Vicente Franco

Bio: Vicente Franco is an academic researcher from James I University. The author has contributed to research in topics: Diesel fuel & European union. The author has an hindex of 12, co-authored 25 publications receiving 1106 citations.

Impacts and mitigation of excess diesel-related NOx emissions in 11 major vehicle markets

Abstract: Vehicle emissions contribute to fine particulate matter (PM 2.5) and tropospheric ozone air pollution, affecting human health, crop yields and climate worldwide. On-road diesel vehicles produce approximately 20 per cent of global anthropogenic emissions of nitrogen oxides (NO x), which are key PM 2.5 and ozone precursors. Regulated NO x emission limits in leading markets have been progressively tightened, but current diesel vehicles emit far more NO x under real-world operating conditions than during laboratory certification testing. Here we show that across 11 markets, representing approximately 80 per cent of global diesel vehicle sales, nearly one-third of on-road heavy-duty diesel vehicle emissions and over half of on-road light-duty diesel vehicle emissions are in excess of certification limits. These excess emissions (totalling 4.6 million tons) are associated with about 38,000 PM 2.5 - and ozone-related premature deaths globally in 2015, including about 10 per cent of all ozone-related premature deaths in the 28 European Union member states. Heavy-duty vehicles are the dominant contributor to excess diesel NO x emissions and associated health impacts in almost all regions. Adopting and enforcing next-generation standards (more stringent than Euro 6/VI) could nearly eliminate real-world diesel-related NO x emissions in these markets, avoiding approximately 174,000 global PM 2.5 - and ozone-related premature deaths in 2040. Most of these benefits can be achieved by implementing Euro VI standards where they have not yet been adopted for heavy-duty vehicles.

Experimental Assessment of NOx Emissions from 73 Euro 6 Diesel Passenger Cars

Abstract: Controlling nitrogen oxides (NOx) emissions from diesel passenger cars during real-world driving is one of the major technical challenges facing diesel auto manufacturers. Three main technologies are available for this purpose: exhaust gas recirculation (EGR), lean-burn NOx traps (LNT), and selective catalytic reduction (SCR). Seventy-three Euro 6 diesel passenger cars (8 EGR only, 40 LNT, and 25 SCR) were tested on a chassis dynamometer over both the European type-approval cycle (NEDC, cold engine start) and the more realistic Worldwide harmonized light-duty test cycle (WLTC version 2.0, hot start) between 2012 and 2015. Most vehicles met the legislative limit of 0.08 g/km of NOx over NEDC (average emission factors by technology: EGR-only 0.07 g/km, LNT 0.04 g/km, and SCR 0.05 g/km), but the average emission factors rose dramatically over WLTC (EGR-only 0.17 g/km, LNT 0.21 g/km, and SCR 0.13 g/km). Five LNT-equipped vehicles exhibited very poor performance over the WLTC, emitting 7-15 times the regulated limit. These results illustrate how diesel NOx emissions are not properly controlled under the current, NEDC-based homologation framework. The upcoming real-driving emissions (RDE) regulation, which mandates an additional on-road emissions test for EU type approvals, could be a step in the right direction to address this problem.

Brake wear particle emissions: a review

Abstract: Traffic-related sources have been recognized as a significant contributor of particulate matter particularly within major cities. Exhaust and non-exhaust traffic-related sources are estimated to contribute almost equally to traffic-related PM10 emissions. Non-exhaust particles can be generated either from non-exhaust sources such as brake, tyre, clutch and road surface wear or already exist in the form of deposited material at the roadside and become resuspended due to traffic-induced turbulence. Among non-exhaust sources, brake wear can be a significant particulate matter (PM) contributor, particularly within areas with high traffic density and braking frequency. Studies mention that in urban environments, brake wear can contribute up to 55 % by mass to total non-exhaust traffic-related PM10 emissions and up to 21 % by mass to total traffic-related PM10 emissions, while in freeways, this contribution is lower due to lower braking frequency. As exhaust emissions control become stricter, relative contributions of non-exhaust sources—and therefore brake wear—to traffic-related emissions will become more significant and will raise discussions on possible regulatory needs. The aim of the present literature review study is to present the state-of-the-art of the different aspects regarding PM resulting from brake wear and provide all the necessary information in terms of importance, physicochemical characteristics, emission factors and possible health effects.

Anthropogenic emission inventories in China: a review

Abstract: The development of reliable anthropogenic emission inventories is essential for both understanding the sources of air pollution and designing effective air-pollution-control measures in China. However, it is challenging to quantify emissions in China accurately, given the variety of contributing sources, the complexity of the technology mix and the lack of reliable measurements. Over the last two decades, tremendous efforts have been made to improve the accuracy of emission inventories, and significant improvements have been realized. More reliable statistics and survey-based data have been used to reduce the uncertainties in activity rates and technology distributions. Local emission factors and source profiles covering various sources have been measured and reported. Based on these local databases, improved emission inventory models have been developed for power plants, large industrial plants and the residential, transportation and agricultural sectors. In this paper, we review the progress that has been made in developing inventories of anthropogenic emissions in China. We first highlight the major updates that have been made to emission inventory models and the underlying data by source category. We then summarize the sector-based estimates of emissions of different species contained in current inventories. The progress that has been made in the development of model-ready emissions is also presented. Finally, we suggest future directions for further improving the accuracy of emission inventories in China.