Yongming Hu

Bio: Yongming Hu is an academic researcher from Hubei University. The author has contributed to research in topics: Materials science & Hydrogen. The author has an hindex of 26, co-authored 107 publications receiving 2810 citations. Previous affiliations of Yongming Hu include Hong Kong Polytechnic University.

WO3 nanorods/graphene nanocomposites for high-efficiency visible-light-driven photocatalysis and NO2 gas sensing

Abstract: One-dimensional (1-D) nanostructures are of great importance due to their superior charge transport properties. Anchoring 1-D semiconductor nanomaterials on graphene offers potential advantages in photoelectrochemical and sensing applications. This paper presents a systematic investigation on the incorporation of WO3 nanorods and graphene for high-efficiency visible-light-driven photocatalysis and NO2 gas sensing. This novel composite shows remarkably enhanced performance compared to pure WO3 nanorods for these applications. The high photocatalytic activity of the WO3/graphene nanocomposite is found to be related to the increased adsorption toward chemical species, enhanced light absorption and efficient charge separation and transfer. Meanwhile, the improved conductivity, specific electron transfer and increased gas adsorption also contribute to their superior sensitivity and selectivity to NO2 gas.

Hydrogen Gas Sensors Based on Semiconductor Oxide Nanostructures

Abstract: Recently, the hydrogen gas sensing properties of semiconductor oxide (SMO) nanostructures have been widely investigated. In this article, we provide a comprehensive review of the research progress in the last five years concerning hydrogen gas sensors based on SMO thin film and one-dimensional (1D) nanostructures. The hydrogen sensing mechanism of SMO nanostructures and some critical issues are discussed. Doping, noble metal-decoration, heterojunctions and size reduction have been investigated and proved to be effective methods for improving the sensing performance of SMO thin films and 1D nanostructures. The effect on the hydrogen response of SMO thin films and 1D nanostructures of grain boundary and crystal orientation, as well as the sensor architecture, including electrode size and nanojunctions have also been studied. Finally, we also discuss some challenges for the future applications of SMO nanostructured hydrogen sensors.

Ultraviolet Detectors Based on Wide Bandgap Semiconductor Nanowire: A Review.

Abstract: Ultraviolet (UV) detectors have attracted considerable attention in the past decade due to their extensive applications in the civil and military fields. Wide bandgap semiconductor-based UV detectors can detect UV light effectively, and nanowire structures can greatly improve the sensitivity of sensors with many quantum effects. This review summarizes recent developments in the classification and principles of UV detectors, i.e., photoconductive type, Schottky barrier type, metal-semiconductor-metal (MSM) type, p-n junction type and p-i-n junction type. The current state of the art in wide bandgap semiconductor materials suitable for producing nanowires for use in UV detectors, i.e., metallic oxide, III-nitride and SiC, during the last five years is also summarized. Finally, novel types of UV detectors such as hybrid nanostructure detectors, self-powered detectors and flexible detectors are introduced.

Highly Responsive Room-Temperature Hydrogen Sensing of α‑MoO3 Nanoribbon Membranes

Abstract: [001]-Oriented α-MoO3 nanoribbons were synthesized via hydrothermal method at temperature from 120 to 200 °C and following assembled a membrane on interdigital electrodes to form sensors. The sensitivity, response speed, and recovery speed of the sensor improve with the increasing hydrothermal temperature. Among them, the sample obtained at 200 °C exhibits a room-temperature response time of 14.1 s toward 1000 ppm of H2. The nanoribbons also show good selectivity against CO, ethanol, and acetone, as well as high sensitivity to H2 with a concentration as low as 500 ppb. The hydrogen sensing behavior is dependent on the redox reaction between the H2 and chemisorbed oxygen species. Higher hydrothermal temperature creates larger specific surface area and higher Mo5+ content, leading to increased chemisorbed oxygen species on the nanoribbon surface.

Nanoscale metal oxide-based heterojunctions for gas sensing: A review

Abstract: Metal oxide-based resistive-type gas sensors are solid-state devices which are widely used in a number of applications from health and safety to energy efficiency and emission control. Nanomaterials such as nanowires, nanorods, and nanoparticles have dominated the research focus in this field due to their large number of surface sites facilitating surface reactions. Previous studies have shown that incorporating two or more metal oxides to form a heterojunction interface can have drastic effects on gas sensor performance, especially the selectivity. Recently, these effects have been amplified by designing heterojunctions on the nano-scale. These designs have evolved from mixed commercial powders and bi-layer films to finely-tuned core–shell and hierarchical brush-like nanocomposites. This review details the various morphological classes currently available for nanostructured metal-oxide based heterojunctions and then presents the dominant electronic and chemical mechanisms that influence the performance of these materials as resistive-type gas sensors. Mechanisms explored include p–n and n–n potential barrier manipulation, n–p–n response type inversions, spill-over effects, synergistic catalytic behavior, and microstructure enhancement. Tables are presented summarizing these works specifically for SnO2, ZnO, TiO2, In2O3, Fe2O3, MoO3, Co3O4, and CdO-based nanocomposites. Recent developments are highlighted and likely future trends are explored.

Recent progress on graphene-based photocatalysts: current status and future perspectives

Abstract: Graphene (GR) has become a sparkling rising star on the horizon of material science. Due to its unique planar structure, excellent transparency, superior electron conductivity and mobility, high specific surface area, and high chemical stability, GR is regarded as an ideal high performance candidate to prepare GR-based nanocomposites for energy storage and conversion. During the past few years, GR-based photocatalysts have been attracting ever-increasing research attention. In this tutorial review, the applications of GR-based nanocomposites in photocatalysis, including nonselective processes for degradation of pollutants, selective transformations for organic synthesis and water splitting to clean hydrogen energy, are summarized systematically. In particular, in addition to discussing opportunities offered by GR, we will also describe the existing challenges for future exploitation and development of GR-based nanocomposites, which we hope would significantly advance us to rationally and efficiently harness the outstanding structural and electronic properties of GR to design smarter and more efficient GR-based photocatalysts instead of joining the graphene “gold rush”.