Roger H. Koch

Bio: Roger H. Koch is an academic researcher from IBM. The author has contributed to research in topics: Superconductivity & Josephson effect. The author has an hindex of 48, co-authored 174 publications receiving 8269 citations. Previous affiliations of Roger H. Koch include Chalmers University of Technology.

Critical-current measurements in epitaxial films of YBa2Cu

Abstract: We have grown epitaxial films of the ${\mathrm{YBa}}_{2}$${\mathrm{Cu}}_{3}$${\mathrm{O}}_{7\mathrm{\ensuremath{-}}\mathrm{x}}$ compound on ${\mathrm{SrTiO}}_{3}$ substrates. The superconducting critical current in these films at 77 K is in excess of ${10}^{5}$ A/${\mathrm{cm}}^{2}$ and at 4.2 K in excess of ${10}^{6}$ A/${\mathrm{cm}}^{2}$.

Experimental evidence for vortex-glass superconductivity in Y-Ba-Cu-O.

Abstract: We demonstrate experimentally the existence of a continuous phase transition between a normal and a true superconducting phase (with zero linear resistivity) in epitaxial films of Y-Ba-Cu-O in strong magnetic fields fields, {ital H}{much gt}{ital H}{sub {ital c}1}. The nonlinear {ital I}-{ital V} curves show scaling behavior near the transition and the relevant critical exponents are extracted. These exponents are consistent with values expected for freezing into a superconducting vortex-glass phase.

Time-resolved reversal of spin-transfer switching in a nanomagnet.

Abstract: Time-resolved measurements of spin-transfer-induced (STI) magnetization reversal were made in current-perpendicular spin-valve nanomagnetic junctions subject to a pulsed current bias. These results can be understood within the framework of a Landau-Lifshitz-Gilbert equation that includes STI corrections and a Langevin random field for finite temperature. Comparison of these measurements with model calculations demonstrates that spin-transfer induced excitation is responsible for the observed magnetic reversal in these samples.

Quantum interference devices made from superconducting oxide thin films

Abstract: We have fabricated superconducting quantum interference devices (dc SQUID’s) from thin films of the superconducting oxide YBa2Cu3Oy. The devices were made by first lithographically patterning an ion implant mask containing a 40 by 40 μm loop and two 17‐μm‐wide weak links over a ∼1‐μm‐thick oxide film. Ion implantation was then used to destroy the superconductivity in the film surrounding the device without actually removing material, resulting in a completely planar structure for the SQUID’s. The SQUID’s were operated in the temperature range from 4.2 to 68 K. The superconducting flux quantum was measured to be h/2e in these materials.

Thin superconducting oxide films

Abstract: Studies of superconductivity in thin films of La-Sr-Cu-O and Y-Ba-Cu-O have resulted in samples completely superconducting at 87 K and with onsets as high as 97 K. The high-${T}_{c}$ materials show a strong Meissner effect which agrees with the temperature dependence of the resistance. Critical current densities in excess of 300 A/${\mathrm{cm}}^{2}$ have been measured close to ${T}_{c}$ in the Y-based materials.

Magnetoencephalography—theory, instrumentation, and applications to noninvasive studies of the working human brain

Abstract: Magnetoencephalography (MEG) is a noninvasive technique for investigating neuronal activity in the living human brain. The time resolution of the method is better than 1 ms and the spatial discrimination is, under favorable circumstances, 2-3 mm for sources in the cerebral cortex. In MEG studies, the weak 10 fT-1 pT magnetic fields produced by electric currents flowing in neurons are measured with multichannel SQUID (superconducting quantum interference device) gradiometers. The sites in the cerebral cortex that are activated by a stimulus can be found from the detected magnetic-field distribution, provided that appropriate assumptions about the source render the solution of the inverse problem unique. Many interesting properties of the working human brain can be studied, including spontaneous activity and signal processing following external stimuli. For clinical purposes, determination of the locations of epileptic foci is of interest. The authors begin with a general introduction and a short discussion of the neural basis of MEG. The mathematical theory of the method is then explained in detail, followed by a thorough description of MEG instrumentation, data analysis, and practical construction of multi-SQUID devices. Finally, several MEG experiments performed in the authors' laboratory are described, covering studies of evoked responses and of spontaneous activity in both healthy and diseased brains. Many MEG studies by other groups are discussed briefly as well.

