다중혈관 관상동맥 환자에서 y-문합을 이용하여 양쪽 내흉동맥만을 사용한 우회술의 조기 성적

Providing ubiquitous connectivity to diverse device types is the key challenge for 5G and beyond 5G (B5G). Unmanned aerial vehicles (UAVs) are expected to be an important component of the upcoming wireless networks that can potentially facilitate wireless broadcast and support high rate transmissions. Compared to the communications with fixed infrastructure, UAV has salient attributes, such as flexible deployment, strong line-of-sight (LoS) connection links, and additional design degrees of freedom with the controlled mobility. In this paper, a comprehensive survey on UAV communication towards 5G/B5G wireless networks is presented. We first briefly introduce essential background and the space-air-ground integrated networks, as well as discuss related research challenges faced by the emerging integrated network architecture. We then provide an exhaustive review of various 5G techniques based on UAV platforms, which we categorize by different domains including physical layer, network layer, and joint communication, computing and caching. In addition, a great number of open research problems are outlined and identified as possible future research directions.

UAV Communications for 5G and Beyond: Recent Advances and Future Trends

We propose a two-phase protocol based on cooperative decode-and-forward relaying for a secondary system to achieve spectrum access along with a primary system. The primary and secondary systems comprise of a transmitter-receiver pair, PT-PR and ST-SR, respectively. In the first transmission phase, PT transmits the primary signal to PR, which is also received by ST and SR, where it is decoded. At ST, the primary signal is regenerated and linearly combined with the secondary signal by assigning fractions alpha and (1 - alpha) of the available power to the primary and secondary signals respectively. This combined signal is then broadcasted by ST in the second transmission phase. We show that as long as ST is located within a critical radius from PT, there exists a threshold value for alpha above which the outage probability of the primary system will be equal to or lower than the case without spectrum sharing. We also determine the outage probability achieved by the secondary system. Theoretical and simulation results confirm the efficiency of the proposed spectrum sharing scheme.

Cooperative decode-and-forward relaying for secondary spectrum access

The fifth generation (5G) mobile networks are envisaged to enable a plethora of breakthrough advancements in wireless technologies, providing support of a diverse set of services over a single platform. While the deployment of 5G systems is scaling up globally, it is time to look ahead for beyond 5G systems. This is mainly driven by the emerging societal trends, calling for fully automated systems and intelligent services supported by extended reality and haptics communications. To accommodate the stringent requirements of their prospective applications, which are data-driven and defined by extremely low-latency, ultra-reliable, fast and seamless wireless connectivity, research initiatives are currently focusing on a progressive roadmap towards the sixth generation (6G) networks, which are expected to bring transformative changes to this premise. In this article, we shed light on some of the major enabling technologies for 6G, which are expected to revolutionize the fundamental architectures of cellular networks and provide multiple homogeneous artificial intelligence-empowered services, including distributed communications, control, computing, sensing, and energy, from its core to its end nodes. In particular, the present paper aims to answer several 6G framework related questions: What are the driving forces for the development of 6G? How will the enabling technologies of 6G differ from those in 5G? What kind of applications and interactions will they support which would not be supported by 5G? We address these questions by presenting a comprehensive study of the 6G vision and outlining seven of its disruptive technologies, i.e., mmWave communications, terahertz communications, optical wireless communications, programmable metasurfaces, drone-based communications, backscatter communications and tactile internet, as well as their potential applications. Then, by leveraging the state-of-the-art literature surveyed for each technology, we discuss the associated requirements, key challenges, and open research problems. These discussions are thereafter used to open up the horizon for future research directions.

A Prospective Look: Key Enabling Technologies, Applications and Open Research Topics in 6G Networks

A new transmission protocol for joint cooperation between a primary and secondary user in a cognitive radio system is proposed. If successful decoding is achieved, the primary/secondary transmitters behave as relays for the other system. With more efficient use of the communication resource, performance is enhanced. The proposed scheme builds on the work in [1] and offers improved outage probabilities for both the primary and secondary systems. The paper provides a full characterization of the Markov Chain describing the protocol behavior and a closed form expression for the stationary distribution of the chain. Furthermore, exact computation or tight approximations for the outage probabilities for all states of the chain are derived. Simulation results exhibit a performance improvement between 22 and 48 percent for primary system and an uniform decrease of outage probability for secondary system.

Jointly cooperative decode-and-forward relaying for secondary spectrum access

Fog computing has emerged as a promising technology that can bring cloud applications closer to the devices at the network edge. The fog infrastructure contains mainly distributed and heterogeneous fog devices such as in the context of the Internet of Things. Unlike traditional data centers, those devices are characterized by sporadic resources availability, mobility, and increased flexibility. However, resource allocation mechanisms proposed currently for fog computing still lack the support of dynamic behavior. In this article, we propose novel resource management algorithms capable of flexible service provisioning in a dynamic fog computing environment. Specifically, the joint problem of container placement and task provisioning is formulated with integer linear programming. Due to its NP-hardness, we propose a low-complex particle-swarm-optimization-based metaheuristic and a greedy heuristic. Our solutions aim to optimize the number of served end-users with a predefined delay-threshold while considering dynamic fog nodes behavior/mobility and resources availability of fog nodes. Using real-world mobility data sets and different resources’ availability models, conducted simulations demonstrate that the PSO-based algorithm achieves near-optimal results. Whereas, the greedy algorithm realizes only 10%–30% less success ratio than the optimal solution with negligible execution time.

