Steven K. Showalter

Bio: Steven K. Showalter is an academic researcher from Sandia National Laboratories. The author has contributed to research in topics: Thermal energy storage & Thermocline. The author has an hindex of 6, co-authored 9 publications receiving 869 citations.

Development of a Molten-Salt Thermocline Thermal Storage System for Parabolic Trough Plants

Abstract: Thermal storage improves the dispatchability and marketability of parabolic trough power plants allowing them to produce electricity on demand independent of solar collection. One such thermal storage system, a thermocline, uses a single tank containing a fluid with a thermal gradient running vertically through the tank, where hotter fluid (lower density) is at the top of the tank and colder fluid is at the base of the tank. The thermal gradient separates the two temperature potentials. A low-cost filler material provides the bulk of the thermal capacitance of the thermal storage, prevents convective mixing, and reduces the amount of fluid required. In this paper, development of a thermocline system that uses molten-nitrate salt as the heat transfer fluid is described and compared to a two-tank molten salt system. Results of isothermal and thermal cycling tests on candidate materials and salt safety tests are presented as well as results from a small pilot-scale (2.3 MWh) thermocline.

Final Test and Evaluation Results from the Solar Two Project

Abstract: Solar Two was a collaborative, cost-shared project between 11 U. S. industry and utility partners and the U. S. Department of Energy to validate molten-salt power tower technology. The Solar Two plant, located east of Barstow, CA, comprised 1926 heliostats, a receiver, a thermal storage system, a steam generation system, and steam-turbine power block. Molten nitrate salt was used as the heat transfer fluid and storage media. The steam generator powered a 10-MWe (megawatt electric), conventional Rankine cycle turbine. Solar Two operated from June 1996 to April 1999. The major objective of the test and evaluation phase of the project was to validate the technical characteristics of a molten salt power tower. This report describes the significant results from the test and evaluation activities, the operating experience of each major system, and overall plant performance. Tests were conducted to measure the power output (MW) of the each major system, the efficiencies of the heliostat, receiver, thermal storage, and electric power generation systems and the daily energy collected, daily thermal-to-electric conversion, and daily parasitic energy consumption. Also included are detailed test and evaluation reports.

Microfabricated thermal conductivity detector for the micro-ChemLab™

Abstract: This work describes the design, computational prototyping, fabrication, and characterization of a microfabricated thermal conductivity detector (μTCD) to analyze the effluent from a micro-gas chromatograph column (μGC) and to complement the detection efficacy of a surface acoustic wave detector in the micro-ChemLab™ system. To maximize the detection sensitivity, we designed a four-filament Wheatstone bridge circuit where the resistors are suspended by a thin silicon nitride membrane in pyramidal or trapezoidal shaped flow cells. The geometry optimization was carried out by simulation of the heat transfer in the devices, utilizing a boundary element algorithm. Within microfabrication constraints, we determined and fabricated nine sensitivity-optimized geometries of the μTCD. The nine optimal geometries were tested with two different flow patterns. We demonstrated that the perpendicular flow, where the gas directly impinged upon the membrane, yielded a sensitivity that is three times greater than the parallel flow, where the gas passed over the membrane. The functionality of the μTCD was validated with the theoretical prediction and showed a consistent linear response to effluent concentrations, with a detection sensitivity of 1 ppm, utilizing less than 1 W of power.

Development of a Molten-Salt Thermocline Thermal Storage System for Parabolic Trough Plants

Abstract: Thermal storage improves the dispatchability and marketability of parabolic trough power plants allowing them to produce electricity on demand independent of solar collection. One such thermal storage system, a thermocline, uses a single tank containing a fluid with a thermal gradient running vertically through the tank, where hotter fluid (lower density) is at the top of the tank and colder fluid is at the base of the tank. The thermal gradient separates the two temperature potentials. A lowcost filler material provides the bulk of the thermal capacitance of the thermal storage, prevents convective mixing, and reduces the amount of fluid required. In this paper, development of a thermocline system that uses molten-nitrate salt as the heat transfer fluid is described and compared to a two-tank molten salt system. Results of isothermal and thermal cycling tests on candidate materials and salt safety tests are presented as well as results from a small pilot-scale (2.3 MWh) thermocline. NOMENCLATURE A = cross sectional area of bed, m 2

