Shuit-Tong Lee

Bio: Shuit-Tong Lee is an academic researcher from Soochow University (Suzhou). The author has contributed to research in topics: Silicon & Nanowire. The author has an hindex of 138, co-authored 1121 publications receiving 77112 citations. Previous affiliations of Shuit-Tong Lee include University of British Columbia & Hong Kong University of Science and Technology.

Field-emission characteristics of SiC nanowires prepared by chemical-vapor deposition

Abstract: Silicon carbide (SiC) nanowires on a silicon substrate were prepared using hot-filament-assisted chemical-vapor deposition with a solid silicon and carbon source. The SiC nanowires show good field-emitting properties as revealed by the current–voltage characteristics. Together with its ease of preparation, these SiC nanowires are shown to have great potential in the area of electron field-emitting devices.

Wavelength-Controlled Lasing in ZnxCd1–xS Single-Crystal Nanoribbons†

Abstract: Znx Cd1-x S single-crystal nanoribbons of controlled composition (where 0 ≤ x ≤ 1) can be synthesized by combining laser ablation with thermal evaporation. The nanoribbons exhibit lasing emission that can be continuously tuned within the ranges of 340-390 nm and 485-515 nm. These results suggest that Znx Cd1-x S nanoribbon lasers of pre-selected "tunable" wavelengths between 340 and 515 nm may be achievable by tailoring the value of x.

Ultrahigh-Responsivity Photodetectors from Perovskite Nanowire Arrays for Sequentially Tunable Spectral Measurement

Abstract: Compared with polycrystalline films, single-crystalline methylammonium lead halide (MAPbX3, X = halogen) perovskite nanowires (NWs) with well-defined structure possess superior optoelectronic properties for optoelectronic applications. However, most of the prepared perovskite NWs exhibit properties below expectations due to poor crystalline quality and rough surfaces. It also remains a challenge to achieve aligned growth of single-crystalline perovskite NWs for integrated device applications. Here, we report a facile fluid-guided antisolvent vapor-assisted crystallization (FGAVC) method for large-scale fabrication of high-quality single-crystalline MAPb(I1–xBrx)3 (x = 0, 0.1, 0.2, 0.3, 0.4) NW arrays. The resultant perovskite NWs showed smooth surfaces due to slow crystallization process and moisture-isolated growth environment. Significantly, photodetectors made from the NW arrays exhibited outstanding performance in respect of ultrahigh responsivity of 12 500 A W–1, broad linear dynamic rang (LDR) of 15...

Synthesis of Large Areas of Highly Oriented, Very Long Silicon Nanowires

Abstract: Silicon is one of the most important electronic materials. Its nanoscale forms, such as nanocrystals, porous silicon, quantum wells, and nanowires, have stimulated great interest among scientists because of their peculiar physical properties, such as light emission, field emission, and quantum confinement effects. The progress made in the synthesis of silicon nanostructures and nanowires in recent years has attracted considerable attention. Today, large quantities of silicon nanowires can be produced by the laser ablation of metalor SiO2-containing silicon targets, [8] and a few properties, such as electric and thermal conductivity and optical properties, have also been studied. However, the experimental characterization and application of silicon nanowires, for example, the measurement of the elastic properties, the realization of efficient field emission of nanoscale silicon, and the fabrication of nanometer field effect transistors and planar displays, have been hampered so far because of the difficulty in growing oriented silicon nanowires. As a result, the production of highly oriented and very long silicon nanowires is a very important and challenging issue. In this communication, we report the successful synthesis of highly oriented, largescale, and very long silicon nanowires on flat silicon substrates by thermal evaporation of silicon monoxide (SiO). The growth mechanism and optical properties of the oriented silicon nanowires are also discussed. To the best of our knowledge, the synthesis of oriented silicon nanowires has not yet been reported. The equipment used for the present work is similar to that described previously. An alumina tube was mounted inside a tube furnace. The SiO powders (Gooodfellow, 99.95 %) were placed near the middle of the high-temperature zone of the furnace. The polished silicon (100) substrates about 5 mm in width and 50 mm in length were ultrasonically cleaned in acetone, ethanol, and deionized water for 20 min each, dipped in 20 % HF for 20 min, and finally rinsed in deionized water for 20 min before they were placed abreast at one end of the alumina tube. The tube had previously been evacuated to a base pressure of 10 torr by a mechanical pump before the starting materials were heated. The carrier gas of argon mixed with 5 % H2 admitted at the other end of the alumina tube flowed at 50 sccm (standard cubic centimeters per minute) at 400 torr. The temperature of the furnace was increased to 1300 C at 6 C/min and kept at this temperature for 7 h. The temperature of the silicon substrate surface where the oriented silicon nanowires grew was found to be approximately 930 C, which differed from that at the center due to the temperature gradient within the tube. The product was first directly examined by scanning electron microscopy (SEM, Philips XL 30 FEG). Microstructural characterization was carried out in a conventional Philips CM 20 transmission electron microscope (TEM) at 200 kV. The high-resolution transmission electron microscopy (HRTEM) study was performed in a Philips CM200 FEG transmission electron microscope, operated at 200 kV accelerating voltage at room temperature. The chemical compositions of the samples were determined by an energy dispersive X-ray (EDX) spectrometer attached to both the SEM and HRTEM instruments. Raman scattering spectra were measured with a Renishaw micro-Raman spectrometer at room temperature. Excitation was by means of the 514 nm line of an Ar laser, and the Raman signals were measured in a backscattering geometry with a spectral resolution of 1.0 cm. The deposited silicon nanowire product is light yellow in color. SEM images at different magnifications of a typical sample in Figures 1a, 1b, 1c, and 1d clearly show the large area of highly oriented nanowires on the surface of the silicon substrate. The low magnification SEM image (Fig. 1a) shows that the area of highly oriented silicon nanowires is about 2 mm ́ 3 mm and the lengths of individual nanowires are up to 1.5±2 mm. The thickness of the oriented nanowire product was about 10 lm, as estimated from the cross-sectional image (Fig. 1d) of the sample prepared by focused ion beam cutting. The highly oriented array of Si nanowires can also be observed from the cross-sectional image. The EDX results show that the nanowires are composed of silicon and oxygen. No metal was found in the sample. Such results are consistent with our previous theory that silicon nanowire growth is enhanced by silicon oxide instead of a metal particle catalyst. Because of local charging effects, the diameters observed from SEM images appear larger than the actual wire diameters. More information about the morphology of silicon nanowires is given by the following TEM characterization Small pieces of oriented silicon nanowire samples were peeled off from a silicon substrate and mounted on a folding grid for TEM and HRTEM observations. Figure 2 shows the typical morphology of silicon nanowires. As reported previously, these nanowires show a better orientation than those synthesized by laser ablation. Silicon nanowires as observed by TEM are quite clean, with very few particles attached to their surfaces, and are relatively homogeneous. Analysis of a number of nanowires shows that the diameters of these silicon nanowires vary from 18 to 46 nm, and the mean value is about 30 nm. The selected-area electron dif-

