Effect of heat input on the microstructure and mechanical properties of gas tungsten arc welded AISI 304 stainless steel joints

Performance of activated TIG process in austenitic stainless steel welds

Study of the characteristics of duplex stainless steel activated tungsten inert gas welds

The purpose of the present work was to investigate the effect of oxide fluxes on weld morphology, arc voltage, mechanical properties, angular distortion and hot cracking susceptibility obtained with TIG welding, which applied to the welding of 5 mm thick austenitic stainless steel plates. A novel variant of the autogenous TIG welding process, oxide powders (Al2O3, Cr2O3, TiO2, SiO2 and CaO) was applied on a type 304 stainless steel through a thin layer of the flux to produce a bead on plate welds. The experimental results indicated that the increase in the penetration is significant with the use of Cr2O3, TiO2, and SiO2. A-TIG welding can increase the weld depth to bead-width ratio, and tends to reduce the angular distortion of the weldment. It was also found that A-TIG welding can increase the retained delta-ferrite content of stainless steel 304 welds and, in consequence, the hot-cracking susceptibility of as-welded is reduced. Physically constricting the plasma column and reducing the anode spot are the possible mechanism for the effect of certain flux on A-TIG penetration.

/pdf/study-of-the-performance-of-stainless-steel-a-tig-welds-5g3rxw8bej.pdf

Study of the Performance of Stainless Steel A-TIG Welds

Activating flux tungsten inert gas welding for enhanced weld penetration

The aim of the present study was to investigate the effect of specific oxide fluxes on the surface appearance, weld morphology, retained δ ferrite content, hot cracking susceptibility, angular distortion and mechanical properties obtained with the tungsten inert gas (TIG) process applied to the welding of 5 mm thick austenitic stainless steel plates. An autogenous gas tungsten arc welding process was applied to stainless steels through a thin layer of activating flux to produce a bead on plate welded joint. The MnO2 and ZnO fluxes used were packed in powdered form. The experimental results indicated that the 80% MnO2–20% ZnO mixture can give full penetration and also a satisfactory surface appearance for type 304 stainless steel TIG flux welds. TIG welding with MnO2 and/or ZnO can increase the measured ferrite number in welds, and tends to reduce hot cracking susceptibility in as welded structures. It was also found that TIG flux welding can significantly reduce the angular distortion of stainless...

Evaluation of TIG flux welding on the characteristics of stainless steel

A welding flux for use in welding stainless steel parts to increase welding penetration, consisting essentially a base material obtained from manganese peroxide (MnO 2 ), and an activator selected from a material group that includes zinc oxide (ZnO), silicon dioxide (SiO 2 ), chromium oxide (CrO 2 ), titanium dioxide (TiO 2 ), molybdenum dioxide (MoO 2 ), and iron oxide (Fe 2 O 2 ).

https://ir.nctu.edu.tw:443/bitstream/11536/105728/1/20050199317.pdf

Sheang-Wen Shyu

Papers

Study of the Performance of Stainless Steel A-TIG Welds

Evaluation of TIG flux welding on the characteristics of stainless steel

Welding flux for use in arc-welding of stainless steels, method of welding stainless steel members using the welding flux