Robert H. Austin

Bio: Robert H. Austin is an academic researcher from Princeton University. The author has contributed to research in topics: Population & Cancer. The author has an hindex of 79, co-authored 294 publications receiving 23996 citations. Previous affiliations of Robert H. Austin include Shenzhen University & University of Washington.

Continuous Particle Separation Through Deterministic Lateral Displacement

Abstract: We report on a microfluidic particle-separation device that makes use of the asymmetric bifurcation of laminar flow around obstacles. A particle chooses its path deterministically on the basis of its size. All particles of a given size follow equivalent migration paths, leading to high resolution. The microspheres of 0.8, 0.9, and 1.0 micrometers that were used to characterize the device were sorted in 40 seconds with a resolution of approximately 10 nanometers, which was better than the time and resolution of conventional flow techniques. Bacterial artificial chromosomes could be separated in 10 minutes with a resolution of approximately 12%.

Dynamics of ligand binding to myoglobin

Abstract: Myoglobin rebinding of carbon monoxide and dioxygen after photodissociation has been observed in the temperature range between 40 and 350 K. A system was constructed that records the change in optical absorption at 436 nm smoothly and without break between 2 musec and 1 ksec. Four different rebinding processes have been found. Between 40 and 160 K, a single process is observed. It is not exponential in time, but approximately given by N(t) = (1 + t/to)-n, where to and n are temperature-dependent, ligand-concentration independent, parameters. At about 170 K, a second and at 200 K, a third concentration-independent process emerge. At 210 K, a concentration-dependent process sets in. If myoglobin is embedded in a solid, only the first three can be seen, and they are all nonexponential. In a liquid glycerol-water solvent, rebinding is exponential. To interpret the data, a model is proposed in which the ligand molecule, on its way from the solvent to the binding site at the ferrous heme iron, encounters four barriers in succession. The barriers are tentatively identified with known features of myoglobin. By computer-solving the differential equation for the motion of a ligand molecule over four barriers, the rates for all important steps are obtained. The temperature dependences of the rates yield enthalpy, entropy, and free-energy changes at all barriers. The free-energy barriers at 310 K indicate how myoglobin achieves specificity and order. For carbon monoxide, the heights of these barriers increase toward the inside; carbon monoxide consequently is partially rejected at each of the four barriers. Dioxygen, in contrast, sees barriers of about equal height and moves smoothly toward the binding site. The entropy increases over the first two barriers, indicating a rupturing of bonds or displacement of residues, and then smoothly decreases, reaching a minimum at the binding site. The magnitude of the decrease over the innermost barrier implies participation of heme and/or protein. The nonexponential rebinding observed at low temperatures and in solid samples implies that the innermost barrier has a spectrum of activation energies. The shape of the spectrum has been determined; its existence can be explained by assuming the presence of many conformational states for myoglobin. In a liquid at temperatures above about 230 K, relaxation among conformational states occurs and rebinding becomes exponential.

Hydrodynamic Focusing on a Silicon Chip: Mixing Nanoliters in Microseconds

Abstract: We describe the formation and control of nanoscale, submerged fluid jets. The focusing process necessary to achieve these small length scales is characterized experimentally and theoretically. Fast mixing is one important application of nanoscale fluid control: We demonstrate this with a continuous-flow mixer capable of mix times of less than $10\ensuremath{\mu}\mathrm{s}$ and sample consumption rates of nanoliters per second. This new technique facilitates the study of fast reaction kinetics on time scales unattainable with conventional mixing technology.

Force mapping in epithelial cell migration

Abstract: We measure dynamic traction forces exerted by epithelial cells on a substrate. The force sensor is a high-density array of elastomeric microfabricated pillars that support the cells. Traction forces induced by cell migration are deduced from the measurement of the bending of these pillars and are correlated with actin localization by fluorescence microscopy. We use a multiple-particle tracking method to estimate the mechanical activity of cells in real time with a high-spatial resolution (down to 2 μm) imposed by the periodicity of the post array. For these experiments, we use differentiated Madin-Darby canine kidney (MDCK) epithelial cells. Our data provide definite information on mechanical forces exerted by a cellular assembly. The maximum intensity of the forces is localized on the edge of the epithelia. Hepatocyte growth factor promotes cell motility and induces strong scattering activity of MDCK cells. Thus, we compare forces generated by MDCK cells in subconfluent epithelia versus isolated cells after hepatocyte growth factor treatment. Maximal-traction stresses at the edge of a monolayer correspond to higher values than those measured for a single cell and may be due to a collective behavior.

Deterministic hydrodynamics: Taking blood apart

Abstract: We show the fractionation of whole blood components and isolation of blood plasma with no dilution by using a continuous-flow deterministic array that separates blood components by their hydrodynamic size, independent of their mass. We use the technology we developed of deterministic arrays which separate white blood cells, red blood cells, and platelets from blood plasma at flow velocities of 1,000 μm/sec and volume rates up to 1 μl/min. We verified by flow cytometry that an array using focused injection removed 100% of the lymphocytes and monocytes from the main red blood cell and platelet stream. Using a second design, we demonstrated the separation of blood plasma from the blood cells (white, red, and platelets) with virtually no dilution of the plasma and no cellular contamination of the plasma.

