Yusong Li

Bio: Yusong Li is an academic researcher from University of Nebraska–Lincoln. The author has contributed to research in topics: Nanoparticle & Porous medium. The author has an hindex of 18, co-authored 51 publications receiving 1280 citations. Previous affiliations of Yusong Li include Tufts University & Emory University.

Investigation of the transport and deposition of fullerene (C60) nanoparticles in quartz sands under varying flow conditions

Abstract: A coupled experimental and mathematical modeling investigation was undertaken to explore nanoscale fullerene aggregate (nC60) transport and deposition in water-saturated porous media. Column experiments were conducted with four different size fractions of Ottawa sand at two pore-water velocities. A mathematical model that incorporates nonequilibrium attachment kinetics and a maximum retention capacity was used to simulate experimental nC60 effluent breakthrough curves and deposition profiles. Fitted maximum retention capacities (S(max)), which ranged from 0.44 to 13.99 microg/g, are found to be correlated to normalized mass flux. The developed correlation provides a means to estimate S(max) as a function of flow velocity, nanoparticle size, and mean grain size of the porous medium. Collision efficiency factors, estimated from fitted attachment rate coefficients, are relatively constant (approximately 0.14) over the range of conditions considered. These fitted values, however, are more than 1 order of magnitude larger than the theoretical collision efficiency factor computed from Derjaguin-Landau-Verwey-Overbeek (DLVO) theory (0.009). Data analyses suggest that neither physical straining nor attraction to the secondary minimum is responsible for this discrepancy. Patch-wise surface charge heterogeneity on the sand grains is shown to be the likely contributor to the observed deviations from classical DLVO theory. These findings indicate that modifications to clean-bed filtration theory and consideration of surface heterogeneity are necessary to accurately predict nC60 transport behavior in saturated porous media.

Transport and Retention of Nanoscale C60 Aggregates in Water-Saturated Porous Media

Abstract: Experimental and mathematical modeling studies were performed to investigate the transport and retention of nanoscale fullerene aggregates (nC60) in water-saturated porous media. Aqueous suspensions of nC60 aggregates (95 nm diameter, 1 to 3 mg/L) were introduced into columns packed with either glass beads or Ottawa sand at a Darcy velocity of 2.8 m/d. In the presence of 1.0 mM CaCl2, nC60 effluent breakthrough curves (BTCs) gradually increased to a maximum value and then declined sharply upon reintroduction of nC60-free solution. Retention of nC60 in glass bead columns ranged from 8 to 49% of the introduced mass, while up to 77% of the mass was retained in Ottawa sand columns. When nC60 suspensions were prepared in deionized water alone, effluent nC60 BTCs coincided with those of a nonreactive tracer (Br−), with minimal nC60 retention. Observed differences in nC60 transport and retention behavior in glass beads and Ottawa sand were consistent with independent batch retention data and theoretical calculat...

Influence of electrolyte species and concentration on the aggregation and transport of fullerene nanoparticles in quartz sands

Abstract: The potential toxicity of nanoscale particles has received considerable attention, but the fate of engineered nanomaterials in the environment has been studied only under a limited set of conditions. In the present study, batch and column experiments were performed to assess the aggregation and transport of nanoscale fullerene (nC60) particles in water-saturated quartz sands as a function of electrolyte concentration and species. As the electrolyte concentration increased from 1 to 100 mM, the change in nC60 particle diameter was minimal in the presence of NaCl but increased by more than sevenfold in the presence of CaCl2. The latter effect was attributed to the agglomeration of individual nC60 particles, consistent with a net attractive force between particles and suppression of the electrical double layer. At low ionic strength (3.05 mM), nC60 particles were readily transported through 40- to 50-mesh quartz sand, appearing in the column effluent after introducing less than 1.5 pore volumes of nC60 suspension, with approximately 30% and less than 10% of the injected mass retained in the presence of CaCl2 or NaCl, respectively. At higher ionic strength (30.05 mM) and in finer Ottawa sand (100-140 mesh), greater than 95% of the introduced nC60 particles were retained in the column regardless of the electrolyte species. Approximately 50% of the deposited nC60 particles were recovered from 100- to 140-mesh Ottawa sand after sequential introduction of deionized water adjusted the pH to 10 and 12. These findings demonstrate that nC60 transport and retention in water-saturated sand is strongly dependent on electrolyte conditions and that release of deposited nC60 requires substantial changes in surface charge, consistent with retention in a primary energy minimum.