Joint Container Placement and Task Provisioning in Dynamic Fog Computing

Aerial platforms are expected to deliver enhanced and seamless connectivity in the fifth generation (5G) wireless networks and beyond (B5G). Alternatively, reconfigurable smart surfaces (RSS), which smartly exploit/recycle signal reflections in the environment, are increasingly being recognized as a new wireless communication paradigm to improve communication links. In fact, their reduced cost, low power use, light weight, and flexible deployment make them an attractive candidate for integration with 5G/B5G technologies. In this article, we discuss comprehensive approaches to the integration of RSS in aerial platforms. First, we present a review of RSS technology, its operations, and types of communication. Next, we describe how RSS can be used in aerial platforms, and we propose a control architecture workflow. Then several potential use cases are presented and discussed. Finally, associated research challenges are identified.

Aerial Platforms with Reconfigurable Smart Surfaces for 5G and Beyond

Recently, interest on the utilization of unmanned aerial vehicles (UAVs) has aroused. Specifically, UAVs can be used in cellular networks as aerial users for delivery, surveillance, rescue search, or as an aerial base station (aBS) for communication with ground users in remote uncovered areas or in dense environments requiring prompt high capacity. Aiming to satisfy the high requirements of wireless aerial networks, several multiple access techniques have been investigated. In particular, space-division multiple access (SDMA) and power-domain non-orthogonal multiple access (NOMA) present promising multiplexing gains for aerial downlink and uplink. Nevertheless, these gains are limited as they depend on the conditions of the environment. Hence, a generalized scheme has been recently proposed, called rate-splitting multiple access (RSMA), which is capable of achieving better spectral efficiency gains compared to SDMA and NOMA. In this paper, we present a comprehensive survey of key multiple access technologies adopted for aerial networks, where aBSs are deployed to serve ground users. Since there have been only sporadic results reported on the use of RSMA in aerial systems, we aim to extend the discussion on this topic by modelling and analyzing the weighted sum-rate performance of a two-user network served by an RSMA-based aBS. Finally, related open issues and future research directions are exposed.

/pdf/multiple-access-in-aerial-networks-from-orthogonal-and-non-4v4nk2q2hp.pdf

Multiple Access in Aerial Networks: From Orthogonal and Non-Orthogonal to Rate-Splitting

The use of unmanned aerial vehicles (UAVs) as base stations (BSs) is envisaged as a key enabler for the fifth generation (5G) and beyond-5G networks. Specifically, aerial base stations (UAV-BS) are expected to provide ubiquitous connectivity and high spectral efficiency. To this end, we present in this correspondence an in-depth look into the integration of rate-splitting multiple access (RSMA) with UAV-BSs and downlink transmissions. A non-convex problem of joint UAV placement, RSMA precoding, and rate splitting, aiming to maximize the weighted sum data rate of users is formulated. Due to its complexity, two sub-problems are investigated, namely the UAV placement and RSMA parameters optimization. The resulting solutions are then combined to propose a novel alternating optimization method. Simulation results illustrate the latter's efficiency compared to baseline approaches.

On the Downlink Performance of RSMA-Based UAV Communications

The increased proliferation of connected devices requires a development of innovative technologies for the next generation of wireless systems. One of the key challenges, however, is the spectrum scarcity, owing to the unprecedented broadband penetration rate in recent years. Based on this, visible light communication (VLC) has recently emerged as an effective potential solution for enabling high-speed short-range communications. Yet, despite their undoubted advantageous features, VLC systems suffer from several limitations which constraint their capabilities. As a result, several multiple access (MA) techniques, such as space-division multiple access (SDMA) and non-orthogonal multiple access (NOMA), have been considered in VLC networks as an effective approach, among others, to circumvent these limitations. However, despite their achievable multiplexing gain, their overall performance is still limited compared to the overall potential of this technology. Motivated by this, the presented article offers two contributions: firstly, we provide an overview of the key MA technologies used in VLC systems and then we introduce rate-splitting multiple access (RSMA), and discuss its capabilities and potentials in VLC systems. Secondly, through realistic system modeling and simulations of an RSMA-based two-user scenario, we illustrate the flexibility of RSMA as well as its superiority in terms of the achievable weighted sum rate over NOMA and SDMA in the context of VLC. Finally, we discuss technical challenges, open issues, and research directions, along with the offered results and insights that are expected to be useful towards the effective practical realization of RSMA in VLC configurations.

Wael Jaafar

Papers

Joint Container Placement and Task Provisioning in Dynamic Fog Computing

Aerial Platforms with Reconfigurable Smart Surfaces for 5G and Beyond

Multiple Access in Aerial Networks: From Orthogonal and Non-Orthogonal to Rate-Splitting

On the Downlink Performance of RSMA-Based UAV Communications

Rate-Splitting Multiple Access: Unifying NOMA and SDMA in MISO VLC Channels