Song Chen

Bio: Song Chen is an academic researcher from China University of Mining and Technology. The author has contributed to research in topics: Flame spread. The author has an hindex of 1, co-authored 1 publications receiving 5 citations.

Fire Spread of Thermal Insulation Materials in the Ceiling of Piloti-Type Structure: Comparison of Numerical Simulation and Experimental Fire Tests Using Small- and Real-Scale Models

Abstract: Large-scale fires mainly due to the ignition of thermal insulation materials in the ceiling of piloti-type structures are becoming frequent. However, the fire spread in these cases is not well understood. Herein we performed small-scale and real-scale model tests, and numerical simulations using a fire dynamics simulator (FDS). The experimental and FDS results were compared to elucidate fire spread and effects of thermal insulation materials on it. Comparison of real-scale fire test and FDS results revealed that extruded polystyrene (XPS) thermal insulation material generated additional ignition sources above the ceiling materials upon melting and propagated and sustained the fire. Deformation of these materials during fire test generated gaps, and combustible gases leaked out to cause fire spread. When the ceiling materials collapsed, air flew in through the gaps, leading to flashover that rapidly increased fire intensity and degree of spread. Although the variations of temperatures in real-scale fire test and FDS analysis were approximately similar, melting of XPS and generation of ignition sources could not be reproduced using FDS. Thus, artificial settings that increase the size and intensity of ignition sources at the appropriate moment in FDS were needed to achieve results comparable to those recorded by heat detectors in real-scale fire tests.

Effects of Overlap Length on Flammability and Fire Hazard of Vertical Polymethyl Methacrylate (PMMA) Plate Array.

Abstract: Polymethyl methacrylate (PMMA) plates are widely used in buildings or factories for natural lighting. Commonly PMMA plates are installed as a discrete array. However, PMMA plates are very susceptible to fire. Therefore, experimental study on flammability and fire hazard of vertical PMMA plate array with different overlap length (D) was conducted in this work. The average flame height (Hf) increases first and then decreases with an increase in the overlap length, and reaches the maximum when D = 40 mm. The discrete flame spread speed (Vf) also rises first and then drops with the increase of D, which is mainly due to the heat transfer from the PMMA flame to the next plate. A model for predicting the flame spread rate of discrete PMMA array is established. The predicted results are consistent with experimental ones, with a predicted error smaller than 15%. The average temperature of flame zone rises first and then drops as D increases, reaching the maximum when D = 40 mm. This leads to the same changing trend of radiative heat flux. Results obtained in this work provide a reference for fire hazard evaluation and fire safety design of PMMA plates employed in buildings or industrial sites.

A Review of Combustion and Flame Spread over Thermoplastic Materials: Research Advances and Prospects

Abstract: As thermoplastic materials are widely used in buildings, the fire hazards of thermoplastic materials are increasingly becoming a central issue in fire safety research due to their unique pyrolysis and melting mechanisms. In this paper, the features and common types of thermoplastic materials are introduced first. Then, the combustion behavior of thermoplastic materials is theoretically analyzed based on the empirical formulas and heat balance equations, such as the pyrolysis kinetics, ignition time, melting and dripping, flame, burning rate and mass loss rate, temperature and heat flow, gas products, and influencing factors. The influencing factors basically include the sample properties (width, incline angle, and thickness, etc.), the façade structure (sidewalls, curtain wall, etc.), the ambient conditions (altitude, pressure, and gravity, etc.), and the flame retardant treatment. Similarly, this study also illustrates the vertical and horizontal flame spread behavior of the thermoplastic materials and the influencing factors. The utilized methods include the experimental methods, the analytical methodologies, and the approaches for numerical simulation. Finally, the problems encountered at this stage and worthy of further study in the future are presented.