Single carrier frequency division multiple access (SC FDMA), a modified form of orthogonal FDMA (OFDMA), is a promising technique for high data rate uplink communications in future cellular systems. SC-FDMA has similar throughput performance and essentially the same overall complexity as OFDMA. A principal advantage of SC-FDMA is the peak-to-average power ratio (PARR), which is lower than that of OFDMA. SC FDMA is currently a strong candidate for the uplink multiple access scheme in the long term evolution of cellular systems under consideration by the third generation partnership project (3GPP). In this paper, we give an overview of SC-FDMA. We also analyze the effects of subcarrier mapping on throughput and PARR. Among the possible subcarrier mapping approaches, we find that localized FDMA (LFDMA) with channel-dependent scheduling (CDS) results in higher throughput than interleaved FDMA (JFDMA). However, the PARR performance of IFDMA is better than that of LFDMA. As in other communications systems there are complex tradeoffs between design parameters and performance in an SC-FDMA system

Single carrier FDMA for uplink wireless transmission

Orthogonal frequency-division multiplexing (OFDM) effectively mitigates intersymbol interference (ISI) caused by the delay spread of wireless channels. Therefore, it has been used in many wireless systems and adopted by various standards. In this paper, we present a comprehensive survey on OFDM for wireless communications. We address basic OFDM and related modulations, as well as techniques to improve the performance of OFDM for wireless communications, including channel estimation and signal detection, time- and frequency-offset estimation and correction, peak-to-average power ratio reduction, and multiple-input-multiple-output (MIMO) techniques. We also describe the applications of OFDM in current systems and standards.

OFDM and Its Wireless Applications: A Survey

From the Publisher:
Frequency spectrum is a limited and valuable resource for wireless communications. A good example can be observed among network operators in Europe for the prices to pay for UMTS-frequency bands. Therefore, the first goal when designing future wireless communication systems (e.g. 4G - fourth generation) has to be the increase in spectral efficiency. The development in digital communications in the past years has enabled efficient modulation and coding techniques for robust and spectral efficient data, speech, audio and video transmission. These are the multi-carrier modulation (e.g. OFDM) and the spread spectrum technique (e.g. DS-CDMA), where OFDM was chosen for broadcast applications (DVB, DAB) as well as for broadband wireless indoor standards (ETSI HIPERLAN-II, IEEE-802.11) and the DS-CDMA was selected in mobile communications (IS-95, third generation mobile radio systems world wide, UMTS/IMT 2000).

Since 1993 various combinations of multi-carrier (MC) modulation and the spread spectrum (SS) technique have been introduced and the field of MC-SS communications has become an independent and important research topic with increasing activities. New application fields have been proposed such as high rate cellular mobile, high rate wireless indoor and LMDS. It has been shown that MC-SS offers the high spectral efficiency, robustness and flexibility that is required for the next generation systems. Meanwhile, different alternative hybrid schemes such as OFDM/OFDMA, MC-TDMA, etc. have been deeply analysed and adopted in different international standards (ETSI-BRAN, IEEE-802 & MMAC).
Multi-Carrier & Spread-Spectrum: Analysis of Hybrid Air Interfaces draws together all ofthe above mentioned hybrid schemes therefore providing a greatly needed resource for system engineers, telecommunication designers and researchers in order to enable them to develop, build and deploy several schemes based on MC-transmission for the next generation systems (which will be an integration of broadband multimedia services covering both 4G mobile and fixed wireless systems). 
Offers a complete treatment of multi-carrier, spread-spectrum (SS) and time division multiplexing (TDM) techniquesProvides an in-depth insight into hybrid multiple access techniques based on multi-carrier (MC) transmissionPresents numerous hybrid multiple access and air interface architectures including OFDM/CDMA, MC-CDMA, MC-DS-CDMA and MT-CDMACovers new techniques such as space-time coding and software radio

Telecommunications engineers, hardware & software system designers and researchers as well as students, lecturers and technicians will all find this an invaluable addition to their bookshelf.

