Ulrich Böttger

Bio: Ulrich Böttger is an academic researcher from RWTH Aachen University. The author has contributed to research in topics: Ferroelectricity & Thin film. The author has an hindex of 36, co-authored 130 publications receiving 6707 citations.

Ferroelectricity in hafnium oxide thin films

Abstract: We report that crystalline phases with ferroelectric behavior can be formed in thin films of SiO2 doped hafnium oxide. Films with a thickness of 10 nm and with less than 4 mol. % of SiO2 crystallize in a monoclinic/tetragonal phase mixture. We observed that the formation of the monoclinic phase is inhibited if crystallization occurs under mechanical encapsulation and an orthorhombic phase is obtained. This phase shows a distinct piezoelectric response, while polarization measurements exhibit a remanent polarization above 10 μC/cm2 at a coercive field of 1 MV/cm, suggesting that this phase is ferroelectric. Ferroelectric hafnium oxide is ideally suited for ferroelectric field effect transistors and capacitors due to its excellent compatibility to silicon technology.

Ferroelectricity in Simple Binary ZrO2 and HfO2

Abstract: The transition metal oxides ZrO2 and HfO2 as well as their solid solution are widely researched and, like most binary oxides, are expected to exhibit centrosymmetric crystal structure and therewith linear dielectric characteristics. For this reason, those oxides, even though successfully introduced into microelectronics, were never considered to be more than simple dielectrics possessing limited functionality. Here we report the discovery of a field-driven ferroelectric phase transition in pure, sub 10 nm ZrO2 thin films and a composition- and temperature-dependent transition to a stable ferroelectric phase in the HfO2–ZrO2 mixed oxide. These unusual findings are attributed to a size-driven tetragonal to orthorhombic phase transition that in thin films, similar to the anticipated tetragonal to monoclinic transition, is lowered to room temperature. A structural investigation revealed the orthorhombic phase to be of space group Pbc21, whose noncentrosymmetric nature is deemed responsible for the spontaneous...

Ferroelectricity in yttrium-doped hafnium oxide

Abstract: Structural and electrical evidence for a ferroelectric phase in yttrium doped hafnium oxide thin films is presented. A doping series ranging from 2.3 to 12.3 mol% YO1.5 in HfO2 was deposited by a thermal atomic layer deposition process. Grazing incidence X-ray diffraction of the 10 nm thick films revealed an orthorhombic phase close to the stability region of the cubic phase. The potential ferroelectricity of this orthorhombic phase was confirmed by polarization hysteresis measurements on titanium nitride based metal-insulator-metal capacitors. For 5.2 mol% YO1.5 admixture the remanent polarization peaked at 24 μC/cm2 with a coercive field of about 1.2 MV/cm. Considering the availability of conformal deposition processes and CMOS-compatibility, ferroelectric Y:HfO2 implies high scaling potential for future, ferroelectric memories.

Ferroelectric Zr0.5Hf0.5O2 thin films for nonvolatile memory applications

Abstract: We report the observation of ferroelectricity in capacitors based on hafnium-zirconium-oxide. Hf0.5Zr0.5O2 thin films of 7.5 to 9.5 nm thickness were found to exhibit ferroelectric polarization-voltage hysteresis loops when integrated into TiN-based metal-insulator-metal capacitors. A remnant polarization of 16 μC/cm2 and a high coercive field of 1 MV/cm were observed. Further proof for the ferroelectric nature was collected by quasi-static polarization-voltage hysteresis, small signal capacitance-voltage, and piezoelectric measurements. Data retention characteristics were evaluated by a Positive Up Negative Down pulse technique. No significant decay of the initial polarization state was observed within a measurement range of up to two days.

Beyond von Neumann—logic operations in passive crossbar arrays alongside memory operations

Abstract: The realization of logic operations within passive crossbar memory arrays is a promising approach to expand the fields of application of such architectures. Material implication was recently suggested as the basic function of memristive crossbar junctions, and single bipolar resistive switches (BRS) as well as complementary resistive switches (CRS) were shown to be capable of realizing this logical functionality. Based on a systematic analysis of the Boolean functions, we demonstrate here that 14 of 16 Boolean functions can be realized with a single BRS or CRS cell in at most three sequential cycles. Since the read-out step is independent of the logic operation steps, the result of the logic operation is directly stored to memory, making logic-in-memory applications feasible.

I and i

Abstract: There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality. Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

Nanoionics-based resistive switching memories

Abstract: Many metal–insulator–metal systems show electrically induced resistive switching effects and have therefore been proposed as the basis for future non-volatile memories. They combine the advantages of Flash and DRAM (dynamic random access memories) while avoiding their drawbacks, and they might be highly scalable. Here we propose a coarse-grained classification into primarily thermal, electrical or ion-migration-induced switching mechanisms. The ion-migration effects are coupled to redox processes which cause the change in resistance. They are subdivided into cation-migration cells, based on the electrochemical growth and dissolution of metallic filaments, and anion-migration cells, typically realized with transition metal oxides as the insulator, in which electronically conducting paths of sub-oxides are formed and removed by local redox processes. From this insight, we take a brief look into molecular switching systems. Finally, we discuss chip architecture and scaling issues.

Memristive devices for computing

Abstract: Memristive devices are electrical resistance switches that can retain a state of internal resistance based on the history of applied voltage and current. These devices can store and process information, and offer several key performance characteristics that exceed conventional integrated circuit technology. An important class of memristive devices are two-terminal resistance switches based on ionic motion, which are built from a simple conductor/insulator/conductor thin-film stack. These devices were originally conceived in the late 1960s and recent progress has led to fast, low-energy, high-endurance devices that can be scaled down to less than 10 nm and stacked in three dimensions. However, the underlying device mechanisms remain unclear, which is a significant barrier to their widespread application. Here, we review recent progress in the development and understanding of memristive devices. We also examine the performance requirements for computing with memristive devices and detail how the outstanding challenges could be met.

Highly sensitive flexible pressure sensors with microstructured rubber dielectric layers

Abstract: The development of an electronic skin is critical to the realization of artificial intelligence that comes into direct contact with humans, and to biomedical applications such as prosthetic skin. To mimic the tactile sensing properties of natural skin, large arrays of pixel pressure sensors on a flexible and stretchable substrate are required. We demonstrate flexible, capacitive pressure sensors with unprecedented sensitivity and very short response times that can be inexpensively fabricated over large areas by microstructuring of thin films of the biocompatible elastomer polydimethylsiloxane. The pressure sensitivity of the microstructured films far surpassed that exhibited by unstructured elastomeric films of similar thickness, and is tunable by using different microstructures. The microstructured films were integrated into organic field-effect transistors as the dielectric layer, forming a new type of active sensor device with similarly excellent sensitivity and response times.