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductors

Abstract: Transparent electronic devices formed on flexible substrates are expected to meet emerging technological demands where silicon-based electronics cannot provide a solution. Examples of active flexible applications include paper displays and wearable computers1. So far, mainly flexible devices based on hydrogenated amorphous silicon (a-Si:H)2,3,4,5 and organic semiconductors2,6,7,8,9,10 have been investigated. However, the performance of these devices has been insufficient for use as transistors in practical computers and current-driven organic light-emitting diode displays. Fabricating high-performance devices is challenging, owing to a trade-off between processing temperature and device performance. Here, we propose to solve this problem by using a novel semiconducting material—namely, a transparent amorphous oxide semiconductor from the In-Ga-Zn-O system (a-IGZO)—for the active channel in transparent thin-film transistors (TTFTs). The a-IGZO is deposited on polyethylene terephthalate at room temperature and exhibits Hall effect mobilities exceeding 10 cm2 V-1 s-1, which is an order of magnitude larger than for hydrogenated amorphous silicon. TTFTs fabricated on polyethylene terephthalate sheets exhibit saturation mobilities of 6–9 cm2 V-1 s-1, and device characteristics are stable during repetitive bending of the TTFT sheet.

Minimal information for studies of extracellular vesicles 2018 (MISEV2018) : a position statement of the International Society for Extracellular Vesicles and update of the MISEV2014 guidelines

Abstract: The last decade has seen a sharp increase in the number of scientific publications describing physiological and pathological functions of extracellular vesicles (EVs), a collective term covering various subtypes of cell-released, membranous structures, called exosomes, microvesicles, microparticles, ectosomes, oncosomes, apoptotic bodies, and many other names. However, specific issues arise when working with these entities, whose size and amount often make them difficult to obtain as relatively pure preparations, and to characterize properly. The International Society for Extracellular Vesicles (ISEV) proposed Minimal Information for Studies of Extracellular Vesicles (“MISEV”) guidelines for the field in 2014. We now update these “MISEV2014” guidelines based on evolution of the collective knowledge in the last four years. An important point to consider is that ascribing a specific function to EVs in general, or to subtypes of EVs, requires reporting of specific information beyond mere description of function in a crude, potentially contaminated, and heterogeneous preparation. For example, claims that exosomes are endowed with exquisite and specific activities remain difficult to support experimentally, given our still limited knowledge of their specific molecular machineries of biogenesis and release, as compared with other biophysically similar EVs. The MISEV2018 guidelines include tables and outlines of suggested protocols and steps to follow to document specific EV-associated functional activities. Finally, a checklist is provided with summaries of key points.

Rapid prototyping of microfluidic systems in poly(dimethylsiloxane)

Abstract: This paper describes a procedure that makes it possible to design and fabricate (including sealing) microfluidic systems in an elastomeric materialpoly(dimethylsiloxane) (PDMS)in less than 24 h. A network of microfluidic channels (with width >20 μm) is designed in a CAD program. This design is converted into a transparency by a high-resolution printer; this transparency is used as a mask in photolithography to create a master in positive relief photoresist. PDMS cast against the master yields a polymeric replica containing a network of channels. The surface of this replica, and that of a flat slab of PDMS, are oxidized in an oxygen plasma. These oxidized surfaces seal tightly and irreversibly when brought into conformal contact. Oxidized PDMS also seals irreversibly to other materials used in microfluidic systems, such as glass, silicon, silicon oxide, and oxidized polystyrene; a number of substrates for devices are, therefore, practical options. Oxidation of the PDMS has the additional advantage that it ...

Reaction-rate theory: fifty years after Kramers

Abstract: The calculation of rate coefficients is a discipline of nonlinear science of importance to much of physics, chemistry, engineering, and biology. Fifty years after Kramers' seminal paper on thermally activated barrier crossing, the authors report, extend, and interpret much of our current understanding relating to theories of noise-activated escape, for which many of the notable contributions are originating from the communities both of physics and of physical chemistry. Theoretical as well as numerical approaches are discussed for single- and many-dimensional metastable systems (including fields) in gases and condensed phases. The role of many-dimensional transition-state theory is contrasted with Kramers' reaction-rate theory for moderate-to-strong friction; the authors emphasize the physical situation and the close connection between unimolecular rate theory and Kramers' work for weakly damped systems. The rate theory accounting for memory friction is presented, together with a unifying theoretical approach which covers the whole regime of weak-to-moderate-to-strong friction on the same basis (turnover theory). The peculiarities of noise-activated escape in a variety of physically different metastable potential configurations is elucidated in terms of the mean-first-passage-time technique. Moreover, the role and the complexity of escape in driven systems exhibiting possibly multiple, metastable stationary nonequilibrium states is identified. At lower temperatures, quantum tunneling effects start to dominate the rate mechanism. The early quantum approaches as well as the latest quantum versions of Kramers' theory are discussed, thereby providing a description of dissipative escape events at all temperatures. In addition, an attempt is made to discuss prominent experimental work as it relates to Kramers' reaction-rate theory and to indicate the most important areas for future research in theory and experiment.