(First edition: 1998, this reprint: 2004). This publication presents an updated procedure for calculating reference and crop evapotranspiration from meteorological data and crop coefficients. The procedure, first presented in FAO Irrigation and Drainage Paper No. 24, Crop water requirements, in 1977, allows estimation of the amount of water used by a crop, taking into account the effect of the climate and the crop characteristics. The publication incorporates advances in research and more accurate procedures for determining crop water use as recommended by a panel of high-level experts organised by FAO in May 1990. The first part of the guidelines includes procedures for determining reference crop evapotranspiration according to the FAO Penman-Monteith method. These are followed by updated procedures for estimating the evapotranspiration of different crops for different growth stages and ecological conditions.

Crop evapotranspiration : guidelines for computing crop water requirements

A conceptual, continuous time model called SWAT (Soil and Water Assessment Tool) was developed to assist water resource managers in assessing the impact of management on water supplies and nonpoint source pollution in watersheds and large river basins. The model is currently being utilized in several large area projects by EPA, NOAA, NRCS and others to estimate the off-site impacts of climate and management on water use, nonpoint source loadings, and pesticide contamination. Model development, operation, limitations, and assumptions are discussed and components of the model are described. In Part II, a GIS input/output interface is presented along with model validation on three basins within the Upper Trinity basin in Texas.

Large Area Hydrologic Modeling and Assessment Part i: Model Development

Boundary Layer Climates.

The energetic basis of the urban heat island

http://abe.ufl.edu/Faculty/jjones/ABE_5646/Xtra%20files/The%20DSSAT%20Cropping%20System%20Model.pdf

The DSSAT cropping system model

In an introductory review it is reemphasized that the large-scale parameterization of the surface fluxes of sensible and latent heat is properly expressed in terms of energetic considerations over land while formulas of the bulk aerodynamic type are most suitahle over the sea. A general framework is suggested. Data from a number of saturated land sites and open water sites in the absence of advection suggest a widely applicable formula for the relationship between sensible and latent heat fluxes. For drying land surfaces, we assume that the evaporation rate is given by the same formula for evaporation multiplied by a factor. This factor is found to remain at unity while an amount of water, varying from one site to another, is evaporated. Following this a linear decrease sets in, reducing the evaporation rate to zero after a further 5 cm of evaporation, the same at several sites examined.

R. J. Taylor

Papers

On the Assessment of Surface Heat Flux and Evaporation Using Large-Scale Parameters