Encapsulation of nanoclusters in dried gel materials via an inverse micelle/sol gel synthesis

Abstract: A dried gel material sterically entrapping nanoclusters of a catalytically active material and a process to make the material via an inverse micelle/sol-gel synthesis. A surfactant is mixed with an apolar solvent to form an inverse micelle solution. A salt of a catalytically active material, such as gold chloride, is added along with a silica gel precursor to the solution to form a mixture. To the mixture are then added a reducing agent for the purpose of reducing the gold in the gold chloride to atomic gold to form the nanoclusters and a condensing agent to form the gel which sterically entraps the nanoclusters. The nanoclusters are normally in the average size range of from 5-10 nm in diameter with a monodisperse size distribution.

State of the art on high temperature thermal energy storage for power generation. Part 1—Concepts, materials and modellization

Abstract: Concentrated solar thermal power generation is becoming a very attractive renewable energy production system among all the different renewable options, as it has have a better potential for dispatchability. This dispatchability is inevitably linked with an efficient and cost-effective thermal storage system. Thus, of all components, thermal storage is a key one. However, it is also one of the less developed. Only a few plants in the world have tested high temperature thermal energy storage systems. In this paper, the different storage concepts are reviewed and classified. All materials considered in literature or plants are listed. And finally, modellization of such systems is reviewed.

High-temperature phase change materials for thermal energy storage

Abstract: The development of energy saving technologies is very actual issue of present day. One of perspective directions in developing these technologies is the thermal energy storage in various industry branches. The review considers the modern state of art in investigations and developments of high-temperature phase change materials perspective for storage thermal and a solar energy in the range of temperatures from 120 to 1000 °C. The considerable quantity of mixes and compositions on the basis of fluorides, chlorides, hydroxides, nitrates, carbonates, vanadates, molybdates and other salts, and also metal alloys is given. Thermophysical properties of potential heat storage salt compositions and metal alloys are presented. Compatibility of heat storage materials (HSM) and constructional materials have found its reflection in the present work. Data on long-term characteristics of some HSMs in the course of repeated cycles of fusion and solidification are analyzed. Article considers also other problems which should be solved for creation of commercial high-temperature heat storage devices with use of phase change materials.

State of the art on high-temperature thermal energy storage for power generation. Part 2—Case studies

Abstract: Power generation systems are attracting a lot of interest from researchers and companies. Storage is becoming a component with high importance to ensure system reliability and economic profitability. A few experiences of storage components have taken place until the moment in solar power plants, most of them as research initiatives. In this paper, real experiences with active storage systems and passive storage systems are compiled, giving detailed information of advantages and disadvantages of each one. Also, a summary of different technologies and materials used in solar power plants with thermal storage systems existing in the world is presented.

Advances in Parabolic Trough Solar Power Technology

Abstract: Parabolic trough solar technology is the most proven and lowest cost large-scale solar power technology available today, primarily because of the nine large commercial-scale solar power plants that are operating in the California Mojave Desert. These plants, developed by Luz International Limited and referred to as Solar Electric Generating Systems (SEGS), range in size from 14-80 MW and represent 354 MW of installed electric generating capacity. More than 2,000,000 m 2 of parabolic trough collector technology has been operating daily for up to 18 years, and as the year 2001 ended, these plants had accumulated 127 years of operational experience. The Luz collector technology has demonstrated its ability to operate in a commercial power plant environment like no other solar technology in the world. Although no new plants have been built since 1990, significant advancements in collector and plant design have been made possible by the efforts of the SEGS plants operators, the parabolic trough industry, and solar research laboratories around the world. This paper reviews the current state of the art of parabolic trough solar power technology and describes the R&D efforts that are in progress to enhance this technology. The paper also shows how the economics of future parabolic trough solar power plants are expected to improve.