Author
Vittorio Scardaci
Other affiliations: University College London, University of Cambridge, Trinity College, Dublin ...read more
Bio: Vittorio Scardaci is an academic researcher from University of Catania. The author has contributed to research in topics: Saturable absorption & Carbon nanotube. The author has an hindex of 26, co-authored 57 publications receiving 20629 citations. Previous affiliations of Vittorio Scardaci include University College London & University of Cambridge.
Topics: Saturable absorption, Carbon nanotube, Fiber laser, Laser, Nanotube
Papers
More filters
TL;DR: Flexible, transparent, and very conducting thin composite films from poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate), filled with both arc discharge and HIPCO single-walled nanotubes, at high loading level are prepared.
Abstract: We have prepared flexible, transparent, and very conducting thin composite films from poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate), filled with both arc discharge and HIPCO single-walled nanotubes, at high loading level. The films are of high optical uniformity. The arc discharge nanotube-filled composites were significantly more conductive, demonstrating DC conductivities of >10(5) S/m for mass fractions >50 wt %. The ratio of DC to optical conductivity was higher for composites with mass fractions of 55-60 wt % than for nanotube-only films. For an 80 nm thick composite, filled with 60 wt % arc discharge nanotubes, this conductivity ratio was maximized at sigma(DC)/sigma(Op) = 15. This translates into transmittance (550 nm) and sheet resistance of 75 and 80 Omega/square, respectively. These composites were electromechanically very stable, showing <1% resistance change over 130 bend cycles.
271 citations
TL;DR: In this article, the authors demonstrate ink-jet printing as a viable method for large area fabrication of carbon nanotube (CNT) thin film transistors (TFTs) and investigate different routes for producing stable CNT solutions ("inks").
Abstract: Ink-jet printing is an important process for placing active electronics on plastic substrates. We demonstrate ink-jet printing as a viable method for large area fabrication of carbon nanotube (CNT) thin film transistors (TFTs). We investigate different routes for producing stable CNT solutions ("inks"). These consist of dispersion methods for CNT debundling and the use of different solvents, such as N-methyl-2-pyrrolidone. The resulting printable inks are dispensed by ink-jet onto electrode bearing silicon substrates. The source to drain electrode gap is bridged by percolating networks of CNTs. Despite the presence of metallic CNTs, our devices exhibit field effect behavior, with effective mobility of similar to 0.07 cm(2)/V s and ON/OFF current ratio of up to 100. This result demonstrates the feasibility of ink-jet printing of nanostructured materials for TFT manufacture. (C) 2007 American Institute of Physics.
211 citations
TL;DR: This work investigates photoluminescence of nanotube bundles by explaining their spectra by exciton energy transfer between adjacent tubes, whereby excitation of large gap tubes induces emission from smaller gap ones.
Abstract: We investigate photoluminescence of nanotube bundles. Their spectra are explained by exciton energy transfer between adjacent tubes, whereby excitation of large gap tubes induces emission from smaller gap ones. The consequent relaxation rate is faster than nonradiative recombination, leading to enhanced photoluminescence of acceptor tubes.
205 citations
TL;DR: In this article, a simple method to stabilize single-wall carbon nanotube (SWNT) dispersions in N-methyl-2-pyrrolidone (NMP) by polyvinylpyrrinolide (PVP) is presented.
Abstract: We present a simple method to stabilize single-wall carbon nanotube (SWNT) dispersions in N-methyl-2-pyrrolidone (NMP) by polyvinylpyrrolidone (PVP). A significant population of isolated SWNTs as well as small bundles of SWNTs in NMP is obtained by ultrasonic treatment followed by vacuum filtration through glass fiber filters. The resulting dispersions in pure NMP are monitored by photoluminescence (PL) spectroscopy over a period of 3 weeks. The PL intensities of such dispersions decrease with time, suggesting slow microscopic aggregation of nanotubes. However, addition of PVP dramatically improves the stability. In addition, PVP also spontaneously “debundles” some nanotube aggregates, increasing the isolated SWNT population without further ultrasonic treatment.
177 citations
TL;DR: In this article, thin films of arc discharge single walled nanotubes were prepared by vacuum filtration, and the optical transmittance scales with film thickness as expected for a thin conducting film with optical conductivity of 1.7 × 104 S/m (λ = 1.5 µm).
171 citations
Cited by
More filters
[...]
TL;DR: Owing to its unusual electronic spectrum, graphene has led to the emergence of a new paradigm of 'relativistic' condensed-matter physics, where quantum relativistic phenomena can now be mimicked and tested in table-top experiments.
Abstract: Graphene is a rapidly rising star on the horizon of materials science and condensed-matter physics. This strictly two-dimensional material exhibits exceptionally high crystal and electronic quality, and, despite its short history, has already revealed a cornucopia of new physics and potential applications, which are briefly discussed here. Whereas one can be certain of the realness of applications only when commercial products appear, graphene no longer requires any further proof of its importance in terms of fundamental physics. Owing to its unusual electronic spectrum, graphene has led to the emergence of a new paradigm of 'relativistic' condensed-matter physics, where quantum relativistic phenomena, some of which are unobservable in high-energy physics, can now be mimicked and tested in table-top experiments. More generally, graphene represents a conceptually new class of materials that are only one atom thick, and, on this basis, offers new inroads into low-dimensional physics that has never ceased to surprise and continues to provide a fertile ground for applications.
35,293 citations
TL;DR: In this paper, the basic theoretical aspects of graphene, a one-atom-thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations, are discussed.
Abstract: This article reviews the basic theoretical aspects of graphene, a one-atom-thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations. The Dirac electrons can be controlled by application of external electric and magnetic fields, or by altering sample geometry and/or topology. The Dirac electrons behave in unusual ways in tunneling, confinement, and the integer quantum Hall effect. The electronic properties of graphene stacks are discussed and vary with stacking order and number of layers. Edge (surface) states in graphene depend on the edge termination (zigzag or armchair) and affect the physical properties of nanoribbons. Different types of disorder modify the Dirac equation leading to unusual spectroscopic and transport properties. The effects of electron-electron and electron-phonon interactions in single layer and multilayer graphene are also presented.
20,824 citations
28 Jul 2005
TL;DR: PfPMP1）与感染红细胞、树突状组胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作�ly.
Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。
18,940 citations
TL;DR: Graphene is established as the strongest material ever measured, and atomically perfect nanoscale materials can be mechanically tested to deformations well beyond the linear regime.
Abstract: We measured the elastic properties and intrinsic breaking strength of free-standing monolayer graphene membranes by nanoindentation in an atomic force microscope. The force-displacement behavior is interpreted within a framework of nonlinear elastic stress-strain response, and yields second- and third-order elastic stiffnesses of 340 newtons per meter (N m(-1)) and -690 Nm(-1), respectively. The breaking strength is 42 N m(-1) and represents the intrinsic strength of a defect-free sheet. These quantities correspond to a Young's modulus of E = 1.0 terapascals, third-order elastic stiffness of D = -2.0 terapascals, and intrinsic strength of sigma(int) = 130 gigapascals for bulk graphite. These experiments establish graphene as the strongest material ever measured, and show that atomically perfect nanoscale materials can be mechanically tested to deformations well beyond the linear regime.
18,008 citations
TL;DR: This work reviews the historical development of Transition metal dichalcogenides, methods for preparing atomically thin layers, their electronic and optical properties, and prospects for future advances in electronics and optoelectronics.
Abstract: Single-layer metal dichalcogenides are two-dimensional semiconductors that present strong potential for electronic and sensing applications complementary to that of graphene.
13,348 citations