Xiaochen Ge

Bio: Xiaochen Ge is an academic researcher from University of Texas at Arlington. The author has contributed to research in topics: Photonic crystal & Monolayer. The author has an hindex of 11, co-authored 30 publications receiving 1503 citations. Previous affiliations of Xiaochen Ge include Zhejiang University & Nanyang Technological University.

Ultra-broadband Microwave Metamaterial Absorber

Abstract: A microwave ultra-broadband polarization-independent metamaterial absorber is demonstrated. It is composed of a periodic array of metal-dielectric multilayered quadrangular frustum pyramids. These pyramids possess resonant absorption modes at multi-frequencies, of which the overlapping leads to the total absorption of the incident wave over an ultra-wide spectral band. The experimental absorption at normal incidence is above 90% in the frequency range of 7.8-14.7GHz, and the absorption is kept large when the incident angle is smaller than 60 degrees. The experimental results agree well with the numerical simulation.

Ultra-broadband microwave metamaterial absorber

Abstract: A microwave ultra-broadband polarization-independent metamaterial absorber is demonstrated. It is composed of a periodic array of metal-dielectric multilayered quadrangular frustum pyramids. These pyramids possess resonant absorption modes at multi-frequencies, of which the overlapping leads to the total absorption of the incident wave over an ultra-wide spectral band. The experimental absorption at normal incidence is above 90% in the frequency range of 7.8–14.7 GHz, and the absorption is kept large when the incident angle is smaller than 60°. The experimental results agree well with the numerical simulation.

Flexible Transient Optical Waveguides and Surface-Wave Biosensors Constructed from Monocrystalline Silicon.

Abstract: Optical technologies offer important capabilities in both biological research and clinical care. Recent interest is in implantable devices that provide intimate optical coupling to biological tissues for a finite time period and then undergo full bioresorption into benign products, thereby serving as temporary implants for diagnosis and/or therapy. The results presented here establish a silicon-based, bioresorbable photonic platform that relies on thin filaments of monocrystalline silicon encapsulated by polymers as flexible, transient optical waveguides for accurate light delivery and sensing at targeted sites in biological systems. Comprehensive studies of the mechanical and optical properties associated with bending and unfurling the waveguides from wafer-scale sources of materials establish general guidelines in fabrication and design. Monitoring biochemical species such as glucose and tracking physiological parameters such as oxygen saturation using near-infrared spectroscopic methods demonstrate modes of utility in biomedicine. These concepts provide versatile capabilities in biomedical diagnosis, therapy, deep-tissue imaging, and surgery, and suggest a broad range of opportunities for silicon photonics in bioresorbable technologies.

Kinetics of Stop-Flow Atomic Layer Deposition for High Aspect Ratio Template Filling through Photonic Band Gap Measurements

Abstract: Atomic layer deposition (ALD) is shown as a unique method to produce high aspect ratio (AR) nanostructures through conformal filling and replication of high AR templates. The stop-flow process is often used as an alternative to the conventional continuous flow process to obtain high step coverage. However, there is a need for understanding the deposition kinetics and optimizing the deposition process to fabricate defect-free nanostructures. In this Article, TiO2 ALD in high AR self-assembled opal photonic crystal templates was performed in stop-flow fill−hold−purge process in comparison with continuous flow pulse−purge process. Photonic band gap properties of opal templates were characterized and compared with simulated band diagrams for quantitative investigation of filling kinetics and the effect of shrinking pore size on filling uniformity. Γ−L bands in the transmittance spectra of ALD-infiltrated opals accurately represented the depth profile of the depositions without the need for expensive sample pr...

Microcavity-coupled emitters in hexagonal boron nitride

Abstract: Abstract Integration of quantum emitters in photonic structures is an important step in the broader quest to generate and manipulate on-demand single photons via compact solid-state devices. Unfortunately, implementations relying on material platforms that also serve as the emitter host often suffer from a tradeoff between the desired emitter properties and the photonic system practicality and performance. Here, we demonstrate “pick and place” integration of a Si3N4 microdisk optical resonator with a bright emitter host in the form of ∼20-nm-thick hexagonal boron nitride (hBN). The film folds around the microdisk maximizing contact to ultimately form a hybrid hBN/Si3N4 structure. The local strain that develops in the hBN film at the resonator circumference deterministically activates a low density of defect emitters within the whispering gallery mode volume of the microdisk. These conditions allow us to demonstrate cavity-mediated out-coupling of emission from defect states in hBN through the microdisk cavity modes. Our results pave the route toward the development of chip-scale quantum photonic circuits with independent emitter/resonator optimization for active and passive functionalities.