Transport and retention of fullerene nanoparticles in natural soils

Abstract: Commercial production and use of fullerene (C60) nanomaterials will inevitably lead to their release into the environment, where knowledge of C60 fate and transport is limited. In this study, a series of one-dimensional column experiments was conducted to assess the transport and retention of nanoscale fullerene aggregates (nC60) in water-saturated soils. Under the experimental conditions, complete retention of nC60 was observed in columns (2.5 cm inside diameter x 11 cm length) packed with Appling or Webster soil, which contain 0.75 and 3.33% organic carbon by weight, respectively. When the volume of aqueous nC60 suspension (approximately 4.5 mg L(-1)) applied to Appling soil was increased from 5 to 65 pore volumes, the travel distance increased from 3 to 8 cm, and the retention capacity approached a limiting value of 130 microg g(-1), although nC60 was not detected in the column effluent. The addition of 20 mg C L(-1) Suwannee River humic acid to the influent suspension increased the nC60 transport in Appling soil but did not resul in breakthrough. Attempts to simulate the experimental data using clean-bed filtration theory were not satisfactory, yielding retention profiles that failed to match observed data. Subsequent incorporation of a limiting retention capacity expression into the mathematical model resulted in accurate predictions of the measured nC60 retention profiles and transport behavior. The sizable retention capacities observed in this study suggest that transport of nC60 is limited in relatively fine-textured soils containing appreciable amounts of clay minerals and organic matter, with substantial accumulation of nC60 aggregates near the point of release.

Transport and Retention of Colloids in Porous Media: Does Shape Really Matter?

Abstract: The effect of particle shape on its transport and retention in porous media was evaluated by stretching carboxylate-modified fluorescent polystyrene spheres into rod shapes with aspect ratios of 2:...

Review on nanoparticles and nanostructured materials: history, sources, toxicity and regulations.

Abstract: Nanomaterials (NMs) have gained prominence in technological advancements due to their tunable physical, chemical and biological properties with enhanced performance over their bulk counterparts. NMs are categorized depending on their size, composition, shape, and origin. The ability to predict the unique properties of NMs increases the value of each classification. Due to increased growth of production of NMs and their industrial applications, issues relating to toxicity are inevitable. The aim of this review is to compare synthetic (engineered) and naturally occurring nanoparticles (NPs) and nanostructured materials (NSMs) to identify their nanoscale properties and to define the specific knowledge gaps related to the risk assessment of NPs and NSMs in the environment. The review presents an overview of the history and classifications of NMs and gives an overview of the various sources of NPs and NSMs, from natural to synthetic, and their toxic effects towards mammalian cells and tissue. Additionally, the types of toxic reactions associated with NPs and NSMs and the regulations implemented by different countries to reduce the associated risks are also discussed.

Aggregation and deposition of engineered nanomaterials in aquatic environments: role of physicochemical interactions.

Abstract: The ever-increasing use of engineered nanomaterials will lead to heightened levels of these materials in the environment. The present review aims to provide a comprehensive overview of current knowledge regarding nanoparticle transport and aggregation in aquatic environments. Nanoparticle aggregation and deposition behavior will dictate particle transport potential and thus the environmental fate and potential ecotoxicological impacts of these materials. In this review, colloidal forces governing nanoparticle deposition and aggregation are outlined. Essential equations used to assess particle−particle and particle−surface interactions, along with Hamaker constants for specific nanoparticles and the attributes exclusive to nanoscale particle interactions, are described. Theoretical and experimental approaches for evaluating nanoparticle aggregation and deposition are presented, and the major findings of laboratory studies examining these processes are also summarized. Finally, we describe some of the chall...

Transformations of nanomaterials in the environment.

Abstract: Increasing use of engineered nanomaterials with novel properties relative to their bulk counterparts has generated a need to define their behaviors and impacts in the environment. The high surface ...