Shien-Kuei Liaw

Bio: Shien-Kuei Liaw is an academic researcher from National Taiwan University of Science and Technology. The author has contributed to research in topics: Fiber Bragg grating & Wavelength-division multiplexing. The author has an hindex of 20, co-authored 233 publications receiving 1549 citations. Previous affiliations of Shien-Kuei Liaw include National Taiwan University & Dayeh University.

Single-longitudinal-mode fiber laser with a passive multiple-ring cavity and its application for video transmission.

Abstract: A single-longitudinal-mode erbium-doped fiber laser with a passive multiple-ring cavity (MRC) is proposed for the first time to the authors' knowledge. The laser is fundamentally structured by insertion of three different short ring cavities, which serve as mode filters, into the main cavity. When it is combined with a mode-restricting intracavity fiber Bragg grating, the MRC resonator ensures single-longitundinal-mode laser oscillation. The laser can successfully suppress side-mode frequencies of as much as 1 GHz and provide an output power of 23 mW with a side-mode suppression ratio of 51 dB at 1533 nm. The short-term linewidth of the laser output measured is ~2 kHz . The ability of this fiber laser to act as an AM transmitter source is also demonstrated.

C-band continuously tunable lasers using tunable fiber Bragg gratings

Abstract: We report the development of a ring tunable fiber laser based on tunable fiber Bragg gratings (TFBG) integrated with an optical circulator. The TFBG is embedded inside a 3-piont bending device for wavelength tuning. The tunable laser operating in the C-band has power variation, tuning resolution, tuning range and laser line width of ±0.5 dB, 0.5 nm, 25.0 nm and less than 0.05 nm, respectively. As 40 mW of pump power is used, the ring tunable laser has a side mode suppression ratio of 60 dB and a power conversion efficiency of 25%. These specifications ensure the high-quality operation of a tunable laser.

Design and analysis of an angular-segmented full-mobility visible light communications receiver

Abstract: This paper presents the concept, design and analysis for a visible light communications receiver utilising the angular and spatial diversity in order to achieve full mobility and protection from signal blocking in a typical home/office environment. The proposed receiver uses seven sub-receivers, each dedicated to an independent viewing angle and direction. Employing selection combining, the receiver with the strongest signal is used for the communications channel. Full performance evaluation and numerical analysis of the proposed system have been performed in MATLAB and compared to that of a single receiver. The received power, impulse response, corresponding signal-to-noise ratios and root-mean-square delay spread are also investigated. Copyright © 2014 John Wiley & Sons, Ltd.

Effects of aperture averaging and beam width on a partially coherent Gaussian beam over free-space optical links with turbulence and pointing errors.

Abstract: Joint effects of aperture averaging and beam width on the performance of free-space optical communication links, under the impairments of atmospheric loss, turbulence, and pointing errors (PEs), are investigated from an information theory perspective. The propagation of a spatially partially coherent Gaussian-beam wave through a random turbulent medium is characterized, taking into account the diverging and focusing properties of the optical beam as well as the scintillation and beam wander effects. Results show that a noticeable improvement in the average channel capacity can be achieved with an enlarged receiver aperture in the moderate-to-strong turbulence regime, even without knowledge of the channel state information. In particular, it is observed that the optimum beam width can be reduced to improve the channel capacity, albeit the presence of scintillation and PEs, given that either one or both of these adverse effects are least dominant. We show that, under strong turbulence conditions, the beam width increases linearly with the Rytov variance for a relatively smaller PE loss but changes exponentially with steeper increments for higher PE losses. Our findings conclude that the optimal beam width is dependent on the combined effects of turbulence and PEs, and this parameter should be adjusted according to the varying atmospheric channel conditions. Therefore, we demonstrate that the maximum channel capacity is best achieved through the introduction of a larger receiver aperture and a beam-width optimization technique.

Dynamic power-equalized EDFA module based on strain tunable fiber Bragg gratings

Abstract: An adaptive power-equalized erbium-doped fiber amplifier (EDFA) module is proposed and experimentally demonstrated by using strain tunable fiber Bragg gratings (FBGs). In a demonstration for a five-channel wavelength-division-multiplexed (WDM) system, the EDFA module can effectively reduce the power variation from 11 dB to 0.3 dB. Measured power penalty for 2.5-Gb/s data is less than 0.5 and 1.1 dB for 5 and 17 dB of signal attenuation by tunable FBGs, respectively. The power-equalized EDFA module can find wide applications in WDM lightwave transmission systems.

