Xueqiang Qi

Bio: Xueqiang Qi is an academic researcher from Chongqing University of Technology. The author has contributed to research in topics: Catalysis & Electrocatalyst. The author has an hindex of 22, co-authored 49 publications receiving 2572 citations. Previous affiliations of Xueqiang Qi include Chongqing University.

Space-confinement-induced synthesis of pyridinic- and pyrrolic-nitrogen-doped graphene for the catalysis of oxygen reduction

Abstract: The development of high-performance and low-cost catalytic materials for the oxygen reduction reaction (ORR) has been a major challenge for the large-scale application of fuel cells. Currently, platinum and platinum-based alloys are the most efficient ORR catalysts in fuel-cell cathodes; however, they cannot meet the demand for the widespread commercialization of fuel cells because of the scarcity of platinum. Thus, the ongoing search for platinum-free catalysts for the ORR has attracted much attention. Graphene, single-layer sheets of sp-hybridized carbon atoms, has attracted tremendous attention and research interest. The abundance of free-flowing p electrons in carbon materials composed of sp-hybridized carbon atoms makes these materials potential catalysts for reactions that require electrons, such as the ORR. However, these p electrons are too inert to be used directly in the ORR. In N-doped electron-rich carbon nanostructures, carbon p electrons have been shown to be activated through conjugation with lone-pair electrons from N dopants; thus, O2 molecules are reduced on the positively charged C atoms that neighbor N atoms. Recently, Hu and co-workers found that as long as the electroneutrality of the sp-hybridized carbon atoms is broken and charged sites that favor O2 adsorption are created, these materials will be transformed into active metal-free ORR electrocatalysts regardless of whether the dopants are electron-rich (e.g., N) or electrondeficient (e.g., B). Nitrogen-doped carbon (NC) materials are considered to be promising catalysts because of their acceptable ORR activity, low cost, good durability, and environmental friendliness. However, their ORR activity is less competitive, especially in acidic media. Relative to commercial Pt/C, the difference in the half-wave potential for ORR is within 25 mV in alkaline electrolytes but is greater than 200 mV in acidic electrolytes. The activity of NC materials can be enhanced through efficient N doping with sufficient active species that favor ORR and through an increase in electrical conductivity. The annealing of graphitized carbon materials, such as carbon nanotubes and microporous carbon black, in NH3 leads to insufficient substitution of nitrogen because of the well-ordered structure of the host materials. Alternatively, the direct pyrolysis of nitrogen-containing hydrocarbons or polymers produces NC materials with good incorporation of nitrogen. However, suitable pyrolysis temperatures are difficult to pinpoint; without optimization, temperatures that are excessively low or excessively high lead to low electronic conductivity or a remarkable loss of active N species, respectively. Recently, mesoporous-alumina-assisted and silica-template-assisted nitrogen incorporation, which can preserve a high content of N in synthesized NC materials, have been reported. However the activities of the resulting NC materials in the ORR were still significantly lower than that of Pt/C, even when the N content was as high as 10.7 atm%. Among three types of N atoms, that is, pyridinic, pyrrolic, and quaternary N, only the pyridinic and pyrrolic forms, which have planar structures, have been proven to be active in the ORR. In contrast, quaternary N atoms, which possess a 3D structure, are not active in the ORR. The low electrical conductivity of NC materials with quaternary N atoms results from the interruption of their p–p conjugation by the 3D structure and is thought to be predominantly responsible for the poor catalysis. Therefore, the synthesis of NC materials with more planar pyridinic and pyrrolic N atoms and fewer quaternary N atoms is important for the preparation of ORR-active catalysts. Herein, we present a novel strategy for the selective synthesis of pyridinicand pyrrolic-nitrogen-doped graphene (NG) by the use of layered montmorillonite (MMT) as a quasi-closed flat nanoreactor, which is open only along the perimeter to enable the entrance of aniline (AN) monomer molecules. The flat MMT nanoreactor, which is less than 1 nm thick, extensively constrains the formation of quaternary N because of its 3D structure but facilitates the formation of pyridinic and pyrrolic N. Nitrogen is well-known to be incorporated into quaternary N in tetrahedral sp hybridization but incorporated into pyridinic and pyrrolic N in planar sp hybridization. The confinement effect of MMT ensures that N is incorporated into the structure and that the graphitization is successful without significant loss of N species. Furthermore, planar pyridinic and pyrrolic N can be [*] Dr. W. Ding, Prof. Z.-D. Wei, Dr. S.-G. Chen, Dr. X.-Q. Qi, Dr. T. Yang, Dr. S. F. Alvi, Dr. L. Li The State Key Laboratory of Power Transmission Equipment and System Security and New Technology, College of Chemistry and Chemical Engineering, Chongqing University Shapingba 174, Chongqing (China) E-mail: zdwei@cqu.edu.cn

