Author
Yongli Gao
Other affiliations: Hebrew University of Jerusalem, Purdue University, Central South University ...read more
Bio: Yongli Gao is an academic researcher from University of Rochester. The author has contributed to research in topics: Photoemission spectroscopy & Thin film. The author has an hindex of 65, co-authored 480 publications receiving 18523 citations. Previous affiliations of Yongli Gao include Hebrew University of Jerusalem & Purdue University.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this article, an interdiffusion method was proposed to fabricate pinhole free perovskite films using a low temperature solution process, achieving an efficiency of 15.4% with a fill factor of ∼80%.
Abstract: We report on an interdiffusion method to fabricate pin-hole free perovskite films using a low temperature (<105 °C) solution process. A high efficiency of 15.4%, with a fill factor of ∼80%, was achieved for the devices under one sun illumination. The interdiffusion method results in high device yield, with an efficiency of above 14.5% for more than 85% of the devices.
1,141 citations
TL;DR: In this paper, single-crystal perovskite devices 2-3 mm thick exhibit 16.4% X-ray detection efficiency with sensitivity four times higher than α-Se detectors.
Abstract: Single-crystal perovskite devices 2–3 mm thick exhibit 16.4% X-ray detection efficiency with sensitivity four times higher than α-Se X-ray detectors.
1,136 citations
TL;DR: Li et al. as discussed by the authors employed fluoride to simultaneously passivate both anion and cation vacancies, by taking advantage of the extremely high electronegativity of fluoride, and obtained a power conversion efficiency of 21.46% (and a certified 21.3%-efficient cell) in a device based on the caesium, methylammonium (MA), and formamidinium (FA) triple-cation perovskite (Cs0.05FA0.41)Pb(I0.98Br0.02)3 treated with sodium
Abstract: Defects play an important role in the degradation processes of hybrid halide perovskite absorbers, impeding their application for solar cells. Among all defects, halide anion and organic cation vacancies are ubiquitous, promoting ion diffusion and leading to thin-film decomposition at surfaces and grain boundaries. Here, we employ fluoride to simultaneously passivate both anion and cation vacancies, by taking advantage of the extremely high electronegativity of fluoride. We obtain a power conversion efficiency of 21.46% (and a certified 21.3%-efficient cell) in a device based on the caesium, methylammonium (MA) and formamidinium (FA) triple-cation perovskite (Cs0.05FA0.54MA0.41)Pb(I0.98Br0.02)3 treated with sodium fluoride. The device retains 90% of its original power conversion efficiency after 1,000 h of operation at the maximum power point. With the help of first-principles density functional theory calculations, we argue that the fluoride ions suppress the formation of halide anion and organic cation vacancies, through a unique strengthening of the chemical bonds with the surrounding lead and organic cations. Defects and defect migration are detrimental for perovskite solar cell efficiency and long-term stability. Li et al. show that fluoride is able to suppress the formation of halide anion and organic cation vacancy defects by restraining the relative ions via ionic and hydrogen bonds.
723 citations
TL;DR: In this paper, the authors used ultraviolet and x-ray photoelectron spectroscopy (XPS) and (UPS) techniques to directly measure absolute values of vacuum work function of indium tin oxide (ITO) thin films.
Abstract: We used ultraviolet and x‐ray photoelectron spectroscopy (XPS) and (UPS) techniques to directly measure absolute values of vacuum work function of indium tin oxide (ITO) thin films. We obtained a work function of 4.4–4.5 eV which is lower than the commonly cited value. These values do not change substantially by heating and Ar ion sputtering. The atomic concentrations of each element in ITO, measured with XPS, are also quite stable under heat treatment and ion sputtering.
620 citations
TL;DR: Th Thin lead oxysalt layers passivate hybrid perovskite surfaces under an ambient atmosphere and enhance solar cell efficiency and formation of the lead oxYSalt layer increases the carrier recombination lifetime and boosts the efficiency of the solar cells to 21.1%.
Abstract: We show that converting the surfaces of lead halide perovskite to water-insoluble lead (II) oxysalt through reaction with sulfate or phosphate ions can effectively stabilize the perovskite surface and bulk material. These capping lead oxysalt thin layers enhance the water resistance of the perovskite films by forming strong chemical bonds. The wide-bandgap lead oxysalt layers also reduce the defect density on the perovskite surfaces by passivating undercoordinated surface lead centers, which are defect-nucleating sites. Formation of the lead oxysalt layer increases the carrier recombination lifetime and boosts the efficiency of the solar cells to 21.1%. Encapsulated devices stabilized by the lead oxysalt layers maintain 96.8% of their initial efficiency after operation at maximum power point under simulated air mass (AM) 1.5 G irradiation for 1200 hours at 65°C.
532 citations
Cited by
More filters
Journal Article•
28,685 citations
TL;DR: In this paper, the basic theoretical aspects of graphene, a one-atom-thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations, are discussed.
Abstract: This article reviews the basic theoretical aspects of graphene, a one-atom-thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations. The Dirac electrons can be controlled by application of external electric and magnetic fields, or by altering sample geometry and/or topology. The Dirac electrons behave in unusual ways in tunneling, confinement, and the integer quantum Hall effect. The electronic properties of graphene stacks are discussed and vary with stacking order and number of layers. Edge (surface) states in graphene depend on the edge termination (zigzag or armchair) and affect the physical properties of nanoribbons. Different types of disorder modify the Dirac equation leading to unusual spectroscopic and transport properties. The effects of electron-electron and electron-phonon interactions in single layer and multilayer graphene are also presented.
20,824 citations
TL;DR: The interest in nanoscale materials stems from the fact that new properties are acquired at this length scale and, equally important, that these properties are equally important.
Abstract: The interest in nanoscale materials stems from the fact that new properties are acquired at this length scale and, equally important, that these properties * To whom correspondence should be addressed. Phone, 404-8940292; fax, 404-894-0294; e-mail, mostafa.el-sayed@ chemistry.gatech.edu. † Case Western Reserve UniversitysMillis 2258. ‡ Phone, 216-368-5918; fax, 216-368-3006; e-mail, burda@case.edu. § Georgia Institute of Technology. 1025 Chem. Rev. 2005, 105, 1025−1102
6,852 citations
TL;DR: Research in the use of organic polymers as active semiconductors in light-emitting diodes has advanced rapidly, and prototype devices now meet realistic specifications for applications.
Abstract: Research in the use of organic polymers as the active semiconductors in light-emitting diodes has advanced rapidly, and prototype devices now meet realistic specifications for applications. These achievements have provided insight into many aspects of the background science, from design and synthesis of materials, through materials fabrication issues, to the semiconductor physics of these polymers.
5,653 citations