Distributed fiber-optic intrusion sensor system

Abstract: A distributed sensor system for detecting and locating intruders based on the phase-sensitive optical-time-domain reflectometer (/spl phi/-OTDR) is described. The sensing element is a cabled single-mode telecommunications fiber buried along the monitored perimeter. Light pulses from a continuous-wave Er:fiber Fabry-Pe/spl acute/rot laser with a narrow (/spl ap/3 kHz) instantaneous linewidth and low (few kilohertz per second) frequency drift are injected into one end of the fiber, and the backscattered light is monitored with a photodetector. The effect of phase changes resulting from the pressure of the intruder on the ground immediately above the buried fiber are sensed by subtracting a /spl phi/-OTDR trace from an earlier stored trace. In laboratory tests with fiber on reels, the effects of localized phase perturbations induced by a piezoelectric fiber stretcher on /spl phi/-OTDR traces were observed. In field tests, people walking on the ground above a buried fiber cable induced phase shifts of several-/spl pi/ radians.

Applications of nonlinear fiber optics

Abstract: * The only book describing applications of nonlinear fiber optics * Two new chapters on the latest developments: highly nonlinear fibers and quantum applications* Coverage of biomedical applications* Problems provided at the end of each chapterThe development of new highly nonlinear fibers - referred to as microstructured fibers, holey fibers and photonic crystal fibers - is the next generation technology for all-optical signal processing and biomedical applications. This new edition has been thoroughly updated to incorporate these key technology developments.The book presents sound coverage of the fundamentals of lightwave technology, along with material on pulse compression techniques and rare-earth-doped fiber amplifiers and lasers. The extensively revised chapters include information on fiber-optic communication systems and the ultrafast signal processing techniques that make use of nonlinear phenomena in optical fibers.New material focuses on the applications of highly nonlinear fibers in areas ranging from wavelength laser tuning and nonlinear spectroscopy to biomedical imaging and frequency metrology. Technologies such as quantum cryptography, quantum computing, and quantum communications are also covered in a new chapter.This book will be an ideal reference for: RD scientists involved with research on fiber amplifiers and lasers; graduate students and researchers working in the fields of optical communications and quantum information. * The only book on how to develop nonlinear fiber optic applications* Two new chapters on the latest developments; Highly Nonlinear Fibers and Quantum Applications* Coverage of biomedical applications

Wind Turbine Condition Monitoring: State-of-the-Art Review, New Trends, and Future Challenges

Abstract: As the demand for wind energy continues to grow at exponential rates, reducing operation and maintenance (OM) costs and improving reliability have become top priorities in wind turbine (WT) maintenance strategies. In addition to the development of more highly evolved WT designs intended to improve availability, the application of reliable and cost-effective condition-monitoring (CM) techniques offers an efficient approach to achieve this goal. This paper provides a general review and classification of wind turbine condition monitoring (WTCM) methods and techniques with a focus on trends and future challenges. After highlighting the relevant CM, diagnosis, and maintenance analysis, this work outlines the relationship between these concepts and related theories, and examines new trends and future challenges in the WTCM industry. Interesting insights from this research are used to point out strengths and weaknesses in today’s WTCM industry and define research priorities needed for the industry to meet the challenges in wind industry technological evolution and market growth.

Visible Light Communication: Concepts, Applications and Challenges

Abstract: During the last decade, the exponential growth of mobile devices and wireless services created a huge demand for radio frequency-based technologies. Meanwhile, the lighting industry has been revolutionized due to the popularization of LED light bulbs, which are more economical and efficient. In that context, visible light communication (VLC) is a disruptive technology based on LEDs that offers a free spectrum and high data rate, which can potentially serve as a complementary technology to the current radio frequency standards. In this paper, we present a comprehensive state-of-the-art survey of VLC, as well as the main concepts and challenges related to this emergent area. We overview VLC technology, from its physical aspects and communication architecture to its main applications and research challenges. Finally, we present the main research platforms available today, along with a deep analysis of the system design and future directions in the field.

Subcarrier multiplexing for high-speed optical transmission

Abstract: The performance of high-speed digital fiber-optic transmission using subcarrier multiplexing (SCM) is investigated both analytically and numerically. In order to reduce the impact of fiber chromatic dispersion and increase bandwidth efficiency, optical single-sideband (OSSB) modulation was used. Because frequency spacing between adjacent subcarriers can be much narrower than in a conventional DWDM system, nonlinear crosstalk must be considered. Although chromatic dispersion is not a limiting factor in SCM systems because the data rate at each subcarrier is low, polarization mode dispersion (PMD) has a big impact on the system performance if radiofrequency (RE) phase detection is used in the receiver. In order to optimize the system performance, tradeoffs must be made between data rate per subcarrier, levels of modulation, channel spacing between subcarriers, optical power, and modulation indexes. A 10-Gb/s SCM test bed has been set up in which 4 /spl times/ 2.5 Gb/s data streams are combined into one wavelength that occupies a 20-GHz optical bandwidth. OSSB modulation is used in the experiment. The measured results agree well with the analytical prediction.