Shuit-Tong Lee

Bio: Shuit-Tong Lee is an academic researcher from Soochow University (Suzhou). The author has contributed to research in topics: Silicon & Nanowire. The author has an hindex of 138, co-authored 1121 publications receiving 77112 citations. Previous affiliations of Shuit-Tong Lee include University of British Columbia & Hong Kong University of Science and Technology.

Ag-modified silicon nanowires substrate for ultrasensitive surface-enhanced raman spectroscopy

Abstract: We report a unique substrate for surface-enhanced raman spectroscopy (SERS) based on silver nanoparticles-embedded silicon nanowires (SiNWs). The SiNWs were prepared by thermal evaporation of SiO powder via oxide-assisted growth, oxide removed with HF, and then used to reduce silver ions to form a highly decorated Ag-embedded surface. Such modified SiNWs substrates yielded ultrahigh SERS sensitivity, which could detect 25μl of 1×10−16M Rhodamine 6G, 1×10−16M crystal violet, and 1×10−14M nicotine in methanol solutions. An Ag-modified SiNW strand could also enable SERS detection of 25μl of 1×10−8mg∕ml calf thymus DNA. The possible mechanisms for the ultrahigh SERS sensitivity were discussed.

Synthesis and microstructure of gallium phosphide nanowires

Abstract: Gallium phosphide (GaP) nanowires of 22 nm in diameter and hundreds micrometers in length were synthesized by laser ablation of a powder mixture of GaP and gallium oxide (Ga2O3). The morphology and microstructure of GaP nanowires were investigated by transmission electron microscopy. Twins and stacking faults were observed on {111} planes of the GaP nanowires with special morphologies, and the formation of these defects was discussed. The growth of the GaP nanowires can be described by an oxide-assisted mechanism involving several oxidation-reduction reactions. The successful synthesis of GaP nanowires without any metallic impurities is beneficial for further exploration of their fundamental properties and applications.

Silicon nanowires for high-sensitivity glucose detection

Abstract: Silicon nanowires (SiNWs) were investigated as supporting matrices for enzyme immobilization to construct glucose biosensors. Glucose oxidase was adsorbed onto SiNWs after different treatments, either as grown, HF etched, or carboxylic acid (COOH) functionalized. The amperometric biosensor with COOH-functionalized SiNWs performed the best with a detection limit of 0.01mM glucose (signal-to-noise ratio=3). For real-time detection of glucose, SiNW biosensor showed a linear response in the range of 0.1–15mM. This work demonstrates the utility of SiNWs as a biosensor component and provides a general method to modify the surface of semiconducting nanomaterials for potential biomedical applications.

Electronic and geometric structure of thin stable short silicon nanowires

Abstract: Using the full-potential linear-muffin-tin-orbital molecular-dynamics method, we have studied the geometric and electronic structures of thin short silicon nanowires consisting of tricapped trigonal prism ${\mathrm{Si}}_{9}$ subunits and uncapped trigonal prisms, respectively. Comparing to other possible structures, these structures are found to be the thinnest stable silicon nanowires, being particularly much more stable than the silicon nanotubes built analogously to small carbon nanotubes. As for their electronic structures, these silicon wires show very small gaps of only a few tenths of an eV between the lowest unoccupied energy level and the highest occupied energy level, and the gaps decrease as the stacked layers increase. The results provide guidance to experimental efforts for assembling and growing silicon nanowires.

A roadmap for graphene

Abstract: Recent years have witnessed many breakthroughs in research on graphene (the first two-dimensional atomic crystal) as well as a significant advance in the mass production of this material. This one-atom-thick fabric of carbon uniquely combines extreme mechanical strength, exceptionally high electronic and thermal conductivities, impermeability to gases, as well as many other supreme properties, all of which make it highly attractive for numerous applications. Here we review recent progress in graphene research and in the development of production methods, and critically analyse the feasibility of various graphene applications.

High-performance lithium battery anodes using silicon nanowires

Abstract: There is great interest in developing rechargeable lithium batteries with higher energy capacity and longer cycle life for applications in portable electronic devices, electric vehicles and implantable medical devices. Silicon is an attractive anode material for lithium batteries because it has a low discharge potential and the highest known theoretical charge capacity (4,200 mAh g(-1); ref. 2). Although this is more than ten times higher than existing graphite anodes and much larger than various nitride and oxide materials, silicon anodes have limited applications because silicon's volume changes by 400% upon insertion and extraction of lithium which results in pulverization and capacity fading. Here, we show that silicon nanowire battery electrodes circumvent these issues as they can accommodate large strain without pulverization, provide good electronic contact and conduction, and display short lithium insertion distances. We achieved the theoretical charge capacity for silicon anodes and maintained a discharge capacity close to 75% of this maximum, with little fading during cycling.

Nanobelts of Semiconducting Oxides

Abstract: Ultralong beltlike (or ribbonlike) nanostructures (so-called nanobelts) were successfully synthesized for semiconducting oxides of zinc, tin, indium, cadmium, and gallium by simply evaporating the desired commercial metal oxide powders at high temperatures. The as-synthesized oxide nanobelts are pure, structurally uniform, and single crystalline, and most of them are free from defects and dislocations. They have a rectanglelike cross section with typical widths of 30 to 300 nanometers, width-to-thickness ratios of 5 to 10, and lengths of up to a few millimeters. The beltlike morphology appears to be a distinctive and common structural characteristic for the family of semiconducting oxides with cations of different valence states and materials of distinct crystallographic structures. The nanobelts could be an ideal system for fully understanding dimensionally confined transport phenomena in functional oxides and building functional devices along individual nanobelts.

Raman spectroscopy as a versatile tool for studying the properties of graphene

Abstract: Raman spectroscopy is an integral part of graphene research. It is used to determine the number and orientation of layers, the quality and types of edge, and the effects of perturbations, such as electric and magnetic fields, strain, doping, disorder and functional groups. This, in turn, provides insight into all sp(2)-bonded carbon allotropes, because graphene is their fundamental building block. Here we review the state of the art, future directions and open questions in Raman spectroscopy of graphene. We describe essential physical processes whose importance has only recently been recognized, such as the various types of resonance at play, and the role of quantum interference. We update all basic concepts and notations, and propose a terminology that is able to describe any result in literature. We finally highlight the potential of Raman spectroscopy for layered materials other than graphene.

Aggregation-Induced Emission: Together We Shine, United We Soar!

Abstract: Ju Mei,†,‡,∥ Nelson L. C. Leung,†,‡,∥ Ryan T. K. Kwok,†,‡ Jacky W. Y. Lam,†,‡ and Ben Zhong Tang*,†,‡,§ †HKUST-Shenzhen Research Institute, Hi-Tech Park, Nanshan, Shenzhen 518057, China ‡Department of Chemistry, HKUST Jockey Club Institute for Advanced Study, Institute of Molecular Functional Materials, Division of Biomedical Engineering, State Key Laboratory of Molecular Neuroscience, Division of Life Science, The Hong Kong University of Science and Technology, Clear Water Bay, Kowloon, Hong Kong, China Guangdong Innovative Research Team, SCUT-HKUST Joint Research Laboratory, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Guangzhou 510640, China