http://ieeexplore.ieee.org/iel5/5610941/5624686/05624745.pdf

Power electronics

The authors discuss high-voltage power conversion. Conventional series connection and three-level voltage source inverter techniques are reviewed and compared. A novel versatile multilevel commutation cell is introduced: it is shown that this topology is safer and more simple to control, and delivers purer output waveforms. The authors show how this technique can be applied to either choppers or voltage-source inverters and generalized to any number of switches.<<ETX>>

Multi-level conversion : high voltage choppers and voltage-source inverters

The main objective of this two-part state-of-the-art paper called “Recent Advances in the Design, Modeling, and Control of Multiphase Machines” is to present latest contributions in the multiphase machines' field. The first part of this paper focuses on the recent progress in the design, modeling, and control, whereas the drive is in healthy operation. This second part presents relevant contributions in two not analyzed fields. The first is in relation with the use of the additional degrees of freedom of multiphase machines and the exploitation of their fault-tolerant capabilities without adding extra hardware. The second one analyzes multiphase generation, particularly in grid-connected wind energy conversion systems and stand-alone applications. Recent progresses are shown and open challenges and future research directions are discussed.

Recent Advances in the Design, Modeling, and Control of Multiphase Machines—Part II

Doubly fed induction generators (DFIGs), often organized in wind parks, are the most important generators used for variable-speed wind energy generation. This paper reviews the control systems for the operation of DFIGs and brushless DFIGs in wind energy applications. Control systems for stand-alone operation, connection to balanced or unbalanced grids, sensorless control, and frequency support from DFIGs and low-voltage ride-through issues are discussed.

Overview of Control Systems for the Operation of DFIGs in Wind Energy Applications

A sparse auto-encoder-based deep neural network approach for induction motor faults classification

Power converter interfaces for electrochemical energy storage systems – A review

This paper presents a three-phase multilevel quasi-Z-source inverter (qZSI) topology operating in normal and fault-tolerant operation mode. This structure is composed by two symmetrical quasi-Z-source networks and a three-phase T-type inverter. Besides the intrinsic advantages of multilevel voltage source inverters, the proposed structure is also characterized by their semiconductor fault tolerance capability. This feature is only obtained through changes on the modulation scheme after the semiconductor fault and does not require additional extra-phase legs or collective switching states. In certain fault types, the reduction of the output power capacity will be compensated by the boost characteristic of the qZSI. The fault-tolerant behavior of the proposed topology is demonstrated by several simulation results of the converter in normal and fault condition. To validate the characteristics of this multilevel qZSI, an experimental prototype was also built to experimentally confirm the results.

V. Fernao Pires

Papers

Power converter interfaces for electrochemical energy storage systems – A review

Quasi-Z-Source Inverter With a T-Type Converter in Normal and Failure Mode

Economic assessment of residential PV systems with self-consumption and storage in Portugal

Motor square current signature analysis for induction motor rotor diagnosis

Dual-inverter for grid-connected photovoltaic system: Modeling and sliding mode control