A rapid synchronization method is presented for an orthogonal frequency-division multiplexing (OFDM) system using either a continuous transmission or a burst operation over a frequency-selective channel. The presence of a signal can be detected upon the receipt of just one training sequence of two symbols. The start of the frame and the beginning of the symbol can be found, and carrier frequency offsets of many subchannels spacings can be corrected. The algorithms operate near the Cramer-Rao lower bound for the variance of the frequency offset estimate, and the inherent averaging over many subcarriers allows acquisition at very low signal-to-noise ratios (SNRs).

/pdf/robust-frequency-and-timing-synchronization-for-ofdm-xyhk65f0x1.pdf

Robust frequency and timing synchronization for OFDM

Broadband wireless access systems deployed in residential and business environments are likely to face hostile radio propagation environments, with multipath delay spread extending over tens or hundreds of bit intervals. Orthogonal frequency-division multiplex (OFDM) is a recognized multicarrier solution to combat the effects of such multipath conditions. This article surveys frequency domain equalization (FDE) applied to single-carrier (SC) modulation solutions. SC radio modems with frequency domain equalization have similar performance, efficiency, and low signal processing complexity advantages as OFDM, and in addition are less sensitive than OFDM to RF impairments such as power amplifier nonlinearities. We discuss similarities and differences of SC and OFDM systems and coexistence possibilities, and present examples of SC-FDE performance capabilities.

/pdf/frequency-domain-equalization-for-single-carrier-broadband-17aswqzbww.pdf

Frequency domain equalization for single-carrier broadband wireless systems

We present the joint maximum likelihood (ML) symbol-time and carrier-frequency offset estimator in orthogonal frequency-division multiplexing (OFDM) systems. Redundant information contained within the cyclic prefix enables this estimation without additional pilots. Simulations show that the frequency estimator may be used in a tracking mode and the time estimator in an acquisition mode.

/pdf/ml-estimation-of-time-and-frequency-offset-in-ofdm-systems-22x9rvpv87.pdf

ML estimation of time and frequency offset in OFDM systems

Orthogonal frequency division multiplexing (OFDM) is a modulation technique which is now used in most new and emerging broadband wired and wireless communication systems because it is an effective solution to intersymbol interference caused by a dispersive channel. Very recently a number of researchers have shown that OFDM is also a promising technology for optical communications. This paper gives a tutorial overview of OFDM highlighting the aspects that are likely to be important in optical applications. To achieve good performance in optical systems OFDM must be adapted in various ways. The constraints imposed by single mode optical fiber, multimode optical fiber and optical wireless are discussed and the new forms of optical OFDM which have been developed are outlined. The main drawbacks of OFDM are its high peak to average power ratio and its sensitivity to phase noise and frequency offset. The impairments that these cause are described and their implications for optical systems discussed.

OFDM for Optical Communications

Information and communication technologies (ICT) represent a fundamental element in the growth and performance of smart grids. A sophisticated, reliable and fast communication infrastructure is, in fact, necessary for the connection among the huge amount of distributed elements, such as generators, substations, energy storage systems and users, enabling a real time exchange of data and information necessary for the management of the system and for ensuring improvements in terms of efficiency, reliability, flexibility and investment return for all those involved in a smart grid: producers, operators and customers. This paper overviews the issues related to the smart grid architecture from the perspective of potential applications and the communications requirements needed for ensuring performance, flexible operation, reliability and economics.

/pdf/a-survey-on-smart-grid-potential-applications-and-16fm89suv9.pdf

A Survey on Smart Grid Potential Applications and Communication Requirements

In this contribution the transmission of M-PSK and M-QAM modulated orthogonal frequency division multiplexed (OFDM) signals over an additive white Gaussian noise (AWGN) channel is considered. The degradation of the bit error rate (BER), caused by the presence of carrier frequency offset and carrier phase noise is analytically evaluated. It is shown that for a given BER degradation, the values of the frequency offset and the linewidth of the carrier generator that are allowed for OFDM are orders of magnitude smaller than for single carrier systems carrying the same bit rate. >

BER sensitivity of OFDM systems to carrier frequency offset and Wiener phase noise

In fully digital receivers, carrier and timing information is derived from samples of the (anti-aliasing-filtered) received continuous-time signal. In case of synchronized sampling, this information is used to align the sampling clock of the receiver with the remote transmit clock. In nonsynchronized sampling systems, the sampling at the receiver is performed by means of a fixed free-running clock, and additional post-processing is necessary to perform timing correction in the digital domain. We investigate the effect of non-synchronized sampling on the BER performance of OFDM systems. We calculate the BER degradation caused by a given frequency offset between receiver and transmitter clock, as compared with the case of ideal sampling. The obtained results are compared with the performance of synchronized sampling systems.

The BER performance of OFDM systems using non-synchronized sampling

This paper deals with symbol timing and carrier phase estimation for orthogonal frequency division multiplexed signaling (OFDM) in satellite/terrestrial systems. For transmission over frequency selective channels, a synchronizer at the receiver estimates the phase rotation of each individual carrier; the synchronizer can not distinguish between the phase shift introduced by the channel and by a symbol timing delay. It is shown that for transmission over a nondispersive channel (e.g. fixed satellite link) this algorithm performs suboptimal as compared to a synchronizer which separately estimates the unknown phase and timing. A lower bound on the timing error variance and phase error variance for both synchronizers is calculated. The BER degradation due to imperfect estimation of the timing and phase is given.

Synchronizability of OFDM signals

In a digital transmission system, synchronization is an essential receiver function. Accurate timing information must be known to the demodulator in order to produce reliable estimates of the transmitted data sequence. In this article, synchronization for discrete multitone transmission (DMT) is examined. The effect of imperfect timing on the receiver performance is investigated. An overview of timing estimation and correction circuits based on data-aided and non-data-aided algorithms derived from maximum-likelihood estimation theory is given.

Synchronization with DMT modulation

In order to qualify a subscriber loop for xDSL transmission, the channel capacity has to be estimated, which depends on the transfer function of the network. A method is provided to estimate the transfer function of the subscriber loop only measuring the one-port scattering parameter at the central office. We consider three types of networks according to their topology: a single line, a homogeneous network with a bridged tap, and a cascade of two line sections. For each type of network a parametric model is derived of its one-port scattering parameter and transfer function based on the physical line model VUB0. The model for the scattering parameter is used to identify the network based on the corresponding measurements by means of a maximum-likelihood estimator. The estimated parameters are substituted in the transfer function model, which is needed for the capacity estimation. The proposed models and estimators are validated by measurements and simulations. For the measurements, which were performed with a network analyzer, three types of twisted-pair cables were used: British Telecom (BT), Deutsch Telekom (FT), and Belgacom.

Thierry Pollet

Papers

BER sensitivity of OFDM systems to carrier frequency offset and Wiener phase noise

The BER performance of OFDM systems using non-synchronized sampling

Synchronizability of OFDM signals

Synchronization with DMT modulation

Estimation of the transfer function of a subscriber loop by means of a one-port scattering parameter measurement at the central office