Tetsu Tanaka

Bio: Tetsu Tanaka is an academic researcher from Tohoku University. The author has contributed to research in topics: Wafer & Chip. The author has an hindex of 38, co-authored 406 publications receiving 10375 citations. Previous affiliations of Tetsu Tanaka include NTT DoCoMo & Tokyo Medical and Dental University.

V/sub th/ fluctuation induced by statistical variation of pocket dopant profile

Abstract: This paper studies effect of pocket (halo) profile on V/sub th/ fluctuation due to statistical dopant variation by measurement and simulation. A pocket profile significantly enhances V/sub th/ fluctuation by a factor of >15% at worst even if the implantation process variations would be negligible. This is because pocket dopants shrink the area which controls V/sub th/.

Repeating station, a communication apparatus, and a directivity control method

Abstract: A repeating station, a communication apparatus, and an antenna directivity control method are disclosed. The repeating station includes a first antenna group including at least one antenna element, a second antenna group that is different from the first antenna group, the second antenna group including two or more antenna elements adjusted so that radiation in the direction of the first antenna group is reduced, wherein the second antenna group is adjusted such that radiated power in the direction of the first antenna group is reduced.

Impact of remnant stress/strain and metal contamination in 3D-LSIs with through-Si vias fabricated by wafer thinning and bonding

Abstract: Wafer thinning and formation of through-Si via (TSV) and metal microbump are key processes in 3D LSI fabrication. However, it might introduce mechanical stress and crystal defects in thinned wafers. In addition, Cu for TSV and microbump might introduce metal contamination in thinned Si substrate. Then the impact of mechanical stress and metal contamination in the thinned Si substrate has been investigated. The remnant stress left after wafer thinning was evaluated by micro-Raman spectroscopy (µRS) and XPS. It was found that the mechanical stress remained in the back surface of Si substrate after wafer thinning and a part of this mechanical stress appeared in the surface of Si substrate. The metal contamination in such thinned Si substrate has been evaluated by a C-t method. It was found that the carrier generation lifetime was degraded by Cu diffused into Si substrate at relatively low temperature of 200 °C. The mechanical stress/strain in the thinned Si substrate after wafer bonding was also evaluated to investigate the influences of metal microbumps to the thinned Si substrate. It was found that the local mechanical stress was generated in the Si substrate surface by the microbumps. This local stress caused a 3% change in the ON current of MOS transistor.

High density 3D LSI technology using W/Cu hybrid TSVs

Abstract: High density 3D LSI technology using W/Cu hybrid through silicon vias (TSVs) has been proposed. Major reliability issues attributed to W/Cu hybrid TSVs in high density 3D LSIs such as (i) thermo-mechanical stress exerted by W TSVs used for signal lines and Cu TSVs used for power/ground lines in active Si, (ii) external gettering (EG) role played by sub-surface defects in thinned Si substrate, and (iii) effect of local stress induced by μ-bumps on device characteristics are discussed. By annealing at the temperature of ≥300°C, both Cu (via size ≤10µm) and W (via size ≤1µm) square TSVs induce only compressive stress at small TSV spacing which will seriously affect the mobility in active Si area, and thus device characteristics. Large compressive stress not only leads to extrusion and peeling of TSV metal, but also die cracking, and it will adversely impact on the reliability of 3D-LSIs. Then it was proposed to increase the TSV pitch to larger than twice of TSV size to avoid these adverse effects in high density 3D-LSI. Sub-surface defects at dry polished (DP) surface well act as potential EG sites for Cu contamination. Influences of mechanical stress induced by μ-bumps on device characteristics were also evaluated and ultra-small size In-Au μ-bump technology has been developed to minimize the influences of μ-bumps on device characteristics.