Crystallinity of inorganic films grown by atomic layer deposition: Overview and general trends

Abstract: Atomic layer deposition (ALD) is gaining attention as a thin film deposition method, uniquely suitable for depositing uniform and conformal films on complex three-dimensional topographies. The deposition of a film of a given material by ALD relies on the successive, separated, and self-terminating gas–solid reactions of typically two gaseous reactants. Hundreds of ALD chemistries have been found for depositing a variety of materials during the past decades, mostly for inorganic materials but lately also for organic and inorganic–organic hybrid compounds. One factor that often dictates the properties of ALD films in actual applications is the crystallinity of the grown film: Is the material amorphous or, if it is crystalline, which phase(s) is (are) present. In this thematic review, we first describe the basics of ALD, summarize the two-reactant ALD processes to grow inorganic materials developed to-date, updating the information of an earlier review on ALD [R. L. Puurunen, J. Appl. Phys. 97, 121301 (2005)], and give an overview of the status of processing ternary compounds by ALD. We then proceed to analyze the published experimental data for information on the crystallinity and phase of inorganic materials deposited by ALD from different reactants at different temperatures. The data are collected for films in their as-deposited state and tabulated for easy reference. Case studies are presented to illustrate the effect of different process parameters on crystallinity for representative materials: aluminium oxide, zirconium oxide, zinc oxide, titanium nitride, zinc zulfide, and ruthenium. Finally, we discuss the general trends in the development of film crystallinity as function of ALD process parameters. The authors hope that this review will help newcomers to ALD to familiarize themselves with the complex world of crystalline ALD films and, at the same time, serve for the expert as a handbook-type reference source on ALD processes and film crystallinity.

Quantum emission from hexagonal boron nitride monolayers

Abstract: We demonstrate first room temperature, and ultrabright single photon emission from a color center in two-dimensional multilayer hexagonal boron nitride. Density Functional Theory calculations indicate that vacancy-related centers are a likely source of the emission.

Plasmonic and metamaterial structures as electromagnetic absorbers

Abstract: Electromagnetic absorbers have drawn increasing attention in many areas. A series of plasmonic and metamaterial structures can work as efficient narrowband absorbers due to the excitation of plasmonic or photonic resonances, providing a great potential for applications in designing selective thermal emitters, biosensing, etc. In other applications such as solar-energy harvesting and photonic detection, the bandwidth of light absorbers is required to be quite broad. Under such a background, a variety of mechanisms of broadband/multiband absorption have been proposed, such as mixing multiple resonances together, exciting phase resonances, slowing down light by anisotropic metamaterials, employing high loss materials and so on.

Plasmonic and Metamaterial Structures as Electromagnetic Absorbers

Abstract: Electromagnetic absorbers have drawn increasing attention in many areas. A series of plasmonic and metamaterial structures can work as efficient narrow band absorbers due to the excitation of plasmonic or photonic resonances, providing a great potential for applications in designing selective thermal emitters, bio-sensing, etc. In other applications such as solar energy harvesting and photonic detection, the bandwidth of light absorbers is required to be quite broad. Under such a background, a variety of mechanisms of broadband/multiband absorption have been proposed, such as mixing multiple resonances together, exciting phase resonances, slowing down light by anisotropic metamaterials, employing high loss materials and so on.

A Metamaterial Emitter for Highly Efficient Radiative Cooling

Abstract: A metamaterial thermal emitter for highly efficient radiative cooling is demonstrated. The emitter selectively radiates within the atmospheric transparency window and minimizes absorption of atmospheric radiation outside the transparency window. Exploiting its intriguing radiative properties, the emitter has the ability to deliver a remarkably high cooling power of more than 100 W m−2 and to cool down 12 °C below the ambient temperature.