scispace - formally typeset
Search or ask a question
Author

V. G. Ralchenko

Bio: V. G. Ralchenko is an academic researcher from Russian Academy of Sciences. The author has contributed to research in topics: Diamond & Chemical vapor deposition. The author has an hindex of 36, co-authored 280 publications receiving 4622 citations. Previous affiliations of V. G. Ralchenko include National Research Nuclear University MEPhI & Harbin Institute of Technology.


Papers
More filters
Journal ArticleDOI
TL;DR: The wettability of CVD diamond films with liquids of different physico-chemical natures (water, glycerin, tin melt) was investigated by measuring the contact angles using the sessile drop method.

197 citations

Journal ArticleDOI
TL;DR: In this article, a tri-layer diamond/tungsten carbide and tungsten buffer layer was used to enhance the adhesion of steel with high compressive stress, σ ≈ 7 GPa.

184 citations

Journal ArticleDOI
TL;DR: In this paper, the structure of fine-grained diamond films with crystallite size as small as 10-50 nm has been studied with cross-section transmission electron microscopy and Raman spectroscopy.

146 citations

Journal ArticleDOI
TL;DR: In this paper, the thermal conductivity at room temperature of diamond composites of two types: with a diamond skeleton and with diamond grains imbedded in a non-diamond matrix was evaluated in dependence of the diamond grain size.

134 citations

Journal ArticleDOI
TL;DR: The postgrowth modification of diamond-like amorphous hydrogenated carbon a-C:H films by laser treatment has been studied by transmission electron microscopy and Raman spectroscopy as discussed by the authors.
Abstract: The post-growth modification of diamond-like amorphous hydrogenated carbon a-C:H films by laser treatment has been studied by transmission electron microscopy and Raman spectroscopy a-C:H films grown on Si substrates by benzene decomposition in a rf glow discharge were irradiated with 15 ns pulses of a KrF-excimer laser with fluences in the range of E=50–700 mJ/cm2 At fluences below 100 mJ/cm2 an increase in the number of graphitic clusters and in their ordering was evidenced from Raman spectra, while the film structure remained amorphous according to electron microscopy and electron diffraction observations At higher fluences the appearance of diamond particles of 2–7 nm size, embedded into the lower crystallized graphitic matrix, was observed and simultaneously a progressive growth of graphite nanocrystals with dimensions from 2 nm to 4 nm was deduced from Raman measurements The maximum thickness of the crystallized surface layer (≈400 nm) and the degree of laser annealing are limited by the film ablation which starts at E>250 mJ/cm2 The laser-treated areas lose their chemical inertness In particular, chemical etching in chromium acid becomes possible, which may be used for patterning the highly inert carbon films

126 citations


Cited by
More filters
Journal ArticleDOI
TL;DR: The extremely high value of the thermal conductivity suggests that graphene can outperform carbon nanotubes in heat conduction and establishes graphene as an excellent material for thermal management.
Abstract: We report the measurement of the thermal conductivity of a suspended single-layer graphene. The room temperature values of the thermal conductivity in the range ∼(4.84 ± 0.44) × 103 to (5.30 ± 0.48) × 103 W/mK were extracted for a single-layer graphene from the dependence of the Raman G peak frequency on the excitation laser power and independently measured G peak temperature coefficient. The extremely high value of the thermal conductivity suggests that graphene can outperform carbon nanotubes in heat conduction. The superb thermal conduction property of graphene is beneficial for the proposed electronic applications and establishes graphene as an excellent material for thermal management.

11,878 citations

Journal ArticleDOI
TL;DR: The thermal properties of carbon materials are reviewed, focusing on recent results for graphene, carbon nanotubes and nanostructured carbon materials with different degrees of disorder, with special attention given to the unusual size dependence of heat conduction in two-dimensional crystals.
Abstract: Recent years have seen a rapid growth of interest by the scientific and engineering communities in the thermal properties of materials. Heat removal has become a crucial issue for continuing progress in the electronic industry, and thermal conduction in low-dimensional structures has revealed truly intriguing features. Carbon allotropes and their derivatives occupy a unique place in terms of their ability to conduct heat. The room-temperature thermal conductivity of carbon materials span an extraordinary large range--of over five orders of magnitude--from the lowest in amorphous carbons to the highest in graphene and carbon nanotubes. Here, I review the thermal properties of carbon materials focusing on recent results for graphene, carbon nanotubes and nanostructured carbon materials with different degrees of disorder. Special attention is given to the unusual size dependence of heat conduction in two-dimensional crystals and, specifically, in graphene. I also describe the prospects of applications of graphene and carbon materials for thermal management of electronics.

5,189 citations

Journal ArticleDOI
TL;DR: In this paper, the authors review thermal and thermoelectric properties of carbon materials focusing on recent results for graphene, carbon nanotubes and nanostructured carbon materials with different degrees of disorder.
Abstract: Recent years witnessed a rapid growth of interest of scientific and engineering communities to thermal properties of materials. Carbon allotropes and derivatives occupy a unique place in terms of their ability to conduct heat. The room-temperature thermal conductivity of carbon materials span an extraordinary large range – of over five orders of magnitude – from the lowest in amorphous carbons to the highest in graphene and carbon nanotubes. I review thermal and thermoelectric properties of carbon materials focusing on recent results for graphene, carbon nanotubes and nanostructured carbon materials with different degrees of disorder. A special attention is given to the unusual size dependence of heat conduction in two-dimensional crystals and, specifically, in graphene. I also describe prospects of applications of graphene and carbon materials for thermal management of electronics.

3,609 citations

Journal ArticleDOI
TL;DR: The rational control of the mechanical, chemical, electronic and optical properties of nanodiamonds through surface doping, interior doping and the introduction of functional groups are discussed.
Abstract: Nanodiamonds have excellent mechanical and optical properties, high surface areas and tunable surface structures. They are also non-toxic, which makes them well suited to biomedical applications. Here we review the synthesis, structure, properties, surface chemistry and phase transformations of individual nanodiamonds and clusters of nanodiamonds. In particular we discuss the rational control of the mechanical, chemical, electronic and optical properties of nanodiamonds through surface doping, interior doping and the introduction of functional groups. These little gems have a wide range of potential applications in tribology, drug delivery, bioimaging and tissue engineering, and also as protein mimics and a filler material for nanocomposites.

2,351 citations

Journal ArticleDOI
TL;DR: This paper presents a meta-analyses of the physical and chemical properties of Boron-Doped Diamond for Electrochemistry as well as a mechanistic analysis of the properties of the diamond itself and some of its applications.
Abstract: 3.6.1. Polishing and Cleaning 2663 3.6.2. Vacuum and Heat Treatments 2664 3.6.3. Carbon Electrode Activation 2665 3.7. Summary and Generalizations 2666 4. Advanced Carbon Electrode Materials 2666 4.1. Microfabricated Carbon Thin Films 2666 4.2. Boron-Doped Diamond for Electrochemistry 2668 4.3. Fibers and Nanotubes 2669 4.4. Carbon Composite Electrodes 2674 5. Carbon Surface Modification 2675 5.1. Diazonium Ion Reduction 2675 5.2. Thermal and Photochemical Modifications 2679 5.3. Amine and Carboxylate Oxidation 2680 5.4. Modification by “Click” Chemistry 2681 6. Synopsis and Outlook 2681 7. Acknowledgments 2682 8. References 2682

2,240 citations