Reconfigured-Wafer-to-Wafer 3-D Integration Using Parallel Self-Assembly of Chips With Cu–SnAg Microbumps and a Nonconductive Film

Abstract: A new 3-D integration concept based on reconfigured wafer-to-wafer stacking is proposed. Using reconfigured wafer-to-wafer 3-D integration, many known-good dies (KGDs) can be simultaneously and precisely self-assembled by water surface tension onto a carrier wafer, which is called a reconfigured wafer. In addition, the KGDs on the reconfigured wafer can be transferred and bonded to another target wafer at the wafer level. The alignment accuracy is within 1 μm when 3 × 3-, 5 × 5-, 4 × 9,- or 10 × 10- mm2 chips are employed. To 3-D stack many KGDs in a batch process, we developed and employed a self-assembly multichip bonder. KGDs with 20- μm-pitch Cu-SnAg microbumps covered with a nonconductive film as a preapplied underfill material on their top surface were self-assembled right-side up, and then transferred to the corresponding target interposer wafer upside down. The resulting daisy chain with 500 Cu-SnAg microbumps exhibited ohmic contacts, and the resistance of ~ 40 mΩ/bump was sufficiently low for 3-D large-scale integration application.

Deciphering the biology of Mycobacterium tuberculosis from the complete genome sequence

Abstract: Countless millions of people have died from tuberculosis, a chronic infectious disease caused by the tubercle bacillus. The complete genome sequence of the best-characterized strain of Mycobacterium tuberculosis, H37Rv, has been determined and analysed in order to improve our understanding of the biology of this slow-growing pathogen and to help the conception of new prophylactic and therapeutic interventions. The genome comprises 4,411,529 base pairs, contains around 4,000 genes, and has a very high guanine + cytosine content that is reflected in the biased amino-acid content of the proteins. M. tuberculosis differs radically from other bacteria in that a very large portion of its coding capacity is devoted to the production of enzymes involved in lipogenesis and lipolysis, and to two new families of glycine-rich proteins with a repetitive structure that may represent a source of antigenic variation.

Antiinflammatory Therapy with Canakinumab for Atherosclerotic Disease

Abstract: BackgroundExperimental and clinical data suggest that reducing inflammation without affecting lipid levels may reduce the risk of cardiovascular disease. Yet, the inflammatory hypothesis of atherothrombosis has remained unproved. MethodsWe conducted a randomized, double-blind trial of canakinumab, a therapeutic monoclonal antibody targeting interleukin-1β, involving 10,061 patients with previous myocardial infarction and a high-sensitivity C-reactive protein level of 2 mg or more per liter. The trial compared three doses of canakinumab (50 mg, 150 mg, and 300 mg, administered subcutaneously every 3 months) with placebo. The primary efficacy end point was nonfatal myocardial infarction, nonfatal stroke, or cardiovascular death. ResultsAt 48 months, the median reduction from baseline in the high-sensitivity C-reactive protein level was 26 percentage points greater in the group that received the 50-mg dose of canakinumab, 37 percentage points greater in the 150-mg group, and 41 percentage points greater in t...

Complete genome sequence of Pseudomonas aeruginosa PAO1, an opportunistic pathogen.

Abstract: Pseudomonas aeruginosa is a ubiquitous environmental bacterium that is one of the top three causes of opportunistic human infections. A major factor in its prominence as a pathogen is its intrinsic resistance to antibiotics and disinfectants. Here we report the complete sequence of P. aeruginosa strain PAO1. At 6.3 million base pairs, this is the largest bacterial genome sequenced, and the sequence provides insights into the basis of the versatility and intrinsic drug resistance of P. aeruginosa. Consistent with its larger genome size and environmental adaptability, P. aeruginosa contains the highest proportion of regulatory genes observed for a bacterial genome and a large number of genes involved in the catabolism, transport and efflux of organic compounds as well as four potential chemotaxis systems. We propose that the size and complexity of the P. aeruginosa genome reflect an evolutionary adaptation permitting it to thrive in diverse environments and resist the effects of a variety of antimicrobial substances.