Nanostructured Polyaniline-Decorated Pt/C@PANI Core-Shell Catalyst with Enhanced Durability and Activity

Abstract: We have designed and synthesized a polyaniline (PANI)-decorated Pt/C@PANI core-shell catalyst that shows enhanced catalyst activity and durability compared with nondecorated Pt/C. The experimental results demonstrate that the activity for the oxygen reduction reaction strongly depends on the thickness of the PANI shell and that the greatest enhancement in catalytic properties occurs at a thickness of 5 nm, followed by 2.5, 0, and 14 nm. Pt/C@PANI also demonstrates significantly improved stability compared with that of the unmodified Pt/C catalyst. The high activity and stability of the Pt/C@PANI catalyst is ascribed to its novel PANI-decorated core-shell structure, which induces both electron delocalization between the Pt d orbitals and the PANI π-conjugated ligand and electron transfer from Pt to PANI. The stable PANI shell also protects the carbon support from direct exposure to the corrosive environment.

Shape Fixing via Salt Recrystallization: A Morphology-Controlled Approach To Convert Nanostructured Polymer to Carbon Nanomaterial as a Highly Active Catalyst for Oxygen Reduction Reaction

Abstract: Herein, we report a “shape fixing via salt recrystallization” method to efficiently synthesize nitrogen-doped carbon material with a large number of active sites exposed to the three-phase zones, for use as an ORR catalyst. Self-assembled polyaniline with a 3D network structure was fixed and fully sealed inside NaCl via recrystallization of NaCl solution. During pyrolysis, the NaCl crystal functions as a fully sealed nanoreactor, which facilitates nitrogen incorporation and graphitization. The gasification in such a closed nanoreactor creates a large number of pores in the resultant samples. The 3D network structure, which is conducive to mass transport and high utilization of active sites, was found to have been accurately transferred to the final N-doped carbon materials, after dissolution of the NaCl. Use of the invented cathode catalyst in a proton exchange membrane fuel cell produces a peak power of 600 mW cm–2, making this among the best nonprecious metal catalysts for the ORR reported so far. Furth...

Insight into the Effect of Oxygen Vacancy Concentration on the Catalytic Performance of MnO2

Abstract: Oxygen vacancies (OVs) are important for changing the geometric and electronic structures as well as the chemical properties of MnO2. In this study, we performed a DFT+U calculation on the electronic structure and catalytic performance of a β-MnO2 catalyst for the oxygen reduction reaction (ORR) with different numbers and extents of OVs. Comparing those results with the experimental XRD analysis, we determined that OVs produce a new crystalline phase of β-MnO2. Changes in the electronic structure (Bader charges, band structure, partial density of states, local density of states, and frontier molecular orbital), proton insertion, and oxygen adsorption in β-MnO2 (110) were investigated as a function of the bulk OVs. The results show that a moderate concentration of bulk OVs reduced the band gap, increased the Fermi and HOMO levels of the MnO2 (or MnOOH), and elongated the O–O bond of the adsorbed O2 and coadsorbed O2 with H. These changes substantially increase the conductivity of MnO2 for the catalysis of ...