A perpendicular-anisotropy CoFeB–MgO magnetic tunnel junction

Abstract: Magnetic tunnel junctions (MTJs) with ferromagnetic electrodes possessing a perpendicular magnetic easy axis are of great interest as they have a potential for realizing next-generation high-density non-volatile memory and logic chips with high thermal stability and low critical current for current-induced magnetization switching. To attain perpendicular anisotropy, a number of material systems have been explored as electrodes, which include rare-earth/transition-metal alloys, L1(0)-ordered (Co, Fe)-Pt alloys and Co/(Pd, Pt) multilayers. However, none of them so far satisfy high thermal stability at reduced dimension, low-current current-induced magnetization switching and high tunnel magnetoresistance ratio all at the same time. Here, we use interfacial perpendicular anisotropy between the ferromagnetic electrodes and the tunnel barrier of the MTJ by employing the material combination of CoFeB-MgO, a system widely adopted to produce a giant tunnel magnetoresistance ratio in MTJs with in-plane anisotropy. This approach requires no material other than those used in conventional in-plane-anisotropy MTJs. The perpendicular MTJs consisting of Ta/CoFeB/MgO/CoFeB/Ta show a high tunnel magnetoresistance ratio, over 120%, high thermal stability at dimension as low as 40 nm diameter and a low switching current of 49 microA.

The Kuramoto model: A simple paradigm for synchronization phenomena

Abstract: Synchronization phenomena in large populations of interacting elements are the subject of intense research efforts in physical, biological, chemical, and social systems. A successful approach to the problem of synchronization consists of modeling each member of the population as a phase oscillator. In this review, synchronization is analyzed in one of the most representative models of coupled phase oscillators, the Kuramoto model. A rigorous mathematical treatment, specific numerical methods, and many variations and extensions of the original model that have appeared in the last few years are presented. Relevant applications of the model in different contexts are also included.

Perpendicular switching of a single ferromagnetic layer induced by in-plane current injection

Abstract: Modern computing technology is based on writing, storing and retrieving information encoded as magnetic bits. Although the giant magnetoresistance effect has improved the electrical read out of memory elements, magnetic writing remains the object of major research efforts. Despite several reports of methods to reverse the polarity of nanosized magnets by means of local electric fields and currents, the simple reversal of a high-coercivity, single-layer ferromagnet remains a challenge. Materials with large coercivity and perpendicular magnetic anisotropy represent the mainstay of data storage media, owing to their ability to retain a stable magnetization state over long periods of time and their amenability to miniaturization. However, the same anisotropy properties that make a material attractive for storage also make it hard to write to. Here we demonstrate switching of a perpendicularly magnetized cobalt dot driven by in-plane current injection at room temperature. Our device is composed of a thin cobalt layer with strong perpendicular anisotropy and Rashba interaction induced by asymmetric platinum and AlOx interface layers. The effective switching field is orthogonal to the direction of the magnetization and to the Rashba field. The symmetry of the switching field is consistent with the spin accumulation induced by the Rashba interaction and the spin-dependent mobility observed in non-magnetic semiconductors, as well as with the torque induced by the spin Hall effect in the platinum layer. Our measurements indicate that the switching efficiency increases with the magnetic anisotropy of the cobalt layer and the oxidation of the aluminium layer, which is uppermost, suggesting that the Rashba interaction has a key role in the reversal mechanism. To prove the potential of in-plane current switching for spintronic applications, we construct a reprogrammable magnetic switch that can be integrated into non-volatile memory and logic architectures. This device is simple, scalable and compatible with present-day magnetic recording technology.

Microwave oscillations of a nanomagnet driven by a spin-polarized current

Abstract: The recent discovery that a spin-polarized electrical current can apply a large torque to a ferromagnet, through direct transfer of spin angular momentum, offers the possibility of manipulating magnetic-device elements without applying cumbersome magnetic fields. However, a central question remains unresolved: what type of magnetic motions can be generated by this torque? Theory predicts that spin transfer may be able to drive a nanomagnet into types of oscillatory magnetic modes not attainable with magnetic fields alone, but existing measurement techniques have provided only indirect evidence for dynamical states. The nature of the possible motions has not been determined. Here we demonstrate a technique that allows direct electrical measurements of microwave-frequency dynamics in individual nanomagnets, propelled by a d.c. spin-polarized current. We show that spin transfer can produce several different types of magnetic excitation. Although there is no mechanical motion, a simple magnetic-multilayer structure acts like a nanoscale motor; it converts energy from a d.c. electrical current into high-frequency magnetic rotations that might be applied in new devices including microwave sources and resonators.