SiO2-enhanced synthesis of Si nanowires by laser ablation

Abstract: Si nanowires with uniform size have been synthesized by laser ablation of highly pure Si powder targets mixed with SiO2. A bulk quantity of Si nanowires was successfully obtained by mixing 30%–70% of SiO2 into the Si powder target. SiO2 played a crucial role in enhancing the formation and growth of the Si nanowires. The morphology and microstructure of the Si nanowire tips have been systematically characterized by means of high-resolution transmission electron microscopy. No evidence of metal was found at the tips. The results suggest that Si oxide is more important than metal in catalyzing the formation of Si nanowires.

A roadmap for graphene

Abstract: Recent years have witnessed many breakthroughs in research on graphene (the first two-dimensional atomic crystal) as well as a significant advance in the mass production of this material. This one-atom-thick fabric of carbon uniquely combines extreme mechanical strength, exceptionally high electronic and thermal conductivities, impermeability to gases, as well as many other supreme properties, all of which make it highly attractive for numerous applications. Here we review recent progress in graphene research and in the development of production methods, and critically analyse the feasibility of various graphene applications.

High-performance lithium battery anodes using silicon nanowires

Abstract: There is great interest in developing rechargeable lithium batteries with higher energy capacity and longer cycle life for applications in portable electronic devices, electric vehicles and implantable medical devices. Silicon is an attractive anode material for lithium batteries because it has a low discharge potential and the highest known theoretical charge capacity (4,200 mAh g(-1); ref. 2). Although this is more than ten times higher than existing graphite anodes and much larger than various nitride and oxide materials, silicon anodes have limited applications because silicon's volume changes by 400% upon insertion and extraction of lithium which results in pulverization and capacity fading. Here, we show that silicon nanowire battery electrodes circumvent these issues as they can accommodate large strain without pulverization, provide good electronic contact and conduction, and display short lithium insertion distances. We achieved the theoretical charge capacity for silicon anodes and maintained a discharge capacity close to 75% of this maximum, with little fading during cycling.

Nanobelts of Semiconducting Oxides

Abstract: Ultralong beltlike (or ribbonlike) nanostructures (so-called nanobelts) were successfully synthesized for semiconducting oxides of zinc, tin, indium, cadmium, and gallium by simply evaporating the desired commercial metal oxide powders at high temperatures. The as-synthesized oxide nanobelts are pure, structurally uniform, and single crystalline, and most of them are free from defects and dislocations. They have a rectanglelike cross section with typical widths of 30 to 300 nanometers, width-to-thickness ratios of 5 to 10, and lengths of up to a few millimeters. The beltlike morphology appears to be a distinctive and common structural characteristic for the family of semiconducting oxides with cations of different valence states and materials of distinct crystallographic structures. The nanobelts could be an ideal system for fully understanding dimensionally confined transport phenomena in functional oxides and building functional devices along individual nanobelts.

Raman spectroscopy as a versatile tool for studying the properties of graphene

Abstract: Raman spectroscopy is an integral part of graphene research. It is used to determine the number and orientation of layers, the quality and types of edge, and the effects of perturbations, such as electric and magnetic fields, strain, doping, disorder and functional groups. This, in turn, provides insight into all sp(2)-bonded carbon allotropes, because graphene is their fundamental building block. Here we review the state of the art, future directions and open questions in Raman spectroscopy of graphene. We describe essential physical processes whose importance has only recently been recognized, such as the various types of resonance at play, and the role of quantum interference. We update all basic concepts and notations, and propose a terminology that is able to describe any result in literature. We finally highlight the potential of Raman spectroscopy for layered materials other than graphene.

Aggregation-Induced Emission: Together We Shine, United We Soar!

Abstract: Ju Mei,†,‡,∥ Nelson L. C. Leung,†,‡,∥ Ryan T. K. Kwok,†,‡ Jacky W. Y. Lam,†,‡ and Ben Zhong Tang*,†,‡,§ †HKUST-Shenzhen Research Institute, Hi-Tech Park, Nanshan, Shenzhen 518057, China ‡Department of Chemistry, HKUST Jockey Club Institute for Advanced Study, Institute of Molecular Functional Materials, Division of Biomedical Engineering, State Key Laboratory of Molecular Neuroscience, Division of Life Science, The Hong Kong University of Science and Technology, Clear Water Bay, Kowloon, Hong Kong, China Guangdong Innovative Research Team, SCUT-HKUST Joint Research Laboratory, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Guangzhou 510640, China