solution process. A high efficiency of 15.4%, with a fill factor of ∼80%, was achieved for the devices under one sun illumination. The interdiffusion method results in high device yield, with an efficiency of above 14.5% for more than 85% of the devices.

Highly narrowband perovskite single-crystal photodetectors enabled by surface-charge recombination

Abstract: Organolead trihalide perovskite is an emerging low-cost, solution-processable material with a tunable bandgap from the violet to near-infrared, which has attracted a great deal of interest for applications in high-performance optoelectronic devices. Here, we present hybrid perovskite single-crystal photodetectors that have a very narrow spectral response with a full-width at half-maximum of <20 nm. The response spectra are continuously tuned from blue to red by changing the halide composition and thus the bandgap of the single crystals synthesized by solution processes. The narrowband photodetection can be explained by the strong surface-charge recombination of the excess carriers close to the crystal surfaces generated by short-wavelength light. The excess carriers generated by below-bandgap excitation locate away from the surfaces and can be much more efficiently collected by the electrodes, assisted by the applied electric field. This provides a new design paradigm for a narrowband photodetector with broad applications where background noise emission needs to be suppressed. Perovskite-based devices typically exhibit broadband spectral responses. Here narrowband (< 20 nm FWHM) response is achieved for a photodetector application.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Electron-hole diffusion lengths > 175 μm in solution-grown CH3NH3PbI3 single crystals

Abstract: Long, balanced electron and hole diffusion lengths greater than 100 nanometers in the polycrystalline organolead trihalide compound CH3NH3PbI3 are critical for highly efficient perovskite solar cells. We found that the diffusion lengths in CH3NH3PbI3 single crystals grown by a solution-growth method can exceed 175 micrometers under 1 sun (100 mW cm(-2)) illumination and exceed 3 millimeters under weak light for both electrons and holes. The internal quantum efficiencies approach 100% in 3-millimeter-thick single-crystal perovskite solar cells under weak light. These long diffusion lengths result from greater carrier mobility, longer lifetime, and much smaller trap densities in the single crystals than in polycrystalline thin films. The long carrier diffusion lengths enabled the use of CH3NH3PbI3 in radiation sensing and energy harvesting through the gammavoltaic effect, with an efficiency of 3.9% measured with an intense cesium-137 source.

Cesium-containing triple cation perovskite solar cells: improved stability, reproducibility and high efficiency

Abstract: Today's best perovskite solar cells use a mixture of formamidinium and methylammonium as the monovalent cations. With the addition of inorganic cesium, the resulting triple cation perovskite compositions are thermally more stable, contain less phase impurities and are less sensitive to processing conditions. This enables more reproducible device performances to reach a stabilized power output of 21.1% and ∼18% after 250 hours under operational conditions. These properties are key for the industrialization of perovskite photovoltaics.