The nondestructive assessment of the damage that occurs in components during service plays a key role for condition monitoring and residual life estimation of in-service components/structures. Ultrasound has been widely utilized for this; however most of these conventional methods using ultrasonic characteristics in the linear elastic region are only sensitive to gross defects but much less sensitive to micro-damage. Recently, the nonlinear ultrasonic technique, which uses nonlinear ultrasonic behavior such as higher-harmonic generation, subharmonic generation, nonlinear resonance, or mixed frequency response, has been studied as a positive method for overcoming this limitation. In this paper, overall progress in this technique is reviewed with the brief introduction of basic principle in the application of each nonlinear ultrasonic phenomenon.

Nonlinear ultrasonic techniques for nondestructive assessment of micro damage in material: A review

This paper presents a comprehensive review of the current state of knowledge of second harmonic generation (SHG) measurements, a subset of nonlinear ultrasonic nondestructive evaluation techniques. These SHG techniques exploit the material nonlinearity of metals in order to measure the acoustic nonlinearity parameter, $$\beta $$
 . In these measurements, a second harmonic wave is generated from a propagating monochromatic elastic wave, due to the anharmonicity of the crystal lattice, as well as the presence of microstructural features such as dislocations and precipitates. This article provides a summary of models that relate the different microstructural contributions to $$\beta $$
 , and provides details of the different SHG measurement and analysis techniques available, focusing on longitudinal and Rayleigh wave methods. The main focus of this paper is a critical review of the literature that utilizes these SHG methods for the nondestructive evaluation of plasticity, fatigue, thermal aging, creep, and radiation damage in metals.

/pdf/review-of-second-harmonic-generation-measurement-techniques-8pdcwltmqt.pdf

Review of Second Harmonic Generation Measurement Techniques for Material State Determination in Metals

Modelling of nonlinear crack–wave interactions for damage detection based on ultrasound—A review

Review of air-coupled ultrasonic materials characterization.

The paper presents an application of nonlinear acoustics for impact damage detection in composite laminates. Two composite plates were analysed. A low-velocity impact was used to damage one of the plates. Ultrasonic C-scan was applied to reveal the extent of barely visible impact damage. Finite element modelling was used to find vibration mode shapes of the plates and to estimate the local defect resonance frequency in the damaged plate. A delamination divergence study was performed to establish excitation parameters for nonlinear acoustics tests used for damage detection. Both composite plates were instrumented with surface-bonded, low-profile piezoceramic transducers that were used for the high-frequency ultrasonic excitation. Both an arbitrary frequency and a frequency corresponding to the local defect resonance were investigated. The low-frequency modal excitation was applied using an electromagnetic shaker. Scanning laser vibrometry was applied to acquire the vibro-acoustic responses from the plates. The study not only demonstrates that nonlinear vibro-acoustic modulations can successfully reveal the barely visible impact damage in composite plates, but also that the entire procedure can be enhanced when the ultrasonic excitation frequency corresponds to the resonant frequency of damage.

S.Yu Vezirov

Papers

Nonlinear modulation technique for NDE with air-coupled ultrasound.