/pdf/multi-carrier-and-spread-spectrum-systems-4jp27uw6t7.pdf

Multi-Carrier and Spread Spectrum Systems

Cellular systems of the fourth generation (4G) have been optimized to provide high data rates and reliable coverage to mobile users. Cellular systems of the next generation will face more diverse application requirements: the demand for higher data rates exceeds 4G capabilities; battery-driven communication sensors need ultra-low power consumption; and control applications require very short response times. We envision a unified physical layer waveform, referred to as generalized frequency division multiplexing (GFDM), to address these requirements. In this paper, we analyze the main characteristics of the proposed waveform and highlight relevant features. After introducing the principles of GFDM, this paper contributes to the following areas: 1) the means for engineering the waveform's spectral properties; 2) analytical analysis of symbol error performance over different channel models; 3) concepts for MIMO-GFDM to achieve diversity; 4) preamble-based synchronization that preserves the excellent spectral properties of the waveform; 5) bit error rate performance for channel coded GFDM transmission using iterative receivers; 6) relevant application scenarios and suitable GFDM parameterizations; and 7) GFDM proof-of-concept and implementation aspects of the prototype using hardware platforms available today. In summary, the flexible nature of GFDM makes this waveform a suitable candidate for future 5G networks.

Generalized Frequency Division Multiplexing for 5th Generation Cellular Networks

The millimeter wave (mmWave) frequency band spanning from 30 to 300 GHz constitutes a substantial portion of the unused frequency spectrum, which is an important resource for future wireless communication systems in order to fulfill the escalating capacity demand. Given the improvements in integrated components and enhanced power efficiency at high frequencies, wireless systems can operate in the mmWave frequency band. In this paper, we present a survey of the mmWave propagation characteristics, channel modeling, and design guidelines, such as system and antenna design considerations for mmWave, including the link budget of the network, which are essential for mmWave communication systems. We commence by introducing the main channel propagation characteristics of mmWaves followed by channel modeling and design guidelines. Then, we report on the main measurement and modeling campaigns conducted in order to understand the mmWave band’s properties and present the associated channel models. We survey the different channel models focusing on the channel models available for the 28, 38, 60, and 73 GHz frequency bands. Finally, we present the mmWave channel model and its challenges in the context of mmWave communication systems design.

/pdf/millimeter-wave-communications-physical-channel-models-qh94bqmhc1.pdf

Millimeter-Wave Communications: Physical Channel Models, Design Considerations, Antenna Constructions, and Link-Budget

Broadband wireless access systems deployed in residential and business environments are likely to face hostile radio propagation environments, with multipath delay spread extending over tens or hundreds of bit intervals. Orthogonal frequency-division multiplex (OFDM) is a recognized multicarrier solution to combat the effects of such multipath conditions. This article surveys frequency domain equalization (FDE) applied to single-carrier (SC) modulation solutions. SC radio modems with frequency domain equalization have similar performance, efficiency, and low signal processing complexity advantages as OFDM, and in addition are less sensitive than OFDM to RF impairments such as power amplifier nonlinearities. We discuss similarities and differences of SC and OFDM systems and coexistence possibilities, and present examples of SC-FDE performance capabilities.

/pdf/frequency-domain-equalization-for-single-carrier-broadband-17aswqzbww.pdf

Frequency domain equalization for single-carrier broadband wireless systems

The application of frequency domain equalization techniques makes single carrier modulation a potentially valuable alternative to OFDM, especially in regard to its robustness to RF implementation impairments. In this overview paper we survey recent results on single carrier systems with frequency domain equalization (SC-FDE), including comparisons and compatibilities with OFDM, and extensions via decision feedback equalization and overlap-save processing.

/pdf/broadband-wireless-using-single-carrier-and-frequency-domain-rn8doxc3ri.pdf

S.L. Ariyavisitakul

Papers

Frequency domain equalization for single-carrier broadband wireless systems

Broadband wireless using single carrier and frequency domain equalization