A Strategy to Promote the Electrocatalytic Activity of Spinels for Oxygen Reduction by Structure Reversal

Abstract: The electrocatalytic performance of a spinel for the oxygen reduction reaction (ORR) can be significantly promoted by reversing its crystalline structure from the normal to the inverse. As the spinel structure reversed, the activation and cleavage of O-O bonds are accelerated owing to a dissimilarity effect of the distinct metal atoms co-occupying octahedral sites. The Co(II)Fe(III)Co(III)O4 spinel with the Fe and Co co-occupying inverse structure exhibits an excellent ORR activity, which even exceeds that of the state-of-the-art commercial Pt/C by 42 mV in alkaline medium.

Active sites of nitrogen-doped carbon materials for oxygen reduction reaction clarified using model catalysts

Abstract: Nitrogen (N)-doped carbon materials exhibit high electrocatalytic activity for the oxygen reduction reaction (ORR), which is essential for several renewable energy systems. However, the ORR active site (or sites) is unclear, which retards further developments of high-performance catalysts. Here, we characterized the ORR active site by using newly designed graphite (highly oriented pyrolitic graphite) model catalysts with well-defined π conjugation and well-controlled doping of N species. The ORR active site is created by pyridinic N. Carbon dioxide adsorption experiments indicated that pyridinic N also creates Lewis basic sites. The specific activities per pyridinic N in the HOPG model catalysts are comparable with those of N-doped graphene powder catalysts. Thus, the ORR active sites in N-doped carbon materials are carbon atoms with Lewis basicity next to pyridinic N.

Recent Advances in Electrocatalysts for Oxygen Reduction Reaction

Abstract: The recent advances in electrocatalysis for oxygen reduction reaction (ORR) for proton exchange membrane fuel cells (PEMFCs) are thoroughly reviewed. This comprehensive Review focuses on the low- and non-platinum electrocatalysts including advanced platinum alloys, core–shell structures, palladium-based catalysts, metal oxides and chalcogenides, carbon-based non-noble metal catalysts, and metal-free catalysts. The recent development of ORR electrocatalysts with novel structures and compositions is highlighted. The understandings of the correlation between the activity and the shape, size, composition, and synthesis method are summarized. For the carbon-based materials, their performance and stability in fuel cells and comparisons with those of platinum are documented. The research directions as well as perspectives on the further development of more active and less expensive electrocatalysts are provided.

Metal-free bifunctional electrocatalyst for oxygen reduction and oxygen evolution reactions

Abstract: A co-doped carbon material, methods of making such materials, and electrochemical cells and devices comprising such materials are provided. The co-doped carbon material comprises a mesoporous carbon material doped with nitrogen and phoshporous (NPMC). The present NPMC exhibit catalytic activity for both oxygen reduction reaction and oxygen evolution reaction and may be useful as an electrode in an electrochemical cell and particularly as part of a battery. The present NPMC materials may be used as electrodes in primary zinc-air batteries and in rechargeable zinc-air batteries and many other energy systems.

Metal-free catalysts for oxygen reduction reaction.

Abstract: Liming Dai,*,†,‡ Yuhua Xue,†,‡ Liangti Qu,* Hyun-Jung Choi, and Jong-Beom Baek* †Center of Advanced Science and Engineering for Carbon (Case4Carbon), Department of Macromolecular Science and Engineering, Case Western Reserve University, 10900 Euclid Avenue, Cleveland, Ohio 44106, United States Key Laboratory of Cluster Science, Ministry of Education of China, Beijing Key Laboratory of Photoelectronic/Electrophotonic Conversion Materials, Department of Chemistry, School of Science, Beijing Institute of Technology, Beijing 100081, People’s Republic of China School of Energy and Chemical Engineering/Center for Dimension-Controllable Covalent Organic Frameworks, Ulsan National Institute of Science and Technology (UNIST), 100 Banyeon, Ulsan, 689-798, South Korea