Young I. Cho

Bio: Young I. Cho is an academic researcher from Drexel University. The author has contributed to research in topics: Fouling & Blood viscosity. The author has an hindex of 42, co-authored 266 publications receiving 12349 citations. Previous affiliations of Young I. Cho include California Institute of Technology & Thomas Jefferson University Hospital.

Decontamination of Surfaces From Extremophile Organisms Using Nonthermal

Abstract: We showed that nonthermal dielectric barrier dis- charge (DBD) plasma compromises the integrity of the cell mem- brane of Deinococcus radiodurans, an extremophile organism. In samples of D. radiodurans, which were dried in a laminar flow hood, we observe that DBD plasma exposure resulted in a six-log reduction in CFU (colony-forming unit) count after 30 min of treatment. When the Deinococcus radiodurans cells were suspended in distilled water and treated, it took only 15 s to achieve a four-log reduction of CFU count.

Cardiovascular Risks of Anemia Correction with Erythrocyte Stimulating Agents: Should Blood Viscosity Be Monitored for Risk Assessment?

Abstract: To date, all major clinical trials for anemia correction using erythrocyte stimulating agents (ESAs) failed to show improved outcomes for cardiovascular disease (CVD), stroke, and vascular thrombosis. Even moderate elevations in hemoglobin (e.g., to 13 g/dL) using erythropoietin have been associated with significantly increased risk of thrombotic cardiovascular events and heart failure. This review presents a biophysical rationale for increased risk of CVD among certain patients treated with ESAs and suggests a risk management approach based on blood viscosity. Whole blood viscosity is a key determinant of the work of the heart, and elevated blood viscosity appears to be both a strong predictor of cardiovascular disease and an important pathophysiological factor in the development of atherothrombosis. Blood donation has been shown to reduce viscosity. Reflecting these findings, studies in male blood donors and in women of premenopausal age with regular menstruation have shown reduced incidence of cardiovascular events such as myocardial infarction, angina, stroke, and the requirement for procedures such as percutaneous transluminal coronary angioplasty and coronary artery bypass graft compared with non-donors and postmenopausal women, respectively. We propose that blood viscosity monitoring should be considered as part of a cardiovascular risk assessment, whenever an increased cardiovascular risk is detected and particularly in the context of anemia correction.

Non-Newtonian viscosity measurements in the intermediate shear rate range with the falling-ball viscometer

Abstract: An attempt to use the falling-ball experiment to measure the non-Newtonian viscosity in the intermediate shear rate range was successfully accomplished by combining the direct experimental observations with a simple analytical model for the average shear and shear rate at the surface of a sphere. The viscosity data of aqueous solutions of Carbopol-960, carboxymethyl cellulose, polyethylene oxide and polyacrylamide obtained from the falling-ball viscometer gave good agreement with those from other viscometers, confirming the general applicability of the analytical approach. In the experiments with the highly viscoelastic polyacrylamide solutions the terminal velocity was observed to be dependent on the time interval between the dropping of successive balls. This time-dependent phenomenon was used to determine characteristic diffusion times of the concentrated solutions of polyacrylamide. These values were, in turn, compared with characteristics relaxation times determined by the Powell-Eyring model. The experimental program revealed that the falling-ball viscometer has very limited utility for the measurement of the steady shear viscosity of aqueous polymer solutions.

