Wesley Williams

Bio: Wesley Williams is an academic researcher from Louisiana State University. The author has contributed to research in topics: Nanofluid & Convective heat transfer. The author has an hindex of 11, co-authored 43 publications receiving 854 citations. Previous affiliations of Wesley Williams include Massachusetts Institute of Technology & Oak Ridge National Laboratory.

Experimental Investigation of Turbulent Convective Heat Transfer and Pressure Loss of Alumina/Water and Zirconia/Water Nanoparticle Colloids (Nanofluids) in Horizontal Tubes

Abstract: The turbulent convective heat transfer behavior of alumina (Al 2 O 3 ) and zirconia (ZrO 2 ) nanoparticle dispersions in water is investigated experimentally in a flow loop with a horizontal tube test section at various flow rates (9000

Mean-field versus microconvection effects in nanofluid thermal conduction.

Abstract: Transient hot-wire data on thermal conductivity of suspensions of silica and perfluorinated particles show agreement with the mean-field theory of Maxwell but not with the recently postulated microconvection mechanism. The influence of interfacial thermal resistance, convective effects at microscales, and the possibility of thermal conductivity enhancements beyond the Maxwell limit are discussed.

Transient and Steady-State Experimental Comparison Study of Effective Thermal Conductivity of Al2O3∕Water Nanofluids

Abstract: Nanofluids are being studied for their potential to enhance heat transfer, which could have a significant impact on energy generation and storage systems. However, only limited experimental data on metal and metal-oxide based nanofluids, showing enhancement of the thermal conductivity, are currently available. Moreover, the majority of the data currently available have been obtained using transient methods. Some controversy exists as to the validity of the measured enhancement and the possibility that this enhancement may be an artifact of the experimental methodology. In the current investigation, Al 2 O 3 /water nanofluids with normal diameters of 47 nm at different volume fractions (0.5%, 2%, 4%, and 6%) have been investigated, using two different methodologies: a transient hot-wire method and a steady-state cut-bar method. The comparison of the measured data obtained using these two different experimental systems at room temperature was conducted and the experimental data at higher temperatures were obtained with steady-state cut-bar method and compared with previously reported data obtained using a transient hot-wire method. The arguments that the methodology is the cause of the observed enhancement of nanofluids effective thermal conductivity are evaluated and resolved. It is clear from the results that at room temperature, both the steady-state cut-bar and transient hot-wire methods result in nearly identical values for the effective thermal conductivity of the nanofluids tested, while at higher temperatures, the onset of natural convection results in larger measured effective thermal conductivities for the hot-wire method than those obtained using the steady-state cut-bar method. The experimental data at room temperature were also compared with previously reported data at room temperature and current available theoretical models, and the deviations of experimental data from the predicted values are presented and discussed.

Numerical Analysis of Convective Instabilities in a Transient Short-Hot-Wire Setup for Measurement of Liquid Thermal Conductivity

Abstract: Numerical simulation has been used to investigate the effects of natural convection on measurements of the thermal conductivity of fluids by transient hot-wire methods. Comparison of the numerical data with the experimental results obtained with a custom-built setup exploiting a short-wire geometry allows fixing an operationally useful time scale, where convective effects can be safely neglected.

Distributed Fiber Optic Sensing for Real-Time Monitoring of Gas in Riser during Offshore Drilling.

Abstract: Effective well control depends on the drilling teams' knowledge of wellbore flow dynamics and their ability to predict and control influx. Unfortunately, detection of a gas influx in an offshore environment is particularly challenging, and there are no existing datasets that have been verified and validated for gas kick migration at full-scale annular conditions. This study bridges this gap and presents pioneering research in the application of fiber optic sensing for monitoring gas in riser. The proposed sensing paradigm was validated through well-scale experiments conducted at Petroleum Engineering Research & Technology Transfer lab (PERTT) facility at Louisiana State University (LSU), simulating an offshore marine riser environment with its larger than average annular space and mud circulation capability. The experimental setup instrumented with distributed fiber optic sensors and pressure/temperature gauges provides a physical model to study the dynamic gas migration in full-scale annular conditions. Current kick detection methods primarily utilize surface measurements and do not always reliably detect a gas influx. The proposed application of distributed fiber optic sensing overcomes this key limitation of conventional kick detection methods, by providing real-time distributed downhole data for accurate and reliable monitoring. The two-phase flow experiments conducted in this research provide critical insights for understanding the flow dynamics in offshore drilling riser conditions, and the results provide an indication of how quickly gas can migrate in a marine riser scenario, warranting further investigation for the sake of effective well control.

A benchmark study on the thermal conductivity of nanofluids

Abstract: This article reports on the International Nanofluid Property Benchmark Exercise, or INPBE, in which the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or “nanofluids,” was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady-state methods, and optical methods. The nanofluids tested in the exercise were comprised of aqueous and nonaqueous basefluids, metal and metal oxide particles, near-spherical and elongated particles, at low and high particle concentrations. The data analysis reveals that the data from most organizations lie within a relatively narrow band (±10% or less) about the sample average with only few outliers. The thermal conductivity of the nanofluids was found to increase with particle concentration and aspect ratio, as expected from classical theory. There are (small) systematic differences in the absolute values of the nanofluid thermal conductivity among the various experimental approaches; however, such differences tend to disappear when the data are normalized to the measured thermal conductivity of the basefluid. The effective medium theory developed for dispersed particles by Maxwell in 1881 and recently generalized by Nan et al. [J. Appl. Phys. 81, 6692 (1997)], was found to be in good agreement with the experimental data, suggesting that no anomalous enhancement of thermal conductivity was achieved in the nanofluids tested in this exercise.

A Benchmark Study on the Thermal Conductivity of Nanofluids

Abstract: This article reports on the International Nanofluid Property Benchmark Exercise, or INPBE, in which the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or “nanofluids,” was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady-state methods, and optical methods. The nanofluids tested in the exercise were comprised of aqueous and nonaqueous basefluids, metal and metal oxide particles, near-spherical and elongated particles, at low and high particle concentrations. The data analysis reveals that the data from most organizations lie within a relatively narrow band (±10% or less) about the sample average with only few outliers. The thermal conductivity of the nanofluids was found to increase with particle concentration and aspect ratio, as expected from classical theory. There are (small) systematic differences in the absolute values of the nanofluid thermal conductivity among the various experimental approaches; however, such differences tend to disappear when the data are normalized to the measured thermal conductivity of the basefluid. The effective medium theory developed for dispersed particles by Maxwell in 1881 and recently generalized by Nan et al. [J. Appl. Phys. 81, 6692 (1997)], was found to be in good agreement with the experimental data, suggesting that no anomalous enhancement of thermal conductivity was achieved in the nanofluids tested in this exercise.

Particle shape effects on thermophysical properties of alumina nanofluids

Abstract: The thermal conductivity and viscosity of various shapes of alumina nanoparticles in a fluid consisting of equal volumes of ethylene glycol and water were investigated. Experimental data were analyzed and accompanied by theoretical modeling. Enhancements in the effective thermal conductivities due to particle shape effects expected from Hamilton–Crosser equation are strongly diminished by interfacial effects proportional to the total surface area of nanoparticles. On the other hand, the presence of nanoparticles and small volume fractions of agglomerates with high aspect ratios strongly increases viscosity of suspensions due to structural constrains. Nanoparticle surface charge also plays an important role in viscosity. It is demonstrated that by adjusting pH of nanofluid, it is possible to reduce viscosity of alumina nanofluid without significantly affecting thermal conductivity. Efficiency of nanofluids (ratio of thermal conductivity and viscosity increase) for real-life cooling applications is evaluate...