Convective Transport in Nanofluids

Abstract: Nanofluids are engineered colloids made of a base fluid and nanoparticles (1-100 nm) Nanofluids have higher thermal conductivity' and single-phase heat transfer coefficients than their base fluids In particular the heat transfer coefficient increases appear to go beyond the mere thermal-conductivity effect, and cannot be predicted by traditional pure-fluid correlations such as Dittus-Boelter's In the nanofluid literature this behavior is generally attributed to thermal dispersion and intensified turbulence, brought about by nanoparticle motion To test the validity of this assumption, we have considered seven slip mechanisms that can produce a relative velocity between the nanoparticles and the base fluid These are inertia, Brownian diffusion, thermophoresis, diffusioplwresis, Magnus effect, fluid drainage, and gravity We concluded that, of these seven, only Brownian diffusion and thermophoresis are important slip mechanisms in nanofluids Based on this finding, we developed a two-component four-equation nonhomogeneous equilibrium model for mass, momentum, and heat transport in nanofluids A nondimensional analysis of the equations suggests that energy transfer by nanoparticle dispersion is negligible, and thus cannot explain the abnormal heat transfer coefficient increases Furthermore, a comparison of the nanoparticle and turbulent eddy time and length scales clearly indicates that the nanoparticles move homogeneously with the fluid in the presence of turbulent eddies so an effect on turbulence intensity is also doubtful Thus, we propose an alternative explanation for the abnormal heat transfer coefficient increases: the nanofluid properties may vary significantly within the boundary layer because of the effect of the temperature gradient and thermophoresis For a heated fluid, these effects can result in a significant decrease of viscosity within the boundary layer, thus leading to heat transfer enhancement A correlation structure that captures these effects is proposed

Investigation on Convective Heat Transfer and Flow Features of Nanofluids

Abstract: Low thermal conductivity is a primary limitation in the development of energy-efficient heat transfer fluids that are required in many industrial applications. In this paper we propose that an innovative new class of heat transfer fluids can be engineered by suspending metallic nanoparticles in conventional heat transfer fluids. The resulting {open_quotes}nanofluids{close_quotes} are expected to exhibit high thermal conductivities compared to those of currently used heat transfer fluids, and they represent the best hope for enhancement of heat transfer. The results of a theoretical study of the thermal conductivity of nanofluids with copper nanophase materials are presented, the potential benefits of the fluids are estimated, and it is shown that one of the benefits of nanofluids will be dramatic reductions in heat exchanger pumping power.

Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles

Abstract: Turbulent friction and heat transfer behaviors of dispersed fluids (i.e., uttrafine metallic oxide particles suspended in water) in a circular pipe were investigated experimentally. Viscosity measurements were also conducted using a Brookfield rotating viscometer. Two different metallic oxide particles, γ-alumina (Al2O3) and titanium dioxide (TiO2), with mean diameters of 13 and 27 nm, respectively, were used as suspended particles. The Reynolds and Prandtl numbers varied in the ranges l04-I05 and 6.5-12.3, respectively. The viscosities of the dispersed fluids with γ-Al2O3 and TiO2 particles at a 10% volume concentration were approximately 200 and 3 times greater than that of water, respectively. These viscosity results were significantly larger than the predictions from the classical theory of suspension rheology. Darcy friction factors for the dispersed fluids of the volume concentration ranging from 1% to 3% coincided well with Kays' correlation for turbulent flow of a single-phase fluid. The Nusselt n...

Thermal Conductivity of Nanoparticle -Fluid Mixture

Abstract: Effective thermal conductivity of mixtures of e uids and nanometer-size particles is measured by a steady-state parallel-plate method. The tested e uids contain two types of nanoparticles, Al 2O3 and CuO, dispersed in water, vacuum pump e uid, engine oil, and ethylene glycol. Experimental results show that the thermal conductivities of nanoparticle ‐e uid mixtures are higher than those of the base e uids. Using theoretical models of effective thermal conductivity of a mixture, we have demonstrated that the predicted thermal conductivities of nanoparticle ‐e uid mixtures are much lower than our measured data, indicating the dee ciency in the existing models when used for nanoparticle ‐e uid mixtures. Possible mechanisms contributing to enhancement of the thermal conductivity of the mixtures are discussed. A more comprehensive theory is needed to fully explain the behavior of nanoparticle ‐e uid mixtures. Nomenclature cp = specie c heat k = thermal conductivity L = thickness Pe = Peclet number P q = input power to heater 1 r = radius of particle S = cross-sectional area T = temperature U = velocity of particles relative to that of base e uids ® = ratio of thermal conductivity of particle to that of base liquid ¯ = .® i 1/=.® i 2/ ° = shear rate of e ow Ω = density A = volume fraction of particles